RealPresence Debut Regulatory Notices

RealPresence Debut Regulatory Notices
January 2016 | 3725-69719-001A
Polycom® RealPresence Debut™
Important Safeguards
Read and understand the following instructions before using the system:
• Closely supervise the area when using the system near children. Do not leave the system unattended while in
• Only use electrical extension cords with a current rating at least equal to that of the system.
• Always disconnect the system from power before cleaning and servicing and when not in use.
• Do not spray liquids directly onto the system when cleaning. Always apply the liquid first to a static-free cloth.
• Do not immerse the system in any liquid or place any liquids on it.
• Do not disassemble this system. To reduce the risk of shock and to maintain the warranty on the system, a
qualified technician must perform service or repair work.
• Connect this appliance to a grounded outlet.
• Only connect the system to surge protected power outlets.
• Keep ventilation openings free of any obstructions.
• If the system or any accessories are installed in an enclosed space such as a cabinet, ensure that the air
temperature in the enclosure does not exceed 40°C (104° F). You may need to provide forced cooling to keep
the equipment within its operating temperature range.
• Do not use this product near water.
• Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Special Safety Instructions
Plug Acts as Disconnect Device: The socket outlet to which this apparatus is connected must be
installed near the equipment and must always be readily accessible.
Follow existing safety instructions and observe all safeguards as directed. Installation must be performed
in accordance with all relevant national wiring rules.
We recommend that you install an AC surge arrestor in the AC outlet to which this device is connected. This action
will help to avoid damage to the equipment caused by local lightning strikes and other electrical surges.
Regulatory Notices
Polycom RealPresence Debut
Regulatory Notices
When using Power over Ethernet (PoE), the equipment is to be connected only to PoE networks without
connections to the outside plant.
All PoE sources must meet the Limited Power Source requirements of IEC 60950-1:2005 (2nd Edition); Am1:2009
or IEC 60950-1:2005 (2nd Edition); Am1:2009; Am2:2013.
Lorsque vous utilisez une alimentation électrique par cable ethernet (PoE - Power over Ethernet) , l'équipement doit
être connecté uniquement aux réseaux PoE sans connexions vers l'extérieur de l'usine.
Toutes les sources PoE doivent satisfaire aux exigences de source d'alimentation limitée de la CEI 60950-1 : 2005
( 2ème édition ) ; Am1 : 2009 ou IEC 60950-1: 2005 (2ème édition ) ; Am1 : 2009; Am2 : 2013.
This is a Class A product. In a domestic environment, this product may cause radio interference in which case the
user may be required to take adequate measures.
USA and Canadian Regulatory Notices
FCC Notice
Class A Digital Device or Peripheral
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
In accordance with Part 15 of the FCC rules, the user is cautioned that any changes or modifications not expressly
approved by Polycom Inc. could void the user's authority to operate this equipment.
Part 15 FCC Rules
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
Industry Canada (IC)
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la Classe [A] est conforme à la norme NMB-003 du Canada.
Class A Statements
Polycom, Inc.
Regulatory Notices
Polycom RealPresence Debut
Regulatory Notices
Polycom RealPresence Debut
1.고장시 임의로 분해하지 마시고 A/S센터로 연락하십시오
2.통풍이 잘되는 곳에서 사용하십시오
3.습기 및 수분이 많은 장소에서는 사용을 금합니다.
This is a Class A product. In a domestic environment, this product may cause radio interference in which case the
user may be required to take adequate measures.
Mexico Regulatory Notices
Polycom, Inc.
Regulatory Notices
Polycom RealPresence Debut
Regulatory Notices
EEA Regulatory Notices
CE Mark LVD & EMC Directive
This Polycom RealPresence Debut has been marked with the CE mark. This mark indicates compliance with EEC
Directives 2006/95/EC, 2004/108/EC. A full copy of the Declaration of Conformity can be obtained from Polycom
Ltd., 270 Bath Road, Slough UK SL1 4DX.
Installation Instructions
Installation must be performed in accordance with all relevant national wiring rules.
Restriction of Hazardous Substances Directive (RoHS)
Polycom products are RoHS compliant, which means we have eliminated or brought to within acceptable limits:
Lead, Mercury, Cadmium, Hexavalent Chromium, Polybrominated Biphenyls, and Polybrominated Diphenylethers.
For more information, please contact
End of Life Products
Polycom encourages you to recycle your end-of-life Polycom products in an environmentally considerate way.
In accordance with the requirements of the European Waste Electronic and Electrical Equipment (WEEE) Directive,
all Polycom products are marked with the crossed wheelie bin symbol shown under Battery Guidelines. Products
that carry this symbol should not be disposed of in the household or general waste stream. Details of the options
open to you and the guidance on the requirements for the recycling and environmentally considerate disposal of
your end of life Polycom products can be found at
Electrical Specifications
Polycom RealPresence Debut, 48Vdc/0.52A @ 100V~240Vac/50-60Hz Typical BTU/h: 85
PoE power sources used must comply with the following operating ranges:
● IEEE 802.3 af
● IEEE 802.3 at
 Type 1: 15.4W power source, 44 to 57Vdc supply using two pairs
 Type 2: 30W power source, 50 to 57Vdc supply using two pairs
Security Notice
In accordance with local laws and regulations, not all security options are available in all countries.
Polycom, Inc.
Regulatory Notices
Polycom RealPresence Debut
Copyright Information
Copyright© 2016, Polycom, Inc. All rights reserved. No part of this document may be reproduced, translated into another
language or format, or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the
express written permission of Polycom, Inc.
6001 America Center Drive
San Jose, CA 95002
Trademarks Polycom®, the Polycom logo and the names and marks associated with Polycom products are
trademarks and/or service marks of Polycom, Inc. and are registered and/or common law marks in the United States
and various other countries.
All other trademarks are property of their respective owners. No portion hereof may be reproduced or transmitted in any
form or by any means, for any purpose other than the recipient's personal use, without the express written permission
of Polycom.
Disclaimer While Polycom uses reasonable efforts to include accurate and up-to-date information in this document,
Polycom makes no warranties or representations as to its accuracy. Polycom assumes no liability or responsibility for
any typographical or other errors or omissions in the content of this document.
Limitation of Liability Polycom and/or its respective suppliers make no representations about the suitability of the
information contained in this document for any purpose. Information is provided "as is" without warranty of any kind and
is subject to change without notice. The entire risk arising out of its use remains with the recipient. In no event shall
Polycom and/or its respective suppliers be liable for any direct, consequential, incidental, special, punitive or other
damages whatsoever (including without limitation, damages for loss of business profits, business interruption, or loss of
business information), even if Polycom has been advised of the possibility of such damages.
End User License Agreement By installing, copying, or otherwise using this product, you acknowledge that you
have read, understand and agree to be bound by the terms and conditions of the End User License Agreement for this
product. The EULA for this product is available on the Polycom Support page for the product.
Patent Information The accompanying product may be protected by one or more U.S. and foreign patents and/or
pending patent applications held by Polycom, Inc.
Open Source Software Used in this Product This product may contain open source software. You may receive
the open source software from Polycom up to three (3) years after the distribution date of the applicable product or
software at a charge not greater than the cost to Polycom of shipping or distributing the software to you. To receive
software information, as well as the open source software code used in this product, contact Polycom by email at
Customer Feedback We are striving to improve our documentation quality and we appreciate your feedback. Email
your opinions and comments to
Polycom Support Visit the Polycom Support Center for End User License Agreements, software downloads,
product documents, product licenses, troubleshooting tips, service requests, and more.
Polycom, Inc.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF