loure loure - Kohler Co.

loure loure - Kohler Co.
LOURE
SERVICE PARTS
97907T-4
97908T-4
97907T-4
97908T-4
Single Handle Lavatory Faucet
Single Handle Tall Lavatory Faucet
Single Handle Lavatory Faucet
Single Handle Tall Lavatory Faucet
BEFORE YOU BEGIN
1245336**
832751
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
1262286
Please leave these instructions for the consumer. They contain important information.
1115707
1245330**
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. If possible, install this faucet before installing the lavatory.
3. Inspect the supply tubing for damage and leakage. Replace and maintain as necessary.
4. Observe local plumbing codes.
5. Shut off the water supplies to the fitting.
6. The hightest working pressure for faucet is 0.5MPa(5bar). If it exceeds 0.5MPa(5bar), a pressure
reducer is needed. Or maybe damage the faucet.
1113689
1262287
1115726
1245332
1267494**
880096
1115710
1123942
1267495
50729
871472
LOURE
INSTALLATION INSTRUCTIONS
HANDLE OPERATION
1249321
Lift handle gently. Turn clockwise for hot water, turn counter-colckwise for cold water.
1245333
ROUGH-IN DIMENSIONS
1228834
1069314
219
1102890**
1102891
269
135
1102892
Ø69
Ø60
Ø69
Ø60
Ø41.2
27~60
188~200
112
G1/2˝
834704
Ø41.2
27~60
188~200
1182548
Ø31~Ø37
112
1245337**
50 Max.
525
1142103**
50 Max.
Ø31~Ø37
370
97908T-4:1249319
135
375
36º
113
97907T-4:1245335
36º
1069314
Ø31.75
Ø31.75
**Color code must be specified when ordering.
1262282-2A-A
97907T-4
4
1262282-2A-A
G1/2˝
97908T-4
1
INSTALLATION CHECKOUT
INSTALLATION
How to Install the Spout
Ensure that all connections are tightened and the
handle is in the off position.
If needed to take off the hoses(4) to repair, reinstall
and tighten them by hand.
Open the drain. Turn on main water supply and check
for leaks. Repair as required.
14
1
2
3
Install the mounting stud(2) into the faucet body
base(1). Slide the washer(3) over the flexible hoses(4)
and mounting stud, and into the groove at the bottom
of the faucet body.
4
17
15
16
Insert the faucet assembly into the lavatory hole.
Position the faucet. From underside of the lavatory,
place the brackets(5, Rubber washer is on the top)
onto the mounting stud. Tighten the nuts(6) by
wrench(7) to secure the faucet.
5
6
18
Attach the hoses to water supplies. The hose with
"COLD" label connects to cold water.
7
Loosen screw(15) with 1.5mm hex wrench(14).
Remove the aerator(17) carefully with key(16). Turn
on the faucet. Run the water through the spout for
about one minute to remove any debris. Remove any
debris from the aerator. Shut off the faucet. Keep the
fixing hole facing downwards, reinstall the aerator.
Replacing the Washer & Piston Kit
19
20
Turn counterclockwise to remove the stopper(18).
Take out washer(19). Replace with a new one.
①
Turn counterclockwise to remove the piston kit(20).
Replace with a new one. Reinstall stopper and
washer.
How to Install the Drain
Remove the locknut(8), plastic washer(9), rubber
gasket(10) from the drain body(11).
12
13
Insert the drain body into the lavatory. Reinstall the
rubber gasket(Tapered side up), plastic washer and
locknut back to the drain body in turn. Tighten the
locknut.
11
NOTE: If needed, apply a ring of plumbers putty or
other sealants around the underside of the drain
flange(12), instead of using rubber washer(13).
10
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
Do not reposition the drain after the locknut is
tightened, or you may break the putty or sealant seal.
Remove any excess putty.
9
8
②
1262282-2A-A
2
1262282-2A-A
3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising