Shintaro Wireless Optical Mouse

Shintaro Wireless Optical Mouse
Shintaro Wireless Optical Mouse
User Manual
SHWM03
shintaro.com.au
Shintaro Wireless Optical Mouse
Contents
Introduction
4
Specifications
4
Setup Instructions
5
Key Description
6
FCC Information
9
shintaro.com.au
Introduction
The Shintaro 14SHWM03 Wireless Mouse is an ergonomically designed, stylish
optical mouse suitable for use on almost any surface. Given there are no moving
parts, the optical sensor gives the user greater precision and reliability without the
need for constant cleaning. The built in battery saving function allows long
use between battery changes.
Specifications
Dimensions: (L / W / H)
Mouse: 115 x 65 x 40
Requires 2x AA batteries
4
Setup Instructions
1.
2.
3.
Pull the battery cover backward
Insert the batteries as shown inside the battery compartment
Replace the cover
5
Setup the Connection between the Receiver and the Mouse.
1.
2.
Insert batteries into mouse, then follow the steps below.
Plug the Nano receiver into the USB port of your computer.
3.
4.
If the mouse is not working, please put it into pairing mode.
Pairing: Re-plug the receiver into the USB port of your computer, then
press the connect button on the mouse. If the mouse does not work after
10 seconds, pair them again. (The receiver has auto pairing function).
The LED indicator on mouse flashes when it is in pairing mode and
stops blinking when it is successfully paired with the receiver.
When the battery power is low, the Low Power indicator will start to blink.
5.
6.
6
Key Description
7
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
8
9
www.shintaro.com.au
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising