OPERATION MANUAL CAUTION When the machine is running

OPERATION MANUAL CAUTION When the machine is running
OPERATION MANUAL
CAUTION
When the machine is running, never
put your hands near or under the
rollers.
Do not remove the bottom lid, front
and rear covers from the machine.
The inside of the machine contains
high voltage parts or hazardous
moving parts, which may cause
electric shock or personal injury.
A socket-outlet shall be installed
near the equipment and shall be
easily accessible.
Keep this manual so that it can be retrieved whenever needed
WARNING
Warning:
Hazardous moving parts Keep hands and other body
parts away.
Warning:
The surface of the motor is hot.
Be careful, don’t touch.
CAUTION
Caution:
For continued protection against risk of fire,
replace only with the same type and rating of
fuse.
No.
Description
Qty
1
Warning Label 1
1
2
Cover Label
2
3
Model Label
1
4
Model Label
1
5
Fuse Label
1
6
Caution Label
1
7
Warning Label 2
1
8
Warning Label 3
1
OPERATION PROCEDURES
1. Before Operating
1.1 Fit stapling handle. .
First insert the end of the stapling
handle at the main holding shaft then
press in the sub-holding shaft
1.2 Load staples
1.3 Connect power cable
Main Operating Parts
1
Safety Cover
2
Back Cover
3
Stapling Handle
4
Side Guide (B)
5
Sub Holding Shaft
6
Main Holding Shaft
7
Stapling Head
8
Paper Guide
9
Table
10
Side Guide (A)
11
Front Cover
12
On/Off Switch
13
Rubber Feet
2. Make a Booklet
2.1 Switch on the machine
2.2 Choose the correct staple position
according to the sheet size
2.3 Set the paper guides; place the sheets
under the rollers and align the sheets
to side guide (A)
2.4 Set the paper guides to hold the
sheets in position
2.5 Press down the stapling handle to
complete the stapling
2.6 Lift up the stapling handle and firmly
press down to the other side and hold.
The stapled sheets will be fed up
through the fold rollers to complete
the booklet
2.7 Repeat steps 2.3 thru 2.6 for
additional booklets
2.8 Switch off the machine after finishing
3. Side Stapling
3.1 Choose and fix the staple position
according to the sheet size
3.2 Place the sheets under the rollers
3.3 Depending on the stapling position,
align the sheets to side guide (A) or
side guide (B)
3.4 Set the side distance and hold the
sheets
3.5 Press down the stapling handle for
stapling
3.6 Repeat steps 3.2 thru 3.5 for
additional booklets
3. Repair & Maintenance
4.1 Always clean up machine after use
SPECIFICATIONS
Paper Size
(min 197mm x 273mm /
max 297mm x 420mm
Max Stapling
Amount
10 sheets of 70 gsm
paper *
Max Folding
Amount
10 sheets of 70 gsm
paper (40 page
booklet)*
Power Source
AC 110V 0.8A 60 Hz
Watt
40W
Dimensions
500mm x 235 mm x
395mm
Weight (KG)
15
* this may vary depending upon paper quality
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement