FM1-EV-WRC-FMC-MICROLOAD-EN-WITH-EV-CFG-001

FM1-EV-WRC-FMC-MICROLOAD-EN-WITH-EV-CFG-001
PART# EV-TUR-001
FMC TECH MICROLOAD
INTO PULSER MODE SETUP
DIRECT CONNECTION
Power source
(12-30VDC)
PULL UP
RESISTOR
1K, 1/2W
Fuse 1A
Blue (Power in)
Pink (PUL2-RESET)
Grey(PUL1-Pulser Input)
White (DIAG-232RX)
Black (DIAG-232TX)
Brown (GND)
TEKINNO CORPORATION INC
Ground
EAGLEVIEW-WRC PULSER MODE DIRECT CONNECTION
ELECTRICAL INSTALLATION (REV1.1)
DOCUMENT : FM1-EV-WRC
BY : S.L.
DATE : 2016-08-29
PAGE : 1 of 3
DWG NO: FM1-EV-WRC-FMC-MICROLOAD-EN-WITH-EV-CFG-001-REV1_1
FMC TECH MICROLOAD
INTO PULSER MODE SETUP
WITH CONFIG BOARD
PART# EV-TUR-001
TK-14002 SWITCHES
SW1 must be set into CONFIG mode
SW2 must be set to ON
PART# EV-CFG-001
Dimensions : 2.2"(5.56cm) x 1.6"(4.06cm)
+12VDC, 0.7A
Blue (Power in)
Brown (GND)
Pink (PUL2-RESET)
Grey(PUL1-Pulser Input)
White (DIAG-232RX)
Black (DIAG-232TX)
TEKINNO CORPORATION INC
EAGLEVIEW-LDD PULSER MODE WITH CONFIG BOARD
Ground
ELECTRICAL INSTALLATION (REV1.1)
DB9 CONFIG PORT
DOCUMENT : FM1-EV-WRC
BY : S.L.
DATE : 2016-08-29
PAGE : 2 of 3
DWG NO: FM1-EV-WRC-FMC-MICROLOAD-EN-WITH-EV-CFG-001-REV1_1
GLOBAL MODE
FMC TECH MICROLOAD PULSER
MODE CONFIGURATION
MESSAGE SETTINGS
INPUTS MODE
PULSER SETTINGS
AMBIENT LIGHT SENSOR SETTINGS
TEKINNO CORPORATION INC
EV manager software link at : http://tekinno.com/ressources/softwares/
Eagelview Manager Software version must be 2.0.0.23 or higher
Eagleview-WRC Firmware must be the latest
FMC TECH MICROLOAD PULSER MODE CONFIGURATION
ELECTRICAL INSTALLATION (REV1.1)
DOCUMENT : FM1-EV-WRC
BY : S.L.
DATE : 2016-08-29
PAGE : 3 of 3
DWG NO: FM1-EV-WRC-FMC-MICROLOAD-EN-WITH-EV-CFG-001-REV1_1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising