Altronix Power Supply Charger (Optional)
Altronix Power Supply Charger (Optional)
The Altronix AL300ULM is a recommended additional power source. It is a multi-output access control
power supply/charger that is specifically designed for use with access control systems and accessories.
The AL300ULM converts a 115 VAC / 60Hz input into five individually regulated 12 VDC or 24 VDC
power limited outputs. Each output will supply power to the RIM, RRM, magnetic locks, electric strikes,
magnetic door holders, etc. These outputs will operate in both fail-safe and fail-secure modes for door
locks.
With the optional batteries installed, it will back up power to the connected remote devices including
RIM/RRM panels.
Panel Layout
Batteries
Optional
Batteries
Optional
Figure 25. Altronix Power Supply Cabinet layout
InfoGraphic Systems
79
TOPAZ Hardware Installation Manual
Altronix Specifications
•
UL-listed fire, burglar and access control power supply (UL1481, UL603, UL294)
•
CSFM - California State Fire Marshal Approved.
•
MEA - NYC Department of Buildings Approved.
•
NFPA 72 compliant.
•
Class 2 rated.
•
Input 115VAC / 60Hz, .9 amps.
•
Field selectable 12VDC or 24VDC
•
2.5 amps continuous supply current at 12VDC / 24VDC.
•
Five (5) individual power limited outputs.
•
Current limit is 2.5 amps @ 12VDC or 24VDC per output.
•
Filtered and electronically regulated outputs.
•
Maximum charge current 600mA.
•
Built-in charger for sealed lead acid or gel type batteries.
•
Automatic switch over to stand-by battery when AC fails.
•
Zero voltage drop when switching over to battery backup.
•
Thermal and short circuit protection with auto reset.
•
Short circuit and overload protection.
•
AC input and DC output LED indicators.
•
LEDs indicate condition of power outputs.
•
Power & input trigger LEDs.
•
AC fail supervision (form "C" contact).
•
DC output supervision (form “C” contact).
•
Low battery supervision (form "C" contact).
•
Fire Alarm Panel or Access Control System trigger inputs.
•
80
(N.O. or N.C. supervised trigger input and polarity reversal trigger input (4mA draw from
FACP).
•
Power fail supervision relay (form “C” contact rated 1amp @ 28VDC/115VAC).
•
Output relay energizes when unit is triggered (form “C” contact rated 1amp @
28VDC/115VAC).
•
Power supply is complete with enclosure, cam lock, transformer, and battery leads.
•
Enclosure accommodates up to two (2) 12AH batteries.
•
Enclosure dimensions: 15.5"H x 12"W x 4.5"D
InfoGraphic Systems
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising