Quick start guide
ENGLISH
CONTROL PANEL
3.1 Control Panel Description
NOTE:
For model
EWF80743, this
option replaced
by “Easy Iron”
program.
* Picture of control panel
model: EWF12843
1
1
2
3
On/Off Button (
9 4 10
5
7
)
4
On/Off button is used to turn on and
turn off your washing machine.
2
Program Touchpads (
)
Press this touchpad to select the
washing program. The relevant light
will light up. (For more information
about washing program, please see
on page 11-12)
3
Temperature Touchpad (
)
Press this touchpad repeatedly to
increase or decrease the wash
temperature if you want your laundry
to be washed at a temperature
different from the one proposed by
the washing machine. The relevant
light will light up.
Different temperatures can be
combined which is dependent
on the program selected.
During a high temperature
cycle you may notice vapour
exiting from the detergent
dispenser drawer of the
washing machine, this is
normal and there is no cause
for alarm.
6
8
Spin Touchpad (
)
Press this touchpad repeatedly to
increase or decrease the spin speed, if
you want your laundry to be spun at a
speed different from the one proposed by
the washing machine. The relevant light
will light up.
Different spin speed can be
combined which is dependent on
the program selected.
No Spin
This option eliminates all the spin phases
and adds 3 rinses to the Cottons program
and 1 rinse for another programs.
Rinse Hold
By selecting this option the water of the
last rinse is not emptied out and the drum
turns regularly to prevent the laundry
creases. The door is still locked to indicate
that the water must be emptied out.
The door stays locked with the water
in the drum. To drain the water refer
to relevant paragraph on page 17.
5 Option Touchpad (
)
Press the option touchpad, if you want
your laundry to be washed with special
functions. The relevant light will light up.
www.electrolux.com
Different options can be combined
which is dependent on the program
selected.
Quick
With this option you can decrease the
program duration. Use this option for
items with light soil or items to refresh.
This option will reduce the working
time and the number of rinses.
If you need to add more rinse
phases, press “ ” + “ ” at the
same time to add “Rinse Plus”
option. (see page 10)
Vapour (For models: EWF85743,
EWF10843, EWF12843)
Select this option to add approximately
30 - 45 minutes of tumbling in vapour
during the wash cycle. Vapour helps open
fabric fibers up to allow laundry additives
to release tough stains. The indicator of
this option comes on.
NOTE:
- Vapour may not necessarily be visible
inside the drum during a vapour wash
cycle. Vapour is created below the
drum and allowed to naturally rise into
the clothes.
- Vapour may not be present during the
entire vapour wash cycle.
- Vapour function is more effective with
half load.
- At the end of the Vapour cycle the
clothes will be warmer, softer and
detached from the drum.
- If Vapour option is selected, rinse
temperatures will be elevated.
- During a vapour cycle you may notice
vapour exiting from the drain hose of the
washing machine, this is normal and
there is no cause for alarm.
Easy Iron (For model: EWF80743)
When selecting this option the laundry is
gently washed and spun to avoid
creasing. In this way ironing is easier.
Soak
This option allows you to soak heavily
soiled clothes and stained items at the
beginning of the wash before main
washing phase.
The machine drum will rotate for short
periods. At other times, the clothes are
soaking and the machine will be doing
nothing, then after 30 minutes the
machine will going to main washing
phase.
Any temperature may be
selected, but COLD (
) water
is recommended with this cycle
as hotter water may set some
stains.
Use the amount of detergent
recommended for a normal wash cycle.
If desired, use a bleach or a soaking
agent safe for the fabric, by pouring it
into the detergent compartment.
This option increases the program
duration.
Rinse & Spin
With this option you can perform only a
last rinse of a selected washing
program.
If you set also the Rinse Plus function
(
) the appliance adds two rinses.
If you set also the “No Spin
the appliance only rinse.
” option,
Drain & Spin
Use this option for very wet clothes to
remove the water and spin.
If you set also the “No Spin
the appliance only drains.
” option,
ENGLISH
6 Delay End Touchpad (
)
Before you start the program, this option
makes it possible to define the end of
the washing program from minimum 3
hours to maximum 20 hours.
7 Start/Pause Touchpad (
)
To start the selected program, press
the “Start/Pause (
)”.
To interrupt a program which is
running, press the “Start/Pause (
)”
to pause the machine, the Start/Pause
pilot light flashes.
NOTE:
If program duration is longer than
3 hours minimum Delay End
option starts from 4 hours.
Press the Delay End touchpad to
choose the end time as your wish. The
display shows the number of hours
and the indicator above the touchpad
is on. This option must be selected
after choosing the wash program, and
before pressing the “Start/Pause”
touchpad.
For example, if the program duration of
your selected program is 3.20 hours
and you define the “Delay End” time to
6 hours. This means your wash
program will finish in 6 hours. (See
diagram below)
“Delay End” Time : 6 hrs.
Countdown
2.80 hrs.
Pressed
Start/Pause
Working Cycle
3.20 hrs.
Start the
Program
End of
Cycle
After select Delay End time, press
Start/Pause touchpad to start the
program. Machine will then countdown
and update time on the display every
hours until it reaches the starting point
of the wash cycle.
If you wish to modify or cancel Delay
End option after starting the program,
follow the steps below:
- set the washing machine to PAUSE
by pressing “Start/Pause” touchpad;
- deselect this option by pressing
Delay End once;
- press the “Start/Pause” to start the
program.
To restart the program from the point
at which it was interrupted, press the
“Start/Pause (
)” again, the Start/
Pause pilot light will stop flashing.
8
Display
The display shows the following
information:
Estimated time of the selected
program
After selecting a
program, the estimated
time is displayed in
hours and minutes (for example 3.01).
The estimated time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric. After the program
has started, the time remaining is
updated every minute.
End Of Program
When the program is
completed the display
will show “ ”.
Alarm Codes
In the event of operating
problems, some alarm
codes can be
displayed, for example
. (see
“Troubleshooting”)
Incorrect Option Selection
If an option which is
not compatible with
the set wash program
selected, the display will show
“
” and flash with 3 consecutive
short beeps.
www.electrolux.com
9
Child Lock Option (
)
10
Your appliance is provided with
CHILD SAFETY LOCK which
permits you to leave the appliance
unsupervised with the door closed
without having to worry that
children might be injured by or
cause damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
)
Select this option to add 2 rinses
to a program.
This option is recommended for
people who are allergic to
detergents, and in areas where the
water is very soft.
This function increases
the program duration.
To set “Rinse Plus” option:
To set “Child Lock” option:
Press and hold “ ” and “
touchpads at the same time
until the LED “ ” lights up.
Rinse Plus Option (
”
The touchpads are locked
(except for the On/Off
“
” button).
To deactivate press and hold
these 2 touchpads at the same
time until the LED “ ” goes off.
Press and hold “ ” and “
”
touchpads at the same time until
the LED “
” lights up.
To deactivate press and hold
these 2 touchpads at the same
” goes off.
time until the LED “
This function remains
enabled even after the
appliance is switched off.
This function remains
enabled even after the
appliance is switched off.
3.2 Enabling/Disabling Buzzer
Sounds
The buzzer sounds operate when:
- The program is completed.
- The appliance has a malfunction.
If you want to disable the buzzer
sound (except for event of
appliance malfunction), press and
” and “Temp
hold “Programs
” touchpads at the same time
for 3 seconds, and listen for
“BEEP, BEEP”.
To enable the Buzzer press and
hold these 2 touchpads at the
same time for 3 seconds, and
listen for “BEEP”.
ENGLISH
3.3 Programs + Options
Cottons;
Cold (
)
to 90 °C
White and
coloured
cotton with heavy
level of soil.
EWF10843,
EWF12843:
8 kg
EWF85743:
7.5 kg
EWF80743:
7 kg
Mixed;
Cold (
)
to 60 °C
Synthetic or mixed EWF10843,
EWF12843:
fabric items with
4 kg
normal level of soil.
EWF80743,
EWF85743:
3.5 kg
Quick 20;
30 °C
Synthetic and
mixed fabric items. 1.5 kg
Light soil and
items to freshen
EWF80743,
up.
EWF85743:
EWF10843,
EWF12843:
1 kg
Bedding;
Cold (
)
to 40 °C
Special program
for one synthetic
blanket, duvet,
bedspread and
so on.
EWF10843,
EWF12843:
4 kg
Cold (
)
to 40 °C
acrylics, viscose,
polyester items
with normal soil.
EWF12843:
1200 RPM
EWF10843:
1000 RPM
EWF80743,
EWF85743:
850 RPM
EWF12843:
1200 RPM
EWF10843:
1000 RPM
EWF80743,
EWF85743:
850 RPM
EWF12843:
800 RPM
EWF10843:
800 RPM
EWF80743,
EWF85743:
600 RPM
EWF12843:
800 RPM
EWF10843:
800 RPM
EWF80743,
EWF85743:
3.5 kg
Delicates; Delicate fabrics as
EWF10843,
EWF12843:
4 kg
EWF80743,
EWF85743:
600 RPM
EWF12843:
1200 RPM
EWF10843:
1000 RPM
EWF80743,
EWF85743:
3.5 kg
Specially tested
Wool/
Handwash; program for woollen 2.5 kg
garments bearing
Cold (
) the “Pure new
to 40 °C
woollen, non-shrink,
machine washable” EWF80743,
EWF85743:
label and hand
2 kg
washing fabrics.
EWF10843,
EWF12843:
EWF80743,
EWF85743:
850 RPM
EWF12843:
1000 RPM
EWF10843:
1000 RPM
EWF80743,
EWF85743:
850 RPM
Rinse +
Delay End
Drain & Spin
Rinse & Spin
Soak
Easy Iron
(Models: EWF80743)
(Models: EWF85743,
EWF10843, EWF12843)
Vapour 1)
RPM)
Quick
(Model: Max.
kg)
Options
Rinse Hold
Maximum
Maximum
Dry Clothes
Spin Speed
Capacity (Model: Max.
No Spin
Program;
Temp.
Program
Description
(type of load and
soil level)
www.electrolux.com
Baby
Wear;
Cold (
)
to 40 °C
Energy
Saving;
40 °C and
60 °C 2)
Baby cotton
clothes and
delicate knitting
items with normal
soil;
EWF10843,
EWF12843:
White and
colourfast, cotton
with normal soil.
Set this program
to have a good
washing results
and decrease the
energy consumption. The time of
the washing
program is
extended;
EWF10843,
EWF12843:
EWF12843:
EWF85743:
EWF10843:
EWF80743:
EWF80743,
EWF85743:
4 kg
EWF80743,
EWF85743:
3.5 kg
8 kg
7.5 kg
7 kg
Rinse +
Delay End
Drain & Spin
Rinse & Spin
Soak
Easy Iron
(Models: EWF80743)
RPM)
(Models: EWF85743,
EWF10843, EWF12843)
(Model: Max.
kg)
Vapour 1)
Maximum
Maximum
Dry Clothes
Spin Speed
Capacity (Model: Max.
Quick
Program
Description
(type of load
and soil level)
Rinse Hold
Program;
Temp.
No Spin
Options
EWF12843:
1200 RPM
EWF10843:
1000 RPM
EWF80743,
EWF85743:
850 RPM
1200 RPM
1000 RPM
850 RPM
1) Vapour option can be combined with temperature 40 to 90 °C only.
2) “Energy Saving” program with 60 °C option selected is recommended for a full load of normally soiled cottons.
4. BEFORE FIRST USE
1.
2.
Ensure that the electrical and water
connections comply with the
installation instructions.
Put 2 litres of water in the detergent
compartment for washing phase.
This activates the drain system.
3. Select “Cottons” cycle at 90 °C,
without any laundry in the machine,
to remove any manufacturing
residue from the drum and tub then
start the machine.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising