"brake lever" "always check"

"brake lever" "always check"
▼
Table of Contents
▲
Main Menu
Seats
Driver’s Seat Height Adjustment
Head Restraints
See page 13 for important safety
information and a warning about how to
properly position the head restraints.
Your vehicle is equipped with head
restraints in all seating positions to
help protect you and your
passengers from whiplash and other
injuries.
To change the seat-back angle of the
front seat, pull up the lever on the
outside of the seat bottom.
Once a seat is adjusted correctly,
rock it back and forth to make sure it
is locked in position.
90
The height of your driver’s seat is
adjustable. To raise the seat,
repeatedly pull up the lever on the
outside of the seat cushion. To lower
the seat, push the lever down
repeatedly.
They are most effective when you
adjust them so the back of the
occupant’s head rests against the
center of the restraint.
▼
Table of Contents
▲
Main Menu
Seats
Rear Center Position
The head restraints adjust for height.
You need both hands to adjust a
restraint. Do not attempt to adjust it
while driving. To raise it, pull upward.
To lower the restraint, push the
release button sideways, and push
the restraint down.
RELEASE BUTTON
When a passenger is seated in the
rear center seating position, make
sure the center head restraint is
adjusted to its highest position.
The lid of the console compartment
can be used as an armrest by moving
it forward and backward. Make sure
the armrest is securely latched.
Make sure your passenger’s hands
or fingers are away from the armrest
before moving it.
91
Instruments and Controls
RELEASE BUTTON
Armrest
▼
Table of Contents
▲
Main Menu
Power Windows
DRIVER’S WINDOW SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
MAIN SWITCH
Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open the window, push
the switch down and hold it. Release
the switch when you want to stop the
window. To close the window, pull
back on the switch and hold it.
The windows operate for up to 10
minutes after you turn off the
ignition switch. Opening either front
door cancels this function.
92
If the MAIN switch is OFF, the
passenger windows cannot be raised
or lowered. Keep the MAIN switch
off when you have children in the
vehicle so they do not injure
themselves by operating the
windows unintentionally.
AUTO − To open or close the
driver’s window, push or pull the
window switch firmly down or up to
the second detent, and release it.
The window will automatically go
down or up all the way. To stop the
window, pull or push the window
switch briefly.
AUTO REVERSE − If the driver’s
window senses any obstacle while it
is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
▼
Table of Contents
▲
Main Menu
Mirrors
Adjusting the Power Mirrors
TAB
SELECTOR SWITCH
The inside mirror has day and night
positions. The night position reduces
glare from headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.
1. Turn the ignition switch to the ON
(II) position.
2. Move the selector switch to L
(driver’s side) or R (passenger’s
side).
3. Push the appropriate edge of the
adjustment switch to move the
mirror right, left, up, or down.
4. When you finish, move the
selector switch to the center (off)
position. This turns the
adjustment switch off to keep your
settings.
93
Instruments and Controls
Keep the inside and outside mirrors
clean and adjusted for best visibility.
Be sure to adjust the mirrors before
you start driving.
ADJUSTMENT SWITCH
▼
Table of Contents
▲
Main Menu
Mirrors, Parking Brake
Heated Mirrors
Parking Brake
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axles. A beeper will sound
if the vehicle is driven with the parking
brake on.
HEATED MIRROR BUTTON
On Canadian models
The outside mirrors are heated to
remove fog and frost. With the
ignition switch in the ON (II)
position, turn on the heaters by
pressing the button. The indicator in
the button comes on as a reminder.
Press the button again to turn the
heaters off. Pressing this button also
turns the rear window defogger on
and off.
94
PARKING BRAKE LEVER
To apply the parking brake, pull the
lever up fully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the parking
brake is fully released (see page 58 ).
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising