Dell OptiPlex SFF 104-2324 wall mount Installation Instructions

Dell OptiPlex SFF and

Monitor Wall Mount

Patent(s) Pending

Installation Instructions

Kit P/N: 104-2324

Kit Contents

Assembly Components:

(1) Main Bracket

(1) Cover

(1) Pivot Assembly

Wall Mount Hardware Package:

(4) Pan Head Screw

(4) Anchors

Monitor Hardware Package:

(8) Nylon Spacers

(5) M4 x 10mm Pan Head Screws

(5) M4 x 18mm Pan Head Screws

(5) M4 x 25mm Pan Head Screws

(5) 8-32 Flat Head Screws

PC Wall Mount Installation Instructions

Step 1. Determine Location: Select an appropriate location on the wall. Consider cable routing and length.

Step 2. Mark Hole Positions: Hold the base in position and mark 4 hole positions with a pencil.

Step 3a. Install Drywall Anchor: Install one drywall anchor at each hole mark. Using a

#2 Phillips head screwdriver press the anchor into the drywall while turning clockwise until it is seated flush with the wall.

Step 3b. Install 4 Screws: Leave 1/4" of each screw protruding out of the wall.

Page 2

1/4"

Installation Instructions

Step 4. VESA Monitor Bracket Attachment: Turn the monitor face down on a large flat surface. Locate the four VESA mounting holes on the rear of the monitor.

a. Determine if spacers are required: Some monitors have a "recess" on the rear

surface. Spacers are provided to fill this gap. See Table A for spacer

length options. b. Determine Screw Length: Only use the metric M4 screws provided. Screw

length is determined by the spacers used (see Table A).

M4 Screws (4x)

Outer four holes

= 100mm Pivot Assembly

Recess Depth

0

Bottom of Monitor

Table A

Spacer

No Spacer Needed

.250 (1/4)

.500 (1/2)

Screw

10mm

18mm

25mm

Screws and Spacers are Shown to Scale

Step 5. Monitor Bracket Attachment: Remove the main Bracket if it is attached to the wall before continuing with this step. Mount the Monitor Assembly through the Main

Bracket using the (4) 8-32 Flat Head screws.

(4) 8-32 Flat

Head Screws

Page 3

Installation Instructions

Step 6. Computer and Cover Attachment: Slide the computer into the Main Bracket.

Main Bracket

Cover

Captive Screw

Dell OptiPlex SFF

Step 7. Attach Mount Base: Attach the base to the wall using the 4 screws that were installed in 3b. Tighten Securely.

Warranty Statement

Innovation First, Inc. warrants our products against defects in material and workmanship for a period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to repairing or replacing, at our option, any defective product.

2324