APB06F QSG (English)
Product Highlights
18000 mAh Portable Battery Charger
Quick Start Guide
Power level indicators
On - Off button
LED flash light
Charge APB06F with the
included Micro USB cable
LED flashlight
Checking the Capacity
To turn the LED flashlight on or off, simply press the
button once to
power on the powerbank and press the
twice to turn On / Off the LED
Press the “Power” button once to check the capacity per below LED status.
Charging the battery pack
The battery is not fully charged and it is highly recommended that you
charge APB06F before you begin using it.
Note: Using APB06F “out of the box” will not harm the device. You will
experience reduced battery life as the unit will not be fully charged.
Charge up to two devices
at the same time*
qsg Q10345
Copyright © 2014 Aluratek, Inc. All Rights Reserved.
*Original charging cable required
Tech Support & Warranty Information
5V / 2.0A
5V / 1.0A
To charge the device, connect the larger end of the USB cable provided
to your PC or a USB power adapter (not provided) and the Micro USB
end to APB06F. The Red LED will be on while charging. In addition, one
of the 4 Blue LED will be flashing depends on capacity. Once it is fully
charged, the 4 Blue LED will stay on and the Red LED will turn off.
<25% capacity
25 - 50% capacity
50 - 75% capacity
>75% capacity
Charging your digital device
Use the original cable that came with your device or a cable with suitable
connector. Connect the USB tip to one of the USB Output ports on the
battery pack. Charging will start automatically once the cable is connected.
A Green LED will be on when your device is been charged.
If you need further assistance, please contact the Aluratek support
department for troubleshooting prior to returning this device.
E-mail: [email protected]
Web: www.aluratek.com/support
Local (Irvine, CA): 714-586-8730
Toll free: 1-866-580-1978
Aluratek warrants this product against defect in material or workmanship
for 1 Year from the date of purchase.
For more information, please visit: http://aluratek.com/warranty-return-policy
You can register your product online at: http://aluratek.com/product-registration
Radio and TV Interference Statement
WARNING!!! This equipment has been tested and found to comply with the
limits of a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by whatever measures may be
required to correct the interference.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF