Timer Guide - Anywhere Cart

Timer Guide - Anywhere Cart
Timer Guide
888-650-4488
www.anywherecart.com
SETTING UP TIMER
IMPORTANT: The electrical system is designed to handle a
MAXIMUM of 1875 Watts
If your device power adapters draw more than 45 Watts each,
DO NOT USE “ON MODE”, use “TIMER MODE” ONLY
1. Before initial setup, IDENTIFY the wattage of your device’s power adapter. Multiply this number by the number of devices being charged.
65 Watts
X
36 Devices
2340 Watts
2. Determine which EXTERNAL devices, if any, will be used and IDENTIFY the wattage.
257 Watts
X
1 Device
257 Watts
3. Add device power adapter wattage total and the external device total:
l If the combined total wattage is under 1875 Watts, any mode can be selected.
l If over 1875 Watts, DO NOT USE “ON MODE”. Divide device wattage by 2, then add EXTERNAL devices. If under 1875 Watts, use “TIMER MODE” only.
l If the total device wattage divided by 2, plus the external devices is over 1875 Watts, remove devices as needed.
D
2340 Watts Devices
+ 257 Watts Projector
= 2597 Watts TOTAL
NO “ON MODE”
2340 Watts Devices / 2
+ 257 Watts Projector
= 1427 Watts TOTAL
YES “TIMER MODE”
C
NOTE: If wattage exceeds 1875 Watts at one time, the charging system will not operate correctly.
Remove devices as needed until the total wattage is under 1875 Watts.
TIMER OPERATION
Turning ON the Charging System
1. Plug power cord into outlet.
2a. If Equipped with Illuminated Switch:
Press switch to “I”. Switch will illuminate.
2b. If Equipped with AIR Switch:
Press switch to turn power on.
Push Button TIMER
IMPORTANT: The electrical system is designed to handle a
MAXIMUM of 1875 Watts
ON MODE
If your device power adapters draw more than 45 Watts each,
DO NOT USE “ON MODE”, use “TIMER MODE” ONLY
All 4 LEDs illuminate and all power strips are on until switched off.
TIMER MODE
1 LED illuminates for 5 minutes, then cycles to next in sequence and will repeat. Adjustable Dial TIMER
IMPORTANT: The electrical system is designed to handle a
ON MODE
MAXIMUM of 1875 Watts
If your device power adapters draw more than 45 Watts each,
DO NOT USE “ON MODE”, use “TIMER MODE” ONLY
Both LEDs illuminate and all power strips are on until switched off.
TIMER MODE
Turn the dial to the desired cycle duration time. Channel “A” LED illuminates for duration, then cycles to channel “B”. The process repeats.
TIMER TROUBLESHOOTING
TIMER TROUBLESHOOTING
Cart won’t turn on:
1) With the EXTERNAL POWER SWITCH OFF, open the rear panel door. Locate power cord going INTO the timer. Verify it is securely plugged in.
2) Check the EXTERNAL POWER SWITCH for physical damage.
Replace by pushing up then down from the back of the switch.
Pull shrink-wrap back and remove wire clips, making note of their position.
Install new switch and verify operation.
Devices aren’t charging:
1) With the EXTERNAL POWER SWITCH OFF, open the rear panel door. Check power strip cords going INTO the timer are securely plugged in.
2)
With the EXTERNAL POWER SWITCH ON, Turn the dial on the TIMER to
ON mode and verify both “A” and “B” are illuminated.
3)
Verify all 4 power strips inside cart are
illuminated. If not, switch them on now.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising