Elevations: PopGlow Tiles

Elevations: PopGlow Tiles
I. Specifications
DMX512 DECODER
USER MANUAL
Working temperature: -20-60˚ C
Supply voltage: DV 12-24V
Product size: L166xW67xH41 mm
Package size: L185xW85xH59 mm
Net weight: 340g
Gross weight: 380g
Output: Three CMOS drain-open output
Connecting Mode: Common anode
Max output current: 4 A each color
II: Function
1. Each DMX common controller occupied 3 DMX addresses. Each coding switch can set
address code from 1 to 9, 1 is the lowest, and 9 is the highest. A combination of 511
address codes are possible. DMX original address code is the total value of the coding
switch value from 1 to 9. Dial the coding switch upward (ON is set to 1) to set the bit value
(by default the bit value is 0). For example: if you want to set 37 as the address code, you
can only dial down the first, the third, and the sixth code switch, the total value of coding
switch from 1 to 9 is 32+4+1. The default address code of DMX512 is 37.
2. DMX signal can be received when coding switch FUN (10) = OFF (ON is set to 0)
3. When the coding switch FUN (10) is on, its function is as follows:
CODING SWITCH
Switch 1-9 is OFF
Switch 1 = ON
Switch 2 = ON
Switch 3 = ON
Switch 4 = ON
Switch 5 = ON
Switch 6 = ON
Switch 7 = ON
Switch 8 = ON
Switch 9 = ON
FUNCTION
black
red
green
blue
yellow
purple
cyan
white
seven-color jumpy changing (8 steps speed)
seven-color gradual changing (8 step speed)
4. If the coding switch is 8 or 9, speed option is 1 to 7. There are 8 steps total:
CODING SWITCH
Switch 1-7 is OFF
Switch 1 = ON
Switch 2 = ON
Switch 3 = ON
Switch 4 = ON
Switch 5 = ON
Switch 6 = ON
Switch 7 = ON
FUNCTION
0 step
1 steps
2 steps
3 steps
4 steps
5 steps
6 steps
7 steps (the greatest speed)
5. There can be several switches ON at the same time.
CH3 CH2 CH1 COM V+ V-
DMX512 DECODER
OUTPUT
POWER
CH1=R
CH2=G
CH3=B
SWITCH
DMX512 IN
DMX512 OUT
DMX512 IN
DMX512 OUT
IV. Safety Information
1. Input voltage specifications for this controller should be followed strictly to avoid
accidents or damage to the device.
2. Never connect two wires directly to avoid circuit shorting.
3. Lead wire should be connected according to the color diagram.
4. The warranty is valid for one year - we guarantee replacement or repairing free of
charge. Warranty may be voided if product is misused or damage is artificially induced.
V. Connect Diagram
III: Interface Diagram
Dimensional Drawing
Controller
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising