NuStreams- P8 RESIDENTIAL GATEWAY TESTER

NuStreams- P8 RESIDENTIAL GATEWAY TESTER
NuStreams - P8
RESIDENTIAL GATEWAY TESTER
FEATURES
SUMMARY
Standalone tester for testing Residential Gateway
(IP-Sharing) device with up to 7 LAN ports and 1 WAN
port.
Three built-in test modes with pre-defined templates for
customization:
AT (Auto Test): Testing the DUT’s ability to switch traffic between
any one of the LAN port and the WAN port
ST (Switch Test): Testing the max. throughput of the LAN ports of
the DUT
MAJOR
BENEFITS
Optimized and reliable testing – perform deterministic and
repeatable tests to validate the functionality and
performance of a DUT at various speed and load
conditions.
DHCP server supplies Internet Protocol (IP) addresses
when requested by client or DUT on a TCP/IP network
that have TCP/IP configured to obtain their IP addresses
automatically.
Cost effective and user friendly
PT (Performance Test): Testing the max. throughput between any
Perfect replacement for expensive and complicated PC + multiple
one of the LAN port and the WAN port of the DUT
network interface cards + third party software solution
User configurable test parameters:*
No special know-how needed for setup, configuration, and
Number of LAN ports tested: 2, 4, 5, 6, or 7 ports
operation
Packet transmission duration: 1, 2, 3,…, 8 seconds
Easy to maintain
Packet loss tolerance: 0, 5, 10, 15, 20, 25, 30…, 100 packets
Excess packets tolerance: 0, 10, 20, 30, 40, 50…, 100 packets
Packet Length: 64 / 256 / 512 / 1,024/ 1,518 bytes
Packet types: UDP or TCP
DHCP test: On / Off
High test throughput - automatic determination of the
pass / fail status of a DUT in between 12 ~ 38 seconds**;
hence, making NuStreams-P8 a more productive option
than traditional PC-based solution
Compact, lightweight and highly portable
Built-in, non-volatile memory for storing test settings and
statistics
*Subject to test mode selected
**Subject to test configuration
KEY APPLICATIONS
Production and QA/QC tests
Performance validation
Trouble shooting at service / maintenance outlets
NuStreams - P8
OVERVIEW
S P E C I F I C A T I O N S
Model
NuStreams - P8
Test Ports
LAN: 7 Fast Ethernet Ports with RJ-45 Connectors;
WAN: 1 Fast Ethernet Port with RJ-45 Connector
Display
Built-in 4 x 16 characters LCD panel for configuration date and test results display;
Built-in 6 LEDs for status indication (Power, Progress, Tx, Rx, Error, GO/NG)
Input Device
Built-in, 8-key keypad (Power Saving, Reset, Set, +, -, PT, ST, AT)
Power
Input: AC 100V ~ 240V, 50Hz ~ 60Hz; Output: DC 9V, 0.8A; Max. Power Consumption: 4.5W
Dimension & Weight
112mm x 157mm x 56mm, 500g
Temperature
Operating: 0oC ~ 40oC, Storage: 0oC ~ 50oC
Humidity
Operating: 0% ~ 85% (non-condensing), Storage: 0% ~ 85% (non-condensing)
NuStreams-P8 is a standalone tester for testing
In Switch Test mode, the maximum throughput of the LAN
Residential Gateway (IP-Sharing Devices) with up to 7 LAN
ports of a DUT is determined by gradually increasing the
ports and 1 WAN port at wire speed. The compact and
utilization rate of the traffic sent from NuStreams-P8 to the
lightweight design and built-in tests make it an ideal
DUT until there is packet loss.
solution for production test on production line and for
performance analysis and trouble shooting at service
centers or maintenance outlets as well.
The maximum throughput between any one of the LAN port
and the WAN port of the DUT can be determined in the
Performance Test mode of NuStreams-P8 by gradually
With 3 built-in test modes – Auto Test, Switch Test, and
increasing the utilization rate of the traffic sent to the tested
Performance Test, NuStreams-P8 provides pre-defined
ports until there is packet loss. In addition, user may select
templates for the customization of test parameters for each
between UDP or TCP packet type for the test and use the
test mode including number of ports tested, packet
DHCP test option to test the DUT’s ability in handling DHCP
transmission duration, enable/disable of DHCP test,
requests.
sending UDP/TCP packets, utilization, packet length, etc.
No software effort or special technical know-how is needed
for test setup.
Built by Xtramus Technologies – an expert in network ASIC
design and testing system development and validated with
professional network testing systems, NuStreams-P8
In Auto Test mode, a DUT’s ability to switch traffic is
offers highly reliable test results and the best C/P ratio
determined by NuStreams-P8 by comparing the no. of
among the solutions available for testing residential gateway.
packets transmitted and received between any one of the
LAN port and the WAN port tested. Two thresholds, one for
packet loss and one for excess packet received, are
provided for determining the pass / fail status.
Xtramus and its logo are the trademarks of Xtramus Technologies. All other trademarks are the property of their respective owners.
The specification may be changed without prior notice. Please contact Xtramus for the latest specification update.
Omnicor
1170 Foster City Blvd., Suite 312
Foster City, CA 94404 U.S. A.
Te l : +1(650) 572 0122
Fax: +1(650) 572 0533
E-Mail: info@omnicor.com
www.omnicor.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising