UNSHIELDED TWISTED-PAIR VIDEO

UNSHIELDED TWISTED-PAIR VIDEO TRANSMITTER, ACTIVE- Page 1
TECHNICAL SPECIFICATIONS
SECURITY SYSTEM
DIVISION 16 - ELECTRICAL
SECTION 16770 - CLOSED CIRCUIT TELEVISION (CCTV) SYSTEM
PART 2 – PRODUCTS
2.01
GENERAL
A. All equipment and materials used shall be standard components that are regularly
manufactured and utilized in the manufacturer’s system.
B. All systems and components shall have been thoroughly tested and proven in actual use.
C. All systems and components shall be provided with the availability of a toll-free (U.S. and
Canada) technical support number from the manufacturer. The number shall provide technical
assistance for either the dealer/installer or the end user at no charge for as long as the product
is installed.
2.02
UNSHIELDED TWISTED-PAIR VIDEO TRANSMITTER, ACTIVE
A. The UTP/CCTV Video Transmitter device shall be capable of transmitting baseband
monochrome or color video signals over unshielded twisted-pair (UTP) telephone wire up to a
distance of 1 mile (1,6 km) when used with an active receiver. Distances up to 8,000 ft (2,4
km) can be achieved when using Category 5 cable.
B. The transmitting device shall have built-in transient protection, with earth-ground screw
connection.
C. The transmitting device shall be equipped with a screw terminal block for connection to UTP
telephone wire, low voltage power and ground.
D. The transmitting device shall be equipped with a female BNC for 75-ohm connections.
E. The transmitting device shall be powered by 24 Volts, AC or DC, 250 milliamps max.
F. The transmitting device shall have a Blue “Power-On” LED.
G. The transmitting device shall have a Green “Active” LED, when a video signal is present.
H. The transmitting device shall have a 3-position distance equalization slide switch.
I.
The transmitting device shall have the ability to operate in the same wire bundle as telephone,
data, low voltage or other video signals.
J.
The transmitting device shall meet or exceed the following design and performance
specifications:
a. Have built-in common-mode rejection not less than 60 dB between the frequencies
of 15 KHz to 5 MHz.
b. Shall have a frequency response from DC to 5 MHz.
c. Shall provide transient immunity of 6,000V 1.2uS x 50 uS and 3,000A 8uS x 20
uS when ground screw terminal is bonded to earth ground, per ANSI/IEEE
587C62.41 B3.
d. Shall be for indoor use or for use in an environmental enclosure and allow a
maximum operating temperature range of 0 to 50 degrees Celsius.
UNSHIELDED TWISTED-PAIR VIDEO TRANSMITTER, ACTIVE- Page 2
K. The transmitting device shall be capable of utilizing 24-16 AWG (solid or stranded) UTP
wire.
L. The transmitting device shall be capable of utilizing Category 2 or better UTP without
compromising transmission distances.
M. The transmitting device shall have a weight of 0.17 lbs (0.08 kg).
N. The transmitting device shall have two 0.175 in. (4,4 mm) diameter holes spaced 2.5 in.
(63,5 mm) apart for the purpose of surface or rack mounting.
O. The transmitting device shall be UL and CUL listed.
P. The transmitting device shall be CE compliant.
Q. The transmitting device shall be provided with a limited lifetime warranty.
R. The UTP Video Transmitter, Active, shall be the NVT:
a. NV-653T or
b. Approved equal
412-674-1-B
Download PDF