How to configure wired TCP/IP Properties of my computer(Windows XP

How to configure wired TCP/IP Properties of my computer(Windows XP
http://www.tp-link.com/en/FAQ-14.html#VISTA_7
• How to configure wired TCP/IP Properties of my computer(Windows XP,Vista,7,8,Mac)
How to configure wired TCP/IP Properties of my computer(Windows
XP,Vista,7,8,Mac)
For Windows Vista & Windows 7
Step 1
Click on windows key+ R key on the keyboard at the same time.
Step 2
Type ncpa.cpl in the box, then press OK.
Step 3
Select the local area connection, right click it and select Properties.
Step 4
Select Internet Protocol Version 4(TCP/IPv4), double click it or click Properties.
Step 5
There are two ways to configure the TCP/IP Properties, Assigned by DHCP server
automatically or manually.
1. Assigned by DHCP server
Select Obtain an IP address automatically and Obtain DNS server address automatically. If
necessary, then click OK to save the settings.
2. Assigned manually
1) Select Use the following IP address, type IP address, subnet mask and default gateway IP
address into it.
If the router’s LAN IP address is 192.168.1.1, please type in IP address 192.168.1.x (x is from 2
to 253), subnet mask 255.255.255.0, and default gateway 192.168.1.1.
2) Select Use the following DNS server addresses, as shown in the following figure. And then
type the DNS server IP address, which should be provided by your ISP. If necessary, then
click OK to save the settings.
Note: In most cases, type your local area DNS server IP addresses into it.
The Preferred DNS server is same to default gateway. For Secondary DNS server, you could leave
it blank or type in 8.8.8.8.
Step 6
Click OK to save and apply your settings.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement