CONNECT YOUR OTA ANTENNA TO YOUR RECEIVER
Attach the coax cable from your
OTA antenna to the coax port on your OTA adapter.
Connect the USB end of your OTA adapter to the USB port on your DISH receiver.
Turn your television and receiver on. Then, open the Menu for your receiver.
Select “System Setup” on your screen, and then select “Local Channels.”
Select “Scan Channels.”
• This scan could take up to five minutes to complete.
When it is complete, you will see a list of the OTA channels that your antenna found.
When the popup appears, select “OK” and then select “Done.”
CONNECT YOUR OTA ANTENNA TO YOUR TV
Turn your TV on, and take note of the channel or input that it is on.
Using the buttons on your TV, or your TV remote, press the Menu/
Settings,/Home button.
Connect your antenna to your TV’s
Antenna In/Air/Cable port.
• If your TV requires a conversion box, connect your antenna to the conversion box, and then connect the box to the TV.
Select Channel/Setup/Auto Tuning/
Installation/System.
• If you are prompted to select Air or Cable, select Air.
Select Scan Channels/Program
Channels/Autoscan/Autoprogram.
Select Start/Enter/OK to start scanning and adding channels to your TV’s channel lineup. Select OK/Done to complete your scan.
Got Questions?
Go to mydish.com/ota for details on setting up your OTA antenna
OR
Give us a call at 1-800-333-DISH (3474)
TM
Flip this sheet over for instructions on how to connect your Over-the-Air (OTA) Antenna to your TV or receiver.
