Edimax | ES-5226RM | Datasheet | Edimax ES-5226RM 24 + 2 port L2 managed switch

ES-5226RM
24‐port Faast Ethernet Management Switch
with 2 Gigabit Combo Slots
Descriptions:
QoS with Four Priority Queues
The QoS (Quality Of Service) feature provides eight internal queues to support two different classifications of traffic. High priority packet streams experience less delay inside the swittch, which supports lower latency for certain delay‐sensitive traffic. it can classify the packet as one of the two priorities according to 802.1p priority tag, DSCP. The QoS operate at full wire speed. The actual scheduling at each egress port can be based upon a strict priority, weighted round robin or a mix of both.
Port Mirroringg
This mechanism helps track network errors or abnormal paccket transmission without interrupting the flow of data. Allow ingress or egress traffic to be monitored by a single port thaat is defined as mirror capture port. The mirror capture port can be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but can create congestion at the mirror capture port.
Q‐in‐Q VLAN for performance & security The VLAN feature in the switch offers the benefits of both security and performance. VLAN is used to isolate traffic between different users and thus provides better security. LLimiting the broadcast traffic to within the same VLAN between different users and thus provides better security. L
Limiting the broadcast traffic to within the same VLAN
broadcast domain also enhances performance. VLAN suppo
ort enabling advanced techniques such as “802.1q Q‐in‐1Q” to be deployed.
Isolated Group, Provide Secure for Certain Ports
nated as protected. All other ports are non‐isolated. Traffic The isolated group feature allows certain ports to be design
between isolated group members are blocked. Traffic can o
only be sent from isolated group to non‐isolated group.
802.1x Port based network Access Control Improve Netwo
802
1x Port based network Access Control Improve Netwo
ork Security
ork Security
802.1x feature enable user authentication for each networkk access attempt. Port security feature allow you to limit the non‐register user access to network. By enabling this featurres, you can establish an access mechanism based on user and machine identities, as well as control the number of access stations.
802.1D Compatible & 802.1w Rapid Spanning Tree
pporting STP, you can configure the switches with a redundant For mission critical environments with multiple switches sup
backup bridge path, so transmission and reception of packeets can be guaranteed in event of any fail‐over switch on the network.
t
k
Broadcast/Multicast/unknown‐Unicast Storm Control
ooding in the network, broadcast/multicast storm control is To limit too many broadcast/multicast/unknown‐unicast flo
used to restrict excess traffic. Threshold values are availablee to control the rate limit for each port. Packets are discarded if the count exceeds the configured upper threshold.
Standard compliance
IEEE 802.3 10Base‐T / IEEE 802.3u 100Base‐T / IEEE 802.3ab 1000Base‐TT / IEEE 802.3z 1000Base‐X Ethernet, IEEE 802.3x flow control / IEEE 802.3 auto‐negotiation / IEEE 802.1q VLAN
Subscriber Interface
1‐24 10/100Mbps Fast Ethernet ports. / 25,26 are Gigabit TP/ SFP Fiberr
Auto‐Negotiation and Auto‐MDIX
Backpressure flow control for half duplex / 802.3x flow control for full d
duplex.
Connector: 24 RJ‐45 and 25,26 dual media (RJ‐45/SFP)
Switching capacity:
Non‐blocking switch fabric supports up to 24FE+2GbE, ports
16K MAC addresses / 448K packet buffer
Bandwidth Control
Ingress rate limit :
g
Port 1~24: 1K up to 100Mbps / Port 25, 26: 1K up to p
p /
,
p 1000Mbps
p
Egress rate limit : Port 1~24: 1K up to 100Mbps / Port 25, 26: 1K up to 1
1000Mbps
Port Mirroring
Support 1: N RX port mirroring
Supports port sniffer function with TX‐RX pair Monitor Mode
Restricted Group
Can decide the direction of transmitting packets for the specific port
Protocol
Tag VLAN: 802.1q
Multicasting : Supports IGMP snooping V1, V2 / Fast Leave / filtering vvia filtering profile / Channel limitation per port/ MVR (Multicast VLAN Registration
STP/RSTP : 802.1d/802.1w
Network Security
802.1x port based network access control / Isolated group / ACL (Accesss Control List)/ Management Access Policy Control / Static
MAC/DHCP snooping /RFC 3046 DHCP relay agent with option 82 /Storrm Control
SNMPv1, v2c Network Management
Private MIB
MIB Files : Interface MIB, FC 1213 MIB (MIB‐II), RFC 1757 RMON MIB, P
Network Interface
Connector
Port
10/100 Mbps TP Jack (RJ-45)
TP(RJ‐45)
TP(RJ
45)
1 to 24
1 to 24
1000Mbps SFP Fiber Module
Dual Media Auto Detection
TP(RJ‐45) / SFP
25 to 26
Interface
Hardware Specifications
Feature
Description
Voltage 100∼240 V
Frequency 50∼60 Hz
Consumption 14W
Ambient 0° to 50°C
Temperature
Temperature Humidity 5% to 90%
Dimensions 240(W) × 200(H) × 44(D) mm
Principal: 1.44Kg.
Weight
Package: 2.48Kg.
Safety
Complies with FCC Parrt 15 Class A & CE Mark approval
Packing Information Carton Dimensions (mm)
pcs/Carton
N.W (KG)
G.W (KG)
420 (W) x 370 (D) x 300 (H)
5
11.5KG
12.5KG
Download PDF

advertising