Report on LED Light

Operation Instruction
REMOTE OPERATION – Your Night Angel
RED BUTTON ON/OFF
is already synchronized to your remote
USB Charge
control and ready to use. However, we
Plug
recommend that you fully charge your
Night Angel before use.
To operate the Night Angel, press any
button on the remote control to turn ON
and OFF. MANUAL OPERATION: Use the
WHITE LED
RED button on Night Angel to turn the
RED LED
WHITE light ON and OFF. This allows the Night Angel to be used
EXTEND ARIEL FOR GREATER RANGE
as a portable light.
CHARGE: Plug the charger into a wall socket and the cable
(micro USB-B5) into the Night Angel.
OR connect the Night Angel to a USB powered source.
The RED LED will turn ON to signal charge mode, and turn OFF
once charge is complete.
The Night Angel light is fully operational during charge.
LOW_BATT: If the battery becomes low, the WHITE light will
turn OFF and the RED light will flash. It will give a quick blip once
every 2 seconds.
POWER_LOSS: The Night Angel has a power-loss (blackout)
RED LED
safety feature. When connected to the charger the Night Angel
WHITE light will turn ON for 1 hour if Mains Power is disabled.
TIMER: Night Angel has a timer which will automatically turn
the WHITE light OFF after one hour. To set the Night Angel to
“All Night Mode”, double push the RED button, the WHITE light
will flash twice to signal the timer has been set to “All Night
Mode”. Night Angel will now stay on all night or until switched
off via the remote control or the RED button.
Night Angel automatically reverts to the 1 hour timer mode.
REMOTE: To sync an additional Night Angel to the current
remote control, push and hold the side (on/off) button for 2
seconds, the RED light will start flashing slowly for 15 seconds.
While flashing slowly push any button on the remote to sync
the additional Night Angel.
INDIVIDUALIZE YOUR NIGHT ANGEL’S (multiple Night Angel 24): Push and hold the Red (on/off) button for 2 seconds, the
RED LED will flash slowly for 15 seconds. After 15 seconds, the
RED light will flash quickly for 5 seconds, during fast flash push
the selected button on the remote to set the Night Angel to the
individual button.
Your Night Angel will now operate from this individual button.
If a button on the remote is not pushed during the 5 seconds of
fast flash, Night Angel will default to ANY button on the remote.
Edgetec Systems Pty Ltd
13Lieber Grove, Carrum Downs, Vic, 3201
P: 03 9775 0882
E: [email protected]
W: www.edgetec.net
Page 1
RED LED SLOW FLASH TO SYNCH
RED LED QUICK FLASH INDIVIDUALISE
Night Angel-May 14

Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project