VisiCook PowerBoil Cordless Kettle
PLUG WIRING (UK & IRELAND) This appliance is fitted with a BS 1363 13-­‐amp plug. If you have to replace the fuse, only those that are ASTA or BSI approved to BS 1362 and with a rated current of 13 amps should be used. If there is a fuse cover fitted, this cover must be refitted after changing the fuse. If the fuse cover is lost or damaged, the plug must not be used. Spare fuse holders and fuses are available from electrical outlets. If the socket outlets in your home are not suitable for the plug of this product, the plug must be removed and disposed of safely as insertion of the plug into a socket is likely to cause electric hazard. A replacement plug should be wired according to the following instructions. If in doubt, contact a qualified electrician. IMPORTANT: This appliance must be earthed. The wires in the cord set are coloured in the following way: BLUE -­‐NEUTRAL BROWN -­‐LIVE GREEN & YELLOW -­‐EARTH As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire that is coloured green & yellow must be connected to the terminal in the plug that is marked with the letter E or by the earth symbol or coloured green or green & yellow or marked with symbol: The wire that is coloured blue must be connected to the terminal that is marked with the letter N or coloured black. The wire that is coloured brown must be connected to the terminal that is marked with the letter L or coloured red. If the power supply cord becomes damaged in any way, it should be replaced by the manufacturer or any other qualified person. We reserve the right to amend specification as part of our policy of continual product improvements. All sizes, weights, dimensions, temperatures, times, consumption figures are approximate only. The ‘crossed-­‐out wheeled bin’ symbol indicates that this product can be recycled. Do not dispose of with the household waste. To protect the environment take it to your local council’s collection site. WARRANTY Your new product has a warranty of 12 months from the date of consumer purchase. Please keep your receipt as it will be required as proof of date of purchase. This warranty only applies if the item has been used solely for household use in the UK or Ireland, and all instructions have been followed properly. Abuse of your appliance, or failure to descale (where appropriate) will invalidate the warranty. Returned goods cannot be accepted unless repacked properly within the original colour box, and presented with the original receipt. This does not affect your statutory rights. In the event of service query, please contact us on 0121 693 9221 or 0044 121 693 9221 if outside the UK, where we will be pleased to help; or via e-­‐mail on wkg67@teamuki.com Issue 3, 100215
VisiCook PowerBoil Cordless Kettle WKG 67 230V~,50Hz, 2850W IMPORTANT SAFEGUARDS BEFORE USE When using electrical appliances, basic safety precautions should always be followed including the following: times and emptied, to remove any residues from the manufacturing process. Check that the voltage of the Remove all packaging from the kettle and the power base. We recommend that the kettle be boiled two v
Read all instructions before use and retain for future reference. appliance corresponds to the mains voltage of your home. We recommend the powerbase be located as v
Do not touch hot surfaces. Use handles or knobs. Do not place on or near heat sources close to the power socket as possible. v
Do not immerse cord, plug or appliance in water or any other liquid. v
Close supervision is necessary when appliance is used near children. This appliance can be used by The powerbase of the kettle features 360 operation, and so the kettle can be placed on it in the most children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities comfortable orientation for the user. or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. HOW TO OPERATE v
Unplug from outlet when not in use and before cleaning. Allow the kettle to cool before putting on or taking off parts. The kettle only works when the unit is plugged in and the power is on. v
Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. v
The use of accessory attachments not recommended by the appliance manufacturer may cause injuries and invalidate any warranty you may have. v
Do not use outdoors. v
Do not let cord hang over edge of table or counter, or touch hot surfaces or allow the product to be situated underneath or close to curtains, window coverings etc. v
The kettle switch actuator must be in the OFF position before attaching or disconnecting the plug from wall outlet. v
Always ensure the water fill does not exceed the MAX level (1.4-­‐litre) as indicated on the kettle body, and is above the MIN level (0.3-­‐litre) as indicated on the water level gauge. v
Only use the kettle for boiling water; this appliance is for household use only. v
The kettle must be placed on a stable, level surface. v
The kettle body can only be used with the complementing power base, and vice versa; these parts cannot be interchanged with other types of kettle available. v
The lid must be correctly in place during use, and the spout must be free from obstruction. v
Do not remove the lid or open the lid while the kettle is in use and the water is boiling. v
Great care must be taken when pouring boiled water, do not over tilt the kettle. v
Always ensure the kettle is switched OFF before removing from the power base. Your kettle is fitted with a resetting boil-­‐dry protector. If the kettle is accidentally switched on with less than the minimum level of water, the boil-­‐dry protector will operate to safely cut off the power. To use the kettle after this safety operation has been activated, switch the kettle and the power supply OFF, remove and then replace the kettle on its base, allowing the kettle to cool down before re-­‐use. Only use with water inside, between the MIN and the MAX levels. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. o
ALWAYS
remove lid
before filling
with water.
ALWAYS refit the lid
before boiling.
1.
Ensure the kettle is unplugged and the switch actuator is in the OFF position. You can only fill the kettle by removing the lid first; do not attempt to spout fill. 2.
You can open the lid by squeezing together the lid buttons and pulling upwards to release the lid. If the kettle has been recently used, steam may escape upwards; it is always good practice to angle the lid away from you. SEE PICTURES EARLIER. 3.
Fill the kettle, taking care not to splash the rear of the unit, and observing the MIN and MAX levels. The MIN level is 0.3 litres, the MAX capacity is 1.4 litres. If the switch area of the handle is splashed, it should be dried or left to dry before use. 3.
4.
For your safety and for correct operation of the kettle, ensure the lid is pushed firmly closed and remains shut during the boiling cycle. 5.
Fit the kettle onto the powerbase and ensure the product is level, stable, and that no powercord is hanging over the edge of the work surface or otherwise causing a hazard. 6.
Plug the kettle into the power supply and depress the switch actuator into the ON position. The power neon light will become illuminated. 7.
8.
9.
10.
When the kettle has finished boiling, the automatic cut-­‐off system will switch the kettle OFF. Ensure the power supply is switched off and lift the kettle up and off the powerbase. Take care when pouring. NOTE: you may notice a small amount of moisture on the top face of the powerbase. This is condensation from the vents built into the kettle and is entirely normal. 11.
THE BUBBLES AND BOILING ACTION THAT YOU SEE IS ENTIRELY NORMAL. 12.
THE KETTLE IS FITTED WITH AN AUTOMATIC CUT-­‐OFF SYSTEM THAT ACTIVATES WHEN THE KETTLE IS BOILING AND PRODUCING THE CORRECT QUANTITY OF STEAM. 13.
YOU MAY SEE PRE-­‐BOILING BUBBLES & THINK THE AUTO CUT-­‐OFF IS DELAYED – 14.
THIS IS NOT THE CASE. 15.
IT IS TYPICALLY circa 20-­‐SECONDS BETWEEN PRE-­‐BOILING BUBBLES AND AUTO SWITCH-­‐
OFF. THIS IS NORMAL AND NOT A VALID CAUSE FOR CONCERN OR RETURN. 16.
THE BUBBLES START AT APPROX 92° C, WHICH IS THE IDEAL TEMPERATURE FOR COFFEE . DESCALING YOUR KETTLE If you live in a hard water area, you should regularly descale the kettle using a proprietary kettle descaler; if unavailable, we suggest boiling with clean water mixed with the juice of a fresh lemon. Take care to rinse thoroughly afterwards. Your new Glass Kettle is easy to clean with a small brush if you prefer – but you MUST ensure the brush has no detergent or washing-­‐up liquid within it’s bristles. Glass is a smooth material, so scale will take longer to adhere to the inner bowl surface. Please regularly clean to ensure the good looks and life are maintained. CLEANING THE OUTSIDE OF YOUR KETTLE Take care when cleaning the outside of your kettle, and we suggest the following steps to ensure a high quality finish, time after time. 1.
2.
3.
4.
5.
Please note that the warranty does not cover damage caused by failure to clean or descale on a regular basis. Do not immerse the kettle in water Ensure the appliance is switched OFF, is disconnected from the power supply, and is totally cold. Apply a small amount of good quality, branded baby oil onto a soft cloth, and buff onto the exterior parts. Leave for a few moments only, before wiping clean with a fresh, soft cloth; we recommend Microfibre Cleaning Cloths, available from most leading supermarkets. ALWAYS ensure that no oil is allowed to enter the appliance, its controls, or its handle, as a hazard may subsequently occur. Ensure no oil enters the body of the kettle. Ensure the handle and lid are totally dry and not slippy. 
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising