4Post Garment Rack Assembly Instructions
4Post Garment Rack Assembly Instructions
TUBE
STEP 1
Thread a 1/4-20 hex bolt into each side of the garment tube. Do not fully tighten
the bolts. Instead, leave a 1/8" gap between the bolt head & the threaded insert.
1/4-20 x 3/4"
HEX BOLT
1/8"
GAP
1/8"
GAP
GARMENT SUPPORT
BRACKETS MUST BE
INSTALLED AT THE
SAME HEIGHT
A
DETAIL A
STEP 2
There needs to be a support bracket attached to each corner of the 4Post unit to mount the garment rack. To install the garment
rack correctly, support brackets must be level with each other. To attach brackets, simply seat the rivets of the support brackets
into the bottom of the upright keyholes. NOTE: Support brackets may need to be installed upside down if a shelf falls right above
the garment rod.
L-BRACKET
#8 x 3/8"
TEK SCREW
Place an L-Bracket over the support brackets.
Attach the L-Bracket with #8 x 3/8" tek screws.
Repeat for the opposite side.
SHEET 1 OF 2
INST0086 REV1 NFW 6/8/2011
STEP 3
STEP 4
Place the hex head of one of the bolts into an
L-Bracket 1/2" hole. Snap the opposite hex
head into the opposite L-Bracket's 1/2" hole.
TUBE
1/2" HOLE
STEP 5
Slide the tube to the desired slot for your application. If you'd prefer
the tube not have adjustability, tighten the (2) 1/4-20 hex head bolts
with an open ended wrench.
NOTE
TUBE
Multiple tubes may be used on the same
L-Bracket, depending on their purpose or size.
Install the extra tubes following steps 4 & 5.
TUBE
END OF INSTRUCTIONS.
FOR ASSEMBLY ASSISTANCE CONTACT CUSTOMER SERVICE AT
1-866-217-0330 (MONDAY THROUGH FRIDAY, 8AM TO 5PM EST).
SHEET 2 OF 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising