advertisement
MILLI GLANCE
SINK MIXER
247
220
56
36
50
SPECIFICATIONS
Recommended Use
Finish Available
Pressure Rating
Temperature Rating
Suitable Hot Water
WELS
Standards
Domestic, Commercial and Hotel
Chrome
Maximum continuous operating pressure 500 kPa
Note: As per AS/NZS 3500 pressure must be limited to 500 kPa on any new home, extension or renovation.
Note: For best performance and longer life we recommend 150-500 kPa
Maximum continuous working temperature 75 o C
Minimum 1 o C
Storage Tank: Yes
Continuous Flow: Yes
Gravity Feed: Not Recommended
Star: 5
Flow Rate: 5.5 L/min
AS/NZS 3718
CLEANING RECOMMENDATIONS
This product should not be cleaned with abrasive materials eg. steel wool/ scourers. Do not use any corrosive or abrasive cleaning agents containing acids or scouring agents. Bleaches can also discolour products and therefore should not be used. Damage caused by any improper treatment is not covered by the product warranty- refer to Warranty Conditions on the last page.
To see the complete Milli range go to www.reece.com.au/bathrooms
Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only.
Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.
Tech Page Version 1
Brand logo area
- grey box to be deleted. Apply on
Master Page page 1 of 3
page 2 of 3
MILLI GLANCE
SINK MIXER
INSTALLATION INSTRUCTIONS
Milli Glance Sink Mixer Installation Instruction
Water Supply Requirements
To ensure optimum performance and customer satisfaction please adhere to the following:
- Maximum hot water temperature 75°C.
- Recommended minimum working pressure
150kPa.
- Recommended maximum working pressure
500kPa.
If the water pressure exceeds or is likely to exceed 500kPa, an approved pressure limiting valve must be fitted.
- Flush out all pipe work prior to installation.
- If the water temperature exceeds 75°C an approved tempering valve must be fitted.
- Installation should comply with Australian standard AS3500.1 or relevant local authority requirements.
Failure to comply with the above may void all warranties. For details on Phoenix’s warranty policy refer to www.phoenixtapware.com.au
Maintenance and Care
Do not use cleaning agents containing a corrosive acid or scouring agent. Do not use cream cleaners, as they are abrasive.
Surfaces should only be cleaned with a cloth and clear water of mild liquid detergent. Use of unsuitable cleaning agents may damage the surface.
Guarantee
This product is guaranteed against faulty workmanship and materials for 1 year from the date of purchase. Installation must be done by a licensed plumber or this guarantee will be void.
Installation Instruction
1 : Cut a mounting hole 35mm in diameter.
2 : Remove one of the hose assemblies from
the mixer. Run Dress Plate over both Hose
Assembly, as shown.
3 : Reattach the hose assembly to Mixer and
fasten with a spanner.
4 : Screw the threaded stud into mixer base.
5 : Fit the rubber ring into Dress Plate groove.
6 : Position Mixer over the mounting hole.
Feed the hoses through the mounting hole.
7 : From underneath the bench, fit “C” gasket
and “C” washer over both hoses and the
threaded stud .
8 : Screw on long nut and fasten firmly with a
tube spanner to secure the mixer.
9 : Connect the water supply.
Red-Marking Hose to hot water.
Blue-Marking Hose to cold water.
10:Turn on the water supply and check for
leaks.
HOT Water Inlet
Red-Marking Hose
Mixer
Dress Plate
Rubber Ring
Cold Water Inlet
Blue-Marking Hose
“ C ” Gasket
“ C ” Washer
Long Nut
Threaded Stud
IN0146 revA
Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference
Brand logo area
- grey box to be deleted. Apply on
Master Page
page 3 of 3
MILLI GLANCE
SINK MIXER
Q
U
ALIT
7
YEAR
Y GUARA
NT
EE
REECE PRODUCT QUALITY GUARANTEE
You have purchased a quality product from Reece Pty Ltd
ABN 84 004 097 090 (“Reece”). This product is covered by a
7 year replacement product warranty and a 12 month warranty over spare parts and labour.
7 YEAR WARRANTY – DOMESTIC USE
This warranty covers faults in the product construction, material and assembly. Products which are within 7 years from the date of purchase, found upon inspection by an authorised
Reece representative, to be defective in construction, material or assembly, will be repaired or exchanged with an equivalent product free of charge. Replaced items become Reece’s property. This warranty also covers any spare parts included under “Manufacturer’s Provisions” below.
All replacement products will be available for collection without charge to the customer at the nearest Reece branch to the customer’s location, or elsewhere as agreed between the customer and Reece.
Labour and Spare Parts
The labour for the replacement of products and spare parts to which this warranty applies will be supplied by Reece or relevant supplier using licensed plumbers engaged by Reece or relevant supplier within 1 year from the date of purchase.
Spare parts other than those listed in the Manufacturer’s
Provisions above, which are within 1 year from the date of purchase found upon inspection by an authorised Reece representative to be defective in construction, material or assembly, will be replaced free of charge.
Warranty Conditions
This warranty will apply only under all of the following conditions:
• The item has been installed by a licensed plumber
• The item has been installed for and subjected to domestic residential use only
• Failure is due to a fault in the manufacture of the product
• Proof of purchase (including the date of purchase) is provided
• The installation of the product is in accordance with the instructions provided
This warranty does not cover products purchased as an ex-display without being fully checked and tested for sale by the manufacturer.
This warranty does not include faults caused by:
• Unsuitable or improper use
• Incorrect installation or installation not in accordance with the instructions provided
• Installation or part installation by the purchaser or any person other than a LICENSED PLUMBER
• Normal wear and tear
• Inadequate or complete lack of maintenance
• Chemical, electrochemical or electrical influences
• Harsh detergents or abrasive cleaners used on product finishes
1 YEAR WARRANTY – COMMERCIAL USE
‘Commercial’ use is all use other than for normal domestic residential purposes, including use in non-business places as in public buildings, schools, sports centres and in establishments that contain private bathrooms with high frequency of use by many individuals, such as hotels, motels, retirement villages and hospitals.
The Commercial warranty covers this product against manufacturing faults in the construction, material and assembly of both the finished products and any spare parts for a period of 1 year from the date of purchase. Products and spare parts which are found upon inspection by an authorised
Reece representative to be defective in construction, material or assembly will be repaired or exchanged free of charge.
Replaced items become Reece’s property. The labour for the replacement of products and spare parts to which this warranty applies will be supplied by Reece or relevant supplier using licensed plumbers engaged by Reece or relevant supplier.
The Warranty Conditions and exclusions which apply to the domestic use warranty also apply to this commercial warranty.
EXCLUSIONS
To the fullest extent permitted by law, Reece excludes all liability for damage or injury to any person, damage to any property, and any indirect consequential or other loss or damage.
CLAIM PROCEDURE
For all warranty queries customers are to contact the branch where the product was purchased. These details can be found on your purchase invoice.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Brand logo area
- grey box to be deleted. Apply on
Master Page
Don’t risk it, use a licensed plumber.
™
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project