ColorKey TriStar
TriStar
Tri-Color LED Centerpiece
CKU01-1010 (US) / CKE01-1010 (EU)
USER MANUAL
Introduction
Thank you for purchasing the ColorKey TriStar. Please read these instructions carefully
before use. Operating this fixture according to these instructions is important to avoid any
possible damage or accidents caused by misuse.
Packing list
n
1x TriStar fixture
n
1x Power cord
n
User Manual
Safety
Caution! Opening this unit voids warranty. Contact ColorKey for any service requests.
Warning! To avoid electrical shock, be sure to disconnect power before any service or when
moving or setting up the fixture.
Caution! Avoid direct eye exposure with the fixture when on.
Ø This fixture is for indoor use only.
Ø This fixture must be installed a minimum distance of 5 meters (16’4”) away from any
lighted objects.
Ø Do not install or operate this fixture near flammable materials.
Ø This device must be installed, operated, and maintained by a qualified professional.
Ø Do not touch the fixture with bare hands during operation as the surface temperature of
the fixture can exceed 60˚C (140˚F). Turn off power and wait 15 minutes for the fixture to
cool before attempting to touch it.
Ø Please check if the voltage is in accordance with the rated power before installing.
Ø Do not operate this fixture if the power cord has been damaged. Turn off fixture and
replace with a power cord of similar rating.
1
DMX Addressing
Auto
Dip Switch
Sound
From the
active
machine
1
Motor speed
XX
ON
2
OFF slow / ON fast
XX
OFF
3
LED speed
XX
OFF
XX
OFF
XX
OFF
DMX
OFF slow / ON fast
4
5
OFF the seven colors
ON Red
DMX address
jump ON to gradient
6
As a host ON flicker
1 to 9 are the
ON Green
XX
OFF
OFF strobe
7
XX
ON Blue
XX
OFF
8
OFF
ON
XX
OFF
9
OFF
OFF
ON
OFF
10
ON
ON
ON
OFF
2
OFF
DMX Channels
Channel
CH1
CH2
CH3
CH4
CH5
CH6
CH7
Function
Value
0-127
Motor position
128-191
Rotation (fast to slow)
192-255
Reverse Rotation (fast to slow)
0
Strobe effect
1-255
Strobe speed (slow to fast)
0
Red OFF
1-255
Red DIM
0
Green OFF
1-255
Green DIM
0
Blue OFF
1-255
Blue DIM
0-10
CH1 to CH5
11-33
Au01
34-57
Au02
58-81
Au03
…
Au04-09
250-255
Au010 Sound control effect
0-255
LED Programs (fast to slow)
3
DMX Connections
DMX Cable:
The TriStar can be controlled via DMX using a 3-pin XLR connection. The standard
DMX connection is XLR is: one end connects to the male plug, and the other connects to the
female. As below: pin 1: ground, pin 2: negative signal, pin 3: positive signal
Noted:In order to avoid failures and interference signal transmission,we connect a
resistance120Ω ( 1/4W ) at
the
end
of
the
DMX
connecting
as
below:
The Conversion between 3 pin and 5 pin XLR
If the output cable of DMX512 controller is the 5PIN, please use 1pc 5PIN to 3PIN cable
4
Troubleshooting
Problem
Solutions
u Make sure that the DMX cable is properly connected
No DMX control
u Make sure that the DMX controller is operational
u Check the DMX cable for tears or breaks
u Make sure that the fixture is in DMX mode
Fixture does not
respond to sound
u Make sure that the fixture is in Sound Active mode.
5
Technical Information
Power Supply:AC110V-230V 60/50Hz
Light source: 3x3W RGB LED units
Power Consumption: 30W
Channel: 7 channels
Control: DMX, Master/Slave, sound activated, auto
Working temperature: Indoor -20℃~40℃
Protection rating: IP20
Notice to consumer: ColorKey offers a 1-year limited warranty. Please visit our website at
www.ColorKeyLED.com to register your product.
Please note: As we continue to work towards improving our products and your experience
as a user, we recommend that you check our website periodically for updates to user
manuals and specifications at www.ColorKeyLED.com or you may contact us directly at
info@colorkeyled.com.
6
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising