WT-GAF-12v12w Gigabit splitter for 12 volt cameras etc - WiFI

WT-GAF-12v12w Gigabit splitter for 12 volt cameras etc - WiFI
PoE-Texas LLC
3616 Far West Blvd
Austin Tx 78731
splitter for 12 volt
cameras etc
Version 5
Product Description - WT-AF-12v12w
This device provides a low cost solution for delivering power to a 12 volt camera or routers over 328ft of network cable.
This device allows power to be carried on 10/100/1000 networks with either 802.3af or passive injectors and switches
with a CAT5e, CAT6 or CAT7 Ethernet network cable.
Intended for use with Cisco or similar PoE switches – this active PoE solution negotiates with the switch to activate
power and provide it to the client device. It is a compact and cost effective power solution. The switch supplies 48 or 56
volts DC at the source location. The higher DC voltage means the current is reduced by a factor of 4, and then carried
with less loss over the 10BASE-T or 100BASE-T network cable. The splitter extracts the DC voltage from the network
cable and reduces the voltage to 12v, and increases the available current by the same factor to power the camera on
the 2.1 mm x 5.5 mm splitter DC plug. Unlike simple injector / splitter sets, this combination of a 48v source and 12v
converter allows you to extend the distance with this product for this application up to 328ft or 100 meters.
We also offer kits with up to 16 injectors and splitters – so one power supply can feed 4, 8, 12 or 16 cameras. These
kits include the Multi Port Passive POE injector and a power supply of either 30 watts, 60 watts or 120 watts.
Step a) connect 2.1mm DC cord to your camera,
Step b) connect RJ45 male to your camera
Step c) use a factory Ethernet cable to connect the RJ45 female to your PoE switch up to 100 mtr distance
Typical Cameras
• Foscam W outdoor series Tenvis, Wansview, Maygion, EasyN, Apexis, EasySF,
• Routers, 12 volt tablet computers
• non-PoE Access points, door locks and other devices
• other adapters available for 2.5 mm x 5.5mm devices, 0.7mm, etc
Power and data source
DC output
Data only connector
Data Pins out – male RJ45
Data + Power input Pins ( 802.3af mode B)
Data + Power input Pins ( 802.3af mode A)
Input Voltage
Input Current at 48v
Output Voltage Max load (12v12w)
Output Voltage no load
Operating Temperature
RJ 45 female connector
2.1mm x 5.5mm
10/100/1000 BASE-T RJ-45 male
All pins active for gigabit speeds
4&5 (plus) and 7&8 (minus)
1&2 and 3&6 – either polarity
44 to 57 volts
300 ma input delivers 1 amp out
12v +- 2% at 1 amps 12 watts
0°C ~ 50°C
22 x 22 x 100 mm
Power non-PoE Cameras
PoE Tester
WiFi-Texas injectors
Any PoE Switch
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF