R58 Towel Rails Installation Instruction 1-2 Tools required mm Installation instruction - Review instructions carefully before installation - Installation should be completed by a suitably qualified person - Please dispose of packaging in a responsible manner 1X 1 6X M5x6 6X ST4.2X40 8X 3 3a D1 3b mm D2 2 3c 2-2 4 5 4a OFF ON Operation and maintenance instruction After installation, connect the electric power and turn on the switch. The indicator light will show red and the towel warmer will start to work. Turn off the switch when the towel warmer is not in use. The indicator light will turn dark and the towel warmer will stop working. Clean the towel warmer with a soft dry towel. This unit has been designed to run continuously. Warning: 1.Please do NOT connect the wire with power grid before completely read and understand the product manual. 2.This product is intended only for domestic use and do NOT put the product into the water or in sauna room, shower cubicle and steam room. 3. This product is only for textile fabrics that washed by water. 4.In order to avoid a hazard for infant or child, this appliance should be installed at the place that is at least 100cm above the floor. 5.If any damage on the wire, which must be changed by manufacturer or service agent or the similar qualified people in case shock hazard. 6.The surface temperature is high when towel warmer works, PLEASE BE CAREFUL ! 7.For safety, please do NOT sit, stand, lean against ,hang on the product or collide in avoid off any damage or collision on the surface of product and influence the function or life of product. 8.Any one who with defects in body, organ or mentality, and inexperienced people must use this appliance under the supervision or guide of professional people or qualified. 9.If any quality problem when the product works, please shut the power right away and post it to the manufacturer or service center,DO NOT DISASSEMBLE IT SELF IN CASE SHOCK HAZARD. 10.Please DO ensure that your hand is dry when unplugging the cord.