SMARTCHARGER

SMARTCHARGER
12V
SMARTCHARGER
User manual type 3245
7A
SAFETY
READ THESE INSTRUCTIONS PRIOR TO USING THE CHARGER
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance
The charger is protected against injects of dust and water according to IP65.
If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified person in order to avoid a hazard.
Note! Make sure the charger terminals are not short-circuited and ensure that the
polarity is correct.
that the specifications for your battery allows for the maximum charge current
indicated on the charger. If in doubt; contact the battery manufacturer for the specific battery. Do not attempt to charge batteries that are not rechargeable.
WARNING
As explosive gases may arise during charging lead-acid batteries the charger
and the battery should be placed in a well-ventilated area during charging. Avoid
sparks and open flames.
Maintenance and warranty
To avoid overheating make sure there is sufficient room for circulation of air around the product when in use. Do not cover it up.
The charger is maintenance free. If the unit itself or its cords are damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified person in
order to avoid a hazard. Do not attempt to service or open the charger yourself.
It is possible to clean the unit using a mild detergent and a towel. When cleaning
the unit, it must be disconnected from mains.
As the charger has a plastic housing, please avoid any contact with lotions, oils,
grease and solvents as most types of plastic may be degraded by such chemicals.
The mains socket outlet used should always be easily accessible to facilitate immediate removal of the products mains supply should an operational error occur
during use.
Keep this manual!
If the charger is disconnected from the mains voltage during a charge cycle the
charger will resume the charge cycle when it is reconnected to the mains.
The product contains hazardous voltages and there are no user replaceable parts
inside the product. Never attempt to remove the cover. Any repair/service should
be carried out by qualified personnel who may get assistance by contacting the
manufacturer or the manufacturer’s agent.
The charger has automatic polarity protection and will be switched off if the battery is connected with reverse polarity. The protection will be automatically reset
when the polarity has been corrected.
www.mascot.com
Main Office NORWAY
Box 177
N-1601 Fredrikstad
+ 47 69 36 43 00
sales@mascot.no
Mascot UK
Bok 2090, Salisbury
Wiltshire SP2 2BH
+44 172 250 4853
Mascot DE, BENELUX
Hirschbergstr. 28/7
D-74838 Limbach
+49 628 795 140
Mascot DE, CH, AT
Tettnanger Str. 52
D-88239 Wangen
+49 752 895 1677
Mascot FRANCE
38 rue Leo Lagrange
F-94270 Le Kremlin Bicêtre
+33 146 587 185
Mascot BALTIC, RUSSIA
Taevakivi 15
13619 Tallinn, Estonia
+372 555 21 121
Mascot SWEDEN
Box 177
N-1601 Fredrikstad
+46 526 14025
Lead-Acid chargers are designed for charging Lead-Acid batteries only. For safety
reasons, individual battery types should have a minimum capacity, please check
2
3
CONGRATULATIONS!
Quick start
For optimal charge and maintenance of your battery, whether it is a standard lead
acid, calcium, GEL or AGM battery, this microprocessor-controlled temperature
compensated charger will be at your service for many years to come, provided
the correct use and care of both the charger and the batteries.
MODE SELECT
Check that the battery and charger specifications match. Take the charger out
from the case and connect the charger to the battery. To charge a vehicle battery, connect first the positive clip (marked “+”) to the positive battery pole then
connect the other clip (marked “-“) to the car’s chassis away from the battery and
fuel system (fuel hoses, fuel pump etc.). Place the temperature sensor on top of
or close to the battery or inside the positive battery. Connect the charger to the
mains. The charger will show that the power is on and that the mains cable is
connected to the wall socket. The charger will start charging battery automaticalModes
ly. If your 12V battery is not standard or AGM, press the mode button to select
Large batteries
correct
for your type of battery.
14,7VDCprogram
max 7A 30-120Ah
If Small
pulse
LED flashes in 1 sec. Intervals, check wether the battery clips are properly
batteries
14,7VDC max Cancel
1,5A 30-30Ah
connected.
charge by disconnecting the charger from the wall socket then
Gel batteries
remove
the
chassis
connection and then the battery connection.
GEL
R
14,4VDC max 7A 30-120Ah
Recond (recovery)
15,7VDC max 1,5A 30-120Ah
Programs
Power supply
13,7VDC
max 6,5A
The
following
5 charge programs are available by pressing the “mode” button:
THERMOPLASTIC COVER
IP65 - WATER RESISTANT
RUBBER SEAL
CHARGING STATUS INDICATION
Large batteries
14.7VDC max 7A, recommended battery capacity 30-120Ah
Small
batteries
SOFT GRIP
14.7VDC max 1.5A, recommended battery capacity (3)5-30Ah
STAINLESS STEEL
Gel batteries
GEL
14.4VDC max 7A, recommended battery capacity 30-120Ah
Pulse charge
13,7VDC max 7A pulses
R
Recond (recovery) improves deeply discharged and severely
sulfatised batteries. For large batteries only. Indicator returns
to large battery mode when cycle is completed. Use once a
year or when your battery has been fully discharged.
15.7VDC max 1.5A, recommended battery capacity 30-120Ah
Power supply or float charger
13.7VDC
max 6.5A
www.mascot.com
Standard:
battery clips
Temperature sensor
4
Main Office NORWAY
Box 177
N-1601 Fredrikstad
+ 47 69 36 43 00
Mascot UK
Bok 2090, Salisbury
Wiltshire SP2 2BH
+44 172 250 4853
Mascot DE, BENELUX
Hirschbergstr. 28/7
D-74838 Limbach
+49 628 795 140
sales@mascot.no
Mascot DE, CH, AT
Tettnanger Str. 52
D-88239 Wangen
+49 752 895 1677
Mascot FRANCE
38 rue Leo Lagrange
F-94270 Le Kremlin Bicêtre
+33 146 587 185
Mascot BALTIC, RUSSIA
Taevakivi 15
13619 Tallinn, Estonia
+372 555 21 121
Mascot SWEDEN
Box 177
N-1601 Fredrikstad
+46 526 14025
The «mode» button is active in 5 seconds after the battery and the mains have
been connected and charging has started. After this, it is possible to change
program by pressing the button for 3 seconds: when Mode LED is blinking it is
possible to change program. If the charger is disconnected from the mains, the
last program selected will be memorized.
5
Mains
connected
Charge progression (in %)
Pulse
Pulse LED flashing in 1 sec interval when battery is not connected
R
•
Mode and
error indication
GEL
“Mode” programs
LED indication
Mode
select
0%
40%
60%
80%
100%
R
Pulse LED flashing in 7 sec intervals when in Float and Pulse charge phase
GEL
•
20%
0%
20%
40%
60%
80%
100%
R
GEL
• All LEDs 0-100% are flashing simultaneously when in Recond phase.
(after top up charge)
0%
www.mascot.com
20%
40%
60%
80%
100%
sales@mascot.no
R
GEL
Main Office NORWAYin Mascot
Mascot
FRANCEthe battery
UK
Mascot DE,during
BENELUX
Mascot
DE, CH, AT
Mascot BALTIC,
RUSSIA Mascot
• LED 0% Flashing
1 sec
interval
softstart
(when
voltage
isSWEDEN
Box 177
38 rue Leo Lagrange
Bok 2090, Salisbury Hirschbergstr. 28/7
Tettnanger Str. 52
Taevakivi 15
Box 177
N-1601 Fredrikstad
F-94270 Le Kremlin Bicêtre 13619 Tallinn, Estonia
Wiltshire SP2 2BH
D-74838 Limbach
D-88239 Wangen
N-1601 Fredrikstad
below 10,5V)
+ 47 69 36 43 00
+33 146 587 185
+44 172 250 4853
+49 628 795 140
+49 752 895 1677
+372 555 21 121
+46 526 14025
0%
6
20%
40%
60%
80%
100%
7
LED error codes
Sequential flashing RED ”MODE” LEDs
GEL
R
Battery voltage remains low after
precharge.
Wrong or defect battery.
Safety timer expired.
Wrong or defect battery.
Battery voltage above 16V.
Check battery type.
Old, sulfated Lead-Acid batteries usually have a reduced capacity and may
be difficult to charge. The charge current may fall rapidly as if the battery had
received a full charge, and the charger will indicate 100% charge. Even though a
battery in this condition should be replaced, it will retain a small charge .
8
Technial data 12V
Input voltage: / Line frequency: 198 - 264VAC / 47 - 63Hz
Max output power:
103W
Modes
1. Large batteries 2. Small batteries
3. Gel batteries 4. Recond 5. Power supply
Charge voltage:
14.7V at 20oC
Charge voltage GEL:
14.7V at 20oC
Charge voltage Recond:
Max 15.7V
Float voltage:
13,7 at 20oC
Charge current:
7A (1.5A small batteries and Recond Phase)
As Power supply:
Output voltage: 13.7V max 6.5A
Ripple: < 100mVp-p
Formation Charge:
Low current start-up of deeply discharged battery.
Float charge:
Auto modus: 7.0A pulses at safe float voltage level for maximum topping of battery capacity
(1.5A pulses,small batteres).
Temperature compensation of
charge voltage:
-3 to -4mV/oC pr. cell
Efficiency (at 100% load, 230V): > 89 %
Switch frequency approx.:
65kHz
Leakage current from battery
with mains switched off:
< 50 uA at 12V
Protection:
Protected against reversed polarity and short circuit
proof. Prevents sparking. Charge timer: 4h. Safety timer : 72h Thermal protection. Charging of wrong lower voltage battery pack (e.g. 6V) will be
limited to 1.6A (0.25A small battery) and terminated after 30 min. Charging battery > 16.2V terminated immediately.
Temperature range:
Operating: ÷25 to +40oC.
Storage: ÷25 to +65oC
Safety:
EN 60335-2-29
www.mascot.com
sales@mascot.no
Insulation class
:
Class II
Main Office NORWAY Mascot UK
Mascot FRANCE
Mascot DE, BENELUX
Mascot DE, CH, AT
Mascot BALTIC, RUSSIA Mascot SWEDEN
Box 177
38
rue Leo Lagrange / 5300VDC
Bok 2090, Salisbury Hirschbergstr.
28/7 – secondary:
Tettnanger Str. 52
Taevakivi 15
Box 177
Insulation voltage:
Primary
3750VAC
N-1601 Fredrikstad
F-94270 Le Kremlin Bicêtre 13619 Tallinn, Estonia
Wiltshire SP2 2BH
D-74838 Limbach
D-88239 Wangen
N-1601 Fredrikstad
+ 47 69 36 43 00
+33 146 587 185
+44 172 250 4853
+49
628 795
140
+49and
752 895 –2,
1677
+372 555 21 121
+46 526 14025
EMC standards:
EN
55014-1
Input terminal:
Non detachable mains cable
Output terminals:
Cord with Insulated battery clips and temp. sensor
IP-Grade:65
Dimensions:
169 x 95 x 47 mm
Weight:900g
9
www.mascot.com
Main Office NORWAY
Box 177
N-1601 Fredrikstad
+ 47 69 36 43 00
10
sales@mascot.no
Mascot UK
Bok 2090, Salisbury
Wiltshire SP2 2BH
+44 172 250 4853
Mascot DE, BENELUX
Hirschbergstr. 28/7
D-74838 Limbach
+49 628 795 140
Mascot DE, CH, AT
Tettnanger Str. 52
D-88239 Wangen
+49 752 895 1677
Mascot FRANCE
38 rue Leo Lagrange
F-94270 Le Kremlin Bicêtre
+33 146 587 185
Mascot BALTIC, RUSSIA
Taevakivi 15
13619 Tallinn, Estonia
+372 555 21 121
Mascot SWEDEN
Box 177
N-1601 Fredrikstad
+46 526 14025
11
QUICK START
Smart charger
1
Match
2
Connect
12V
Check that the battery and charger specifications match.
To charge a vehicle battery, connect first the positive clip (marked “+”) to the positive
battery pole, then connect the other clip (marked “-“) to the car’s chassis away from
the battery and fuel system (fuel hoses, fuel pump etc.). Place the temperature sensor
on top of or close to the battery.
Positive clip
Temperature sensor
Negative clip
NEGATIVE CLIP
Check car user
manual for where
to connect.
R
Charge
Connect the charger to the mains.
R
GEL
3
R
Check status/mode
Charger will start automatically.
Check indication lights for status.
Use mode button to select preferred mode.
GEL
4
GEL
230V
MODE
www.mascot.no
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising