OptReboot works seamlessly with an existing OptConnect cellular gateway, enabling you to remotely reboot your ATM, Kiosk, Point of Sale, or any other similar device from an internet connected computer, tablet, or smart phone. Your OptReboot comes pre-configured and simply needs to be connected using the included cabling. Open the ATM’s lower cabinet to access the ATM’s and OptConnect gateway’s power supply. The OptReboot is designed to be installed in this lower cabinet. Locate An Available Ethernet Port: Looking at the back of the OptConnect cellular gateway, determine if you have an open ethernet port. If the ethernet port is already occupied by a connection to an ATM, Kiosk, or other device, continue to step 3a. If the port is available, skip directly to step 3b. Connecting Network Connections 3a Connect Using A Network Switch: These steps are required only if your OptConnect gateway’s ethernet port is occupied. The OptReboot is compatible with any network switch (one may have been included in your shipment). a) Disconnect your ATM, Kiosk, or other device from the OptConnect gateway. Network Switch STATUS RESET OptConnect Gateway Network Switch ETHERNET CELL ON S I G N A L b) Connect your device’s ethernet cable to a port on a network switch. d) Connect an ethernet cable between the OptConnect gateway and the networt switch. Network Switch OptReboot c) Connect an ethernet cable between the OptReboot’s ethernet port and a port on the network switch. See overall Network Connection diagram on back. 3b Connect Using Direct Connection: a) Connect the included ethernet cable between the ethernet port on the OptConnect gateway and the OptReboot’s ethernet port. OptReboot OptConnect Gateway STATUS ETHERNET CELL ON RESET S I G N A L 4 OptReboot (AC Input) A/C Output Electrical Connections a) Connect the OptReboot’s power cord to it’s A/C Input connection and to a wall outlet. See figure 1. b) Connect the OptReboot’s short electrical pigtail cable to it’s A/C Output connection. See figure 2. c) Connect your ATM’s, Kiosk’s, or other device’s power cord to the OptReboot’s short electrical pigtail cable. See figure 2. d) Confirm the red “Outlet On” light is illuminated on the OptReboot device. If it’s not, please call technical support. Outlet On See overall electrical connection diagram below. OptReboot (AC Output) Short Electrical Pigtail Cable Note: Please do not use the recessed reset button on the OptReboot device. Resetting it will lose all programming associated with your unique installation and the device will not function properly. OptReboot (AC Input) Network Switch OptReboot A/C Output Outlet On OptReboot (AC Output) Network Switch Short Electrical Pigtail Cable POWER UNLOCK LOCK +5V STATUS RESET ETHERNET CELL ON S I G N A L AUX MAIN OptConnect Gateway OptConnect Gateway Warning: The OptReboot is designed to connect to a single device. By connecting a multipleoutlet power strip to the OptReboot, multiple devices can be controlled. However, please be aware connecting multiple devices may cause damage to all attached devices. The electrical load of all devices controlled by OptReboot must not exceed 12 amps. Please consult your device manufacturers’ documentation to ensure the combined start up load of all connected devices does not exceed this amperage. Need Help? Feel free to contact us with any questions at 1-877-678-3343.