- Computers & electronics
- Computer components
- Chassis components
- Mounting kits
- Panamax
- BEZ5100-EXS
- Data Sheet
advertisement
Improve Picture Quality with Home Theater
Power Conditioners by Panamax
MAX
®
5100-EX
THE SOURCE OF
PURE
SOUND AND PICTURE
™
TOP BENEFITS
1 Improves Picture and Sound Quality
LEVEL 3 Power Cleaning and Filtration eliminates common symptoms of contaminated power (including loss of detail, pops, hisses, hums and visual artifacts) and allows your A/V equipment to perform up to its full capability.
2 Monitors Incoming Line Voltage and Provides a Visual
Indication of Power Level
Panamax’s patent pending AVM™ circuitry continuously monitors the incoming power as displayed on the LED voltmeter. The first LED will flash slowly to indicate an under voltage condition and the last LED will flash to indicate an over voltage condition.
Power to the connected equipment is automatically turned off if either of these conditions is detected. When voltage returns to a safe level, power to the equipment is automatically reconnected.
3 Reduces Cross-Contamination Between Components
The M5100-EX is designed to provide noise isolation between 3 isolated outlet banks including 2 high current outlets so that any noise created by an A/V component can not contaminate the power going to equipment plugged into another outlet bank.
FEATURES
LEVEL 3
Filtration
Power Cleaning and
Protect or Disconnect™ Automatic
Voltage Monitoring Circuitry (AVM)
LED Voltmeter and Power Status
Indicator Lights
11 Outlets: 4 Always On,
4 Switched, 2 High Current,
1 Convenience (front)
3 Isolated Outlet Banks
Coaxial Signal Line Protection:
1 HD Sat and 1 HD CATV
Auto-resetting Telephone (payper-view) and LAN Line Protection
DC Trigger Input
Rack Mountable (rack mount kit not included and sold separately-
Part # GRM2204)
Optional Silver Bezel
www.panamax.com
The Power Specialists Since 1975
L548 REV B 10/06
®
MAX
®
5100-EX REAR PANEL FEATURES
Circuit Breaker
Automatically opens when the current load is greater than 15
Amps.
Ground Lug
Provides a common grounding point for equipment with separate ground leads.
Outlet Bank 2
Four switched outlets controlled by the front panel Power
Button or the DC Trigger input. Bank 2 will turn on immediately and turn off after 10 seconds. EMI/RFI noise filtration is provided by a two-stage balanced Pi filter which also provides noise isolation from Outlet Banks 1 and 3.
Outlet Bank 1
Four always on outlets. Power will only be turned off under a fault condition. (See specifications for overvoltage and under-voltage thresholds) Power is cleaned by a two-stage balanced Pi filter which also provides noise isolation from Outlet Banks 2 and 3.
Satellite TV Coax Jacks
Bidirectional protection circuit optimized for satellite TV signal lines
.
Cable TV Coax Jacks
Bidirectional protection circuit optimized for cable TV, off-air antennas and cable modem signal lines.
Main Power
Must be plugged into a properly wired & grounded 3-wire outlet
Outlet Bank 3
Two switched, high current outlets controlled by the front panel Power Button or the DC
Trigger input. Bank 3 has a 5 second turn on delay and turns off immediately. The High
Current outlet provides power from a low impedance noise filtration circuit that does not limit the current to your equipment. Its output is noise isolated from all other outlet banks.
MAX
®
5100-EX SPECIFICATIONS
AC Power
Line Voltage:____________________________________________________120V, 60Hz
Total Current Capacity:__________________________________________________15 A
UL1449 Suppression Rating:____________________________________________330V
Protection Modes:______________________________________________L-N, L-G, N-G
Initial Clamping Level:_________________________________________________200V
Energy Dissipation:______________________________________________1815 Joules
Peak Impulse Current:___________________________________________73,000 Amps
Catastrophic Surge Circuit:_______________________________________________Yes
Thermal Fusing:_______________________________________________________Yes
Over-voltage shutoff:__________________________________________142 VAC ±5 VAC
Under-voltage shutoff:________________________________________90 VAC ± 2 VAC
EMI/RFI Noise Filtration
Banks 1 & 2:________________________________________ 80 db, 100 KHz – 2 MHz
Bank 3, High Current Outlets:____________________________60 db, 100 KHz – 2 MHz
Common Mode (all banks)______________________________60 db, 100 KHz - 2 MHz
DC Trigger Input
Jacks:_______________________________________________3.5mm (1/8”) mini-plug
Voltage and Polarity:___________________________________3 - 24V DC, bidirectional
Current Requirement:_________________________________4.6 mA @3V, 58 mA @24V
LAN Circuit
Clamping Level:____________________________________________________8V ± 2V
Jacks:_____________________________________________________________RJ-45
Wires Protected:_______________________________________4-Wires, Pins 1, 2, 3 & 6
Voltage Sense Trigger Input
3.5mm (1/8”) Mini-Plug jack. Connect to a remote trigger device that uses a DC output to trigger a startup/shutdown sequence. This bypasses the front panel power switch.
LAN Jacks
Protection circuits for 10/100 baseT Ethernet lines.
Phone Jacks
Protection circuits for standard telephone or pay-per-view lines.
Phone circuit is autoresetting.
Rack Mountable
(rack mount kit not included and sold separately - Rack Mount Kit / Double DIN, Part #
GRM2204)
Telephone Circuit (pay-per-view)
Fuseless/Auto-resetting:_________________________________________________Yes
Clamping Level:______________________________________________________260V
Capacitance:__________________________________________________30pf (approx.)
Suppression Modes:____________________________________Metallic & Longitudinal
Jacks:_____________________________________________________________RJ-11
Wires Protected:___________________________________________2-Wire, Pins 4 & 5
DSL Compatible:_______________________________________________________Yes
HD Satellite TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________27V
Attenuation:______________________________________< 1db from 950MHz-2.05GHz
< 2.4db @ 2.2GHz
Connections:__________________________________________Female “F”, Gold Plated
HD Cable TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________1.4V
Attenuation:________________________________________< 1db from 5MHz - 950MHz
Connections:__________________________________________Female “F”, Gold Plated
Pay-Per-View Compatible________________________________________________Yes
Specifications subject to change due to product upgrades and improvements.
UPC’s, QUANTITIES, WEIGHTS & MEASUREMENTS FOR ORDERING & SHIPPING
MODEL M5100-EX UNIT CARTON MASTER CARTON
Dimensions Weight Dimensions Weight UPC Qty Dimensions Weight
17" x 12.75" x 3.5"
4.1" H with feet
14 lbs
UPC
23.75" x 19.25" x 9.5" 17.5 Lbs 0 50616 00785 6 1 Same as 17.5 Lbs 5 00 50616 00785 1
Individual Carton
OPTIONAL SILVER BEZEL
SILVER BEZEL PRODUCT
Model # Dimensions
UNIT CARTON
Weight Dimensions Weight UPC
MASTER CARTON
Qty Dimensions Weight UPC
BEZ5100-EXS 17" W x 0.625" D x 3.5" H 14.5 Oz 18" x 4" x 1" 18.0 Oz 0 50616 00791 7 N/A N/A N/A N/A
The Power Specialists Since 1975
®
1690 Corporate Circle, Petaluma, CA 94954 • 800-472-5555 or 707-283-5900 • Fax - 707-283-5901 • www.panamax.com
© 2006 Panamax, Inc. Panamax, MAX and the Panamax logo are registered US trademarks of Panamax. Protect or Disconnect is a trademark of Panamax. SIDACtor is a registered US trademark of Teccor Electronics, Inc.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project