aftermarket radio - CRUX Interfacing Solutions

aftermarket radio - CRUX Interfacing Solutions
Rev. 050915
RADIO REPLACEMENT W/SWC RETENTION FOR SELECT AUDI VEHICLES 2001-2010
SWRAD-55
AUDI
2002 - 2010 A3
2001 - 2009 A4
2008 - 2010 A5
2002 - 2004 A6
2004 - 2009 S4
2009 - 2010 Q5
2002 - 2010 TT
IMPORTANT NOTES:
See “Using The RCA Connections” section for
those vehicles with Bose and Factory amps.
work. Following these instructions from “Start” to” Finish” will ensure
9:00 AM – 5:00PM PDT at 1 (855) 822-1348. We are here to help.
OVERVIEW OF INSTALLATION
CONNECT THE WIRES,
COLOR FOR COLOR.
MATCH LOOSE WIRES TO AFTERMARKET RADIO
Front Left RCA
PARTS INCLUDED:
Front Right RCA
(1) Interface Module
(2) Audi Harness
(1) Instruction Sheet
Rear Left RCA
AFTERMARKET
RADIO
PRECAUTIONS:
- Remove the negative side of the battery to avoid any short circuits
durring the installation.
- Do not install the interface near any major components or near the
HVAC system. This may cause damage or overheating to the vehicle.
Rear Right RCA
front left speakers
front right speakers
rear left speakers
rear right speakers
constant
accessory
ground
illumination
antenna turn on
reverse
vss
sub amp on
PRELIMINARY:
Please read the entire mannual before installing this interface.
Before installing this interface please review the options before
removing the factory radio. Some options may need to be adjusted
prior to removing the factory radio.
USING THE SWC WIRE ON NEW JVC UNITS
New JVC units no longer carry the 3.5mm cable and have
added the SWC signal via a Lt. Blue/Yellow wire.
This wire needs to be connected to the SWC wire labeled
“Kenwood” also Lt. Blue/Yellow.
WIRING COLOR CODES
Black
Red
Yellow
Orange
Blue
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Purple/White
Blue/Yellow
Red/White
White RCA
Gray RCA
Green RCA
Purple RCA
= Ground
= Accessory (2A Max)
= Constant
= Illumination (100mA Max)
= Left Front (+)
= Left Front (-)
= Right Front (+)
= Right Front (-)
= Left Rear (+)
= Left Rear (-)
= Right Rear (+)
= Right Rear (-)
= VSS
= SWC KEN/New JVC/Blaupunkt
= Reverse (100mA Max)
= Left Front Speakers
= Right Front Speakers
= Left Rear Speakers
= Right Rear Speaker
USING THE RCA CONNECTORS
- For Non-Bose system:
Connect the 8 speaker wires. No RCA connection needed.
Connect the front channel speaker wires only.
Then connect the rear RCA connectors.
- For Bose system:
Connect all 4 (front and rear) RCA connectors only.
No speaker wire connections needed.
Notes: For Bose and Rear Factory Sub, connect the Blue wire.
OPTION B
OPTION A
3.5mm CONNECTOR
ON
12-PIN
4-PI N
1
2
3
44-PIN
(male plug)
The module allows for both type of SWC connections.
Option A is used for the Alpine, Clarion, JVC, and Kenwood
units. And Option B is used for the Pioneer, and Sony units.
Select the proper harness type for your aftermarket radio and
connect the 4-pin molex to its proper connection.
12-PIN
4-PIN
20-PIN
(male plug)
For Audi A2, A3, A4 and A6 (up till 01/05) they must use the
following pins on the Female Mini-ISO connector.
CAN-HI = Pin 7, CAN-LOW = Pin 12
8-PIN
(male plug)
7
TO FACTORY
HARNESS
12
8-PIN
(male plug)
SETTING THE RADIO TYPE
USING A RELAY
This step is only needed if the vehicle has steering wheel controls
and you are installing one of the listed radios. With the ignition key
The module has been rated for upto 2A max of output.
For applications demanding a continuous output of 3A or more,
we reccomend using a standard BOSCH (SPDT) relay.
See your local car audio specialist.
Below is a diagram on how to install the BOSCH relay.
functions.
DIP: 1
2
3
RADIO TYPE:
Pioneer/ Sony/ Jensen
OFF ON ON
Alpine
OFF OFF OFF
Clarion
ON ON OFF
Kenwood
ON ON ON
JVC
ON OFF ON
Blaupunkt
ON OFF OFF
FUSE
CAR 12V CONSTANT
ON
87
1
2
INSTALLATION TIPS
1. Test the radio for power, turn the key to the “ON” position and
revise your wiring connections with multi-meter, avialable at your
local car audio dealer.
3
CHASSIS
GROUND
86
87a
85
TO ACC 12V
30
NEW ACC 12C (HIGH CURRENT
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising