8. G Sensor S401183 - negativesplits.net

8. G Sensor S401183 - negativesplits.net
G SENSOR
ABS
8. G Sensor
A: REMOVAL
B: INSTALLATION
S401183
S401183A11
1) Install in the reverse order of removal.
S401183A18
NOTE:
Do not install G sensor in the wrong direction.
There is an arrow mark on the sensor showing
which side faces the vehicle front.
1) Disconnect battery ground terminal.
G6M0095
2) Remove console cover.
<Ref. to EI-36 Console Box.>
3) Disconnect connector from G sensor.
4) Remove G sensor from body.
B4M1729A
CAUTION:
Do not drop or bump G sensor.
B4M1734
ABS-24
G SENSOR
C: INSPECTION
No.
1
2
3
4
5
6
7
ABS
S401183A10
Step
CHECK SUBARU SELECT MONITOR.
CHECK G SENSOR.
1) Turn ignition switch to OFF.
2) Remove G sensor from vehicle.
3) Connect connector to G sensor.
4) Turn ignition switch to ON.
5) Measure voltage between G sensor connector terminals.
Connector & terminal:
(R70) No. 2 (+) — No. 3 (−)
CHECK G SENSOR.
Measure voltage between G sensor connector
terminals.
Connector & terminal:
(R70) No. 2 (+) — No. 3 (−)
CHECK G SENSOR.
Measure voltage between G sensor connector
terminals.
Connector & terminal:
(R70) No. 2 (+) — No. 3 (−)
CHECK G SENSOR.
1) Turn ignition switch to OFF.
2) Connect select monitor connector to data
link connector.
3) Turn select monitor into {BRAKE CONTROL} mode.
4) Set the display in the {Current Data Display
& Save} mode.
5) Read the G sensor output voltage.
CHECK G SENSOR.
1) Remove console box.
2) Remove G sensor from vehicle. (Do not
disconnect connector.)
3) Read the select monitor display.
CHECK G SENSOR.
Read the select monitor display.
Check
Do you have SUBARU
SELECT MONITOR?
Is the voltage 2.3±0.2 V
when G sensor is horizontal?
Yes
Go to step 5.
No
Go to step 2.
Go to step 3.
Replace G sensor.
Is the voltage 3.9±0.2 V
when G sensor is inclined
forwards to 90°?
Go to step 4.
Replace G sensor.
Is the voltage 0.7±0.2 V
when G sensor is inclined
backwards to 90°?
G sensor is normal.
Replace G sensor.
Is the indicated reading
Go to step 6.
2.3±0.2 V when the vehicle
is in horizontal position?
Replace G sensor.
Is the indicated reading
Go to step 7.
3.9±0.2 V when G sensor
is inclined forwards to 90°?
Replace G sensor.
Is the indicated reading
0.7±0.2 V when G sensor
is inclined backwards to
90°?
ABS-25
G sensor is normal.
Replace G sensor.
ABS
G SENSOR
MEMO:
ABS-26
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising