2. FAD (Fader Control) Knob 3. BASS Control

2. FAD (Fader Control) Knob 3. BASS Control
1 FEATURES OF YOUR HYUNDAI
76
H210B04O-AAT
1. POWER ON-OFF/VOLUME Control
Knob
The radio unit may be operated when the ignition key is in the "ACC" or "ON" position. Rotate
the knob clockwise to switch the radio unit on
and to increase the volume.
The LCD shows the radio frequency in the radio
mode. Turn the knob counterclockwise to reduce the volume and to switch the radio unit off.
BAL (Balance Control) Knob
Pull and turn the control knob clockwise to
emphasize right speaker sound (left speaker
sound will be attenuated). When the control
knob is turned counterclockwise, left speaker
sound will be emphasized (right speaker sound
will be attenuated).
After adjusting the balance, push the knob
again to use the other function.
SCAN Knob
When the scan knob is pressed, the frequency
will increase and the receivable stations will be
tuned in one after another, receiving each station for 5 seconds. To stop scanning, press the
scan knob again.
2. FAD (Fader Control) Knob
SEEK Operation
(Automatic Channel Selection)
Turn the control knob counterclockwise to emphasize front speaker sound (rear speaker
sound will be attenuated). When the control
knob is turned clockwise, rear speaker sound
will be emphasized (front speaker sound will
be attenuated).
Press the TUNE select button for 1 sec. or
more. When the ( ) side is pressed, the unit will
automatically tune to the next higher frequency
and when the ( ) side is pressed, it will automatically tune to the next lower frequency.
3. BASS Control Knob
6. PRESET STATION SELECT Button
Press to pop the knob out and turn to the left or
right for the desired bass tone.
Six (6) stations for AM, FM1 and FM2 respectively can be preset in the electronic memory
circuit on this unit.
TREBLE Control Knob.
Pull the bass control knob further out. Turn to
the left or right for the desired treble tone.
4. BAND Selector
Pressing the FM
button changes the AM, FM1
AM
and FM2 bands. The mode selected is displayed on LCD.
5. TUNE (Manual) Select Button
Press the ( ) side or ( ) side to increase or to
decrease the frequency. With the button held
down for 1 sec. or more, the stop signal (broadcasting radio wave) is ignored and channel
selection continues.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be programmed into the memory of the radio. Then, by
simply pressing the band select button and/or
one of the six station select buttons, you may
recall any of these stations instantly. To program the stations, follow these steps:
o Press band selector to set the band for AM,
FM1, and FM2.
o Select the desired station to be stored by
seek, scan or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising