cerno Libri-Mounting-Kit-J-Box

cerno Libri-Mounting-Kit-J-Box
Libri - Mounting Kit, J-Box Hardwire
Installation Instructions
General Product information
This product is suitable for dry locations only.
The product turns on automatically when the fixture is
pulled away from the wall.
These are supplemental instructions to be used in
conjection with the Libri - Hardwired or Libri - Plugin
instructions.
WARNING
This product requires the use of the supplied
CONSTANT CURRENT led driver. DO NOT
CONNECT DIRECTLY TO LINE VOLTAGE OR USE
ANY OTHER POWER SOURCE!!!
Positioning the Fixture
For mounting the libri as a bedside reading fixture, there is an optimal zone within which to mount the fixture. The exact position
within this zone will depend on personal preference. If you enjoy sitting upright to read, you will want to mount it high and away
from the edge of the bed. If you don’t have long arms and want to control the light while laying down, you will want to mount the
fixture lower and closer towards the bed.
12” Wide Zone
20” Above Bed Height
Edge Of Bed
Mounting Zone
14” Tall Zone
Height Of Bed
Side
CERNOGROUP.COM
T_949.715.1534
Front
1751 MCGAW AVE, IRVINE, CA 92614
COPYRIGHT 2016 CERNO LLC.
ISSUE DATE 11/7/2016
1/2” Ø minimum (to allow
end of plug to pass through)
Libri - Mounting Kit, J-Box Hardwire
Installation Instructions
HARDWIRED
Canopy
4
Mounting Plate
LED Driver
2
3
1
Junction Box
Line Voltage
(Yellow wire nuts)
Low Voltage
(Grey wire nuts)
1
Feed fixture wires through the canopy and mount in plate as shown.
2
Make wire connections as shown and place LED driver and excess wire in jucntion box.
3
Attach mounting plate to junctions box using the provided screws, until level, then tighten screws.
4
Attach Libri fixture and canopy to mounting plate using the provided screws.
PLUG IN
Installing the Fixture
1
2
3
4
Attach the mounting plate to the
wall securely (drywall anchors included). Be sure the plate is level.
Pull excess cord out of the bottom
of the canopy as you place the Libri light fixture body against the
canopy.
Mounting
Canopy
Plate
1
2
3
Use screws to secure the light fixture into place, taking care to not
pinch the cord.
2
Plug the cord into the Supplied
contant current LED driver.
WARNING
DO NOT CONNECT DIRECTLY TO
LINE VOLTAGE OR ANY OTHER
POWER SOURCE!
CERNOGROUP.COM
T_949.715.1534
1751 MCGAW AVE, IRVINE, CA 92614
COPYRIGHT 2016 CERNO LLC.
ISSUE DATE 11/7/2016
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising