Kingston Technology | KVR1333D3D4R9S/8GHA | Datasheet | Kingston Technology ValueRAM KVR1333D3D4R9S/8GHA memory module

Memory Module Specification
8GB 1024M x 72-Bit PC3-10600
CL9 Registered w/Parity 240-Pin DIMM
This document describes ValueRAM's 1024M x 72-bit 8GB (8192MB) DDR3-1333MHz CL9 SDRAM (Synchronous
DRAM) registered w/parity, dual-rank memory module, based on thirty-six 512M x 4-bit DDR3-1333MHz FBGA
components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 240-pin DIMM
uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:
DRAM Supported:
Hynix A-Die
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9,10
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component
Row Cycle Time (tRCmin)
Refresh to Active/Refresh Command Time (tRFCmin)
Row Active Time (tRASmin)
UL Rating
Operating Temperature
9 cycles
49.5ns (min.)
160ns (min.)
36ns (min.)
4.365 W (operating)
94 V - 0
0o C to 85o C
Storage Temperature
-55o C to +100o C
Document No. VALUERAM0901-001.A00
Page 1
Document No. VALUERAM0901-001.A00
Page 2
Download PDF