Two Way PVC Valve Installation Instructions

Two Way PVC Valve Installation Instructions
Jandy Pro Series Never Lube®
1½”- 2” Two Way PVC Valve
Installation Instructions
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed
and qualified in pool equipment by the jurisdiction in which the product will be installed where such
state or local requirements exist. The maintainer must be a professional with sufficient experience
in pool equipment installation and maintenance so that all of the instructions in this manual can be
followed exactly. Before installing this product, read and follow all warning notices and instructions
that accompany this product. Failure to follow warning notices and instructions may result in
property damage, personal injury, or death. Improper installation and/or operation will void the
warranty.
PLUMBING
One valve is designed for both 1½” and 2” pipe. 1½” pipe slip fits into valve ports. 2” pipe is joined using
2½” pipe coupler. 45° or 90° fitting. See drawing on this page.
Internal valve assembly must be removed prior to gluing valve
body to pipe fittings. Make certain no glue enters valve body
beyond the ports.
WELD-ON® PVC GRAY IS RECOMMENDED.
Shut Off Stop
VALVE HANDLE USE
Lock Knob - Loosen lock knob to turn
handle. To secure handle, turn knob down
finger tight. See drawing on this page.
H0500100 Rev C
Off Indicator - OFF area on indicator
represents exact position of internal valve
diverter seal.
Handle Stops - Protruding pins
located on valve cover will stop
diverter in complete port shutoff position. Be sure the word
“INLET” on valve cover is over
the incoming flow port.
Coupler
2” Pipe
Lock Knob
1 1/2” Pipe
Slip Fit
Page 2
Jandy® Pro Series Never Lube® 1½” - 2” 2 Way PVC Valve
| Installation Instructions
Valve Complete, Positive Seal, 2724
Item
No
Part No
Description
Qty
1
1298
#14 x 3/4” Valve Housing Screw
2
R0487000
Knob (ABS) Gray
1
3
R0642300
Valve Handle Never Lube® Gray
1
4
R0642100
Valve Cover (2-Port) Gray
1
5
1132+
151 O-Ring
1
6
R0487100
116 O-Ring
2
7
4720
Diverter Assembly Complete
(Positive) Never Lube®
1
NOTE
2
1
8
3
The valve housing is not available as a separate part.
To replace the valve housing, you must replace the
entire valve.
6
4
6
6
6
5
7
2
Item #7. Diverter Assembly Complete with Knob
NOTE
Item 7 (Part 4720) includes a Pipe Plug P-18, but you
can discard it, because it is not needed with this valve.
Zodiac Pool Systems, Inc.
2620 Commerce Way, Vista, CA 92081
1.800.822.7933 | www.Jandy.com
©2016 Zodiac Pool Systems, Inc. ZODIAC ® is a registered trademark of Zodiac International, S.A.S.U., used under license. All trademarks referenced herein are the property of
their respective owners.
H0500100 Rev C
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising