Cart Assembly - Webstaurant Store

Cart Assembly - Webstaurant Store
ASSEMBLY INSTRUCTIONS FOR TRANSPORT CART
Tools Requirements: Rubber Mallet; cushioned assembly surface
With just a rubber mallet and 15 minutes, your
new Transport Cart assembles quickly and easily.
Posts
Top
1.) Using either Side (2 long
curved Panels) determine
top orientation as shown in
illustration (1)
1
Locking Tabs
CC2036
2.) Locate the Middle Shelf (shelf with 4 slots – 2 on either
end). Align slots on shelf with inside ribs on back of Side
Panel above the middle cross brace as shown (2a). Pressing
the Middle Shelf into the back of the Side Panel, hammer the
Middle Shelf into place. When complete, the 2 large tabs on
the end of the Middle Shelf should extend through the 2
corresponding slots on the Side Panel as shown (2b).
2a
2b
3.) Stand up Shelf and Panel assembly. Align the 2 remaining exposed
tabs on the end of the Shelf with the two slots on the opposite Side
Panel. While pressing the Shelf into the Panel, hammer Shelf into place
as in step two (3). Please note that the Middle Shelf has a retaining lip
along its back edge. Make sure to align the corresponding lips on the
other two shelves with this one as you attach them in Steps 4 and 6.
P.O. Box 53006
Oklahoma City, Oklahoma 73152-3006
(405) 475-5600 • FAX (405) 475-5607
1-800-654-8210
www.carlislefsp.com
European Distribution Center:
Edisonstraat 84, P.O. Box 110
6900 AC Zevenaar, The Netherlands
Tel +31/(0)316-596550 • Telex 45642
FAX +31/(0)316-340168
#104803330
3
4.) Align Top Shelf (Shelf with Handles) with the four corner posts on top of the Side
Panels as shown (4a). Check to ensure that the retaining lip on this Shelf is on the
same side of the cart as the lip on the Middle Shelf. Making sure that each socket on
the underside of the Shelf remains lined-up with the corresponding post, hammer the
Top Shelf in place as shown (4b) until Shelf is fully seated on the Side Panels.
4a
4b
5.) Turn cart on end. Align the
tabs on the End-Cap (strip with
logo) with the corresponding
slots on the center of the Side
Panel as shown (5a). Starting
in the middle and moving in
one direction, hammer each
tab into the Side Panel as
shown (5b) until the End-Cap
is flush with the Side Panel.
Turn Cart over and repeat with
other side.
5a
5b
6.) Turn cart upside down. Align
Bottom Shelf with the four corner
posts on the bottom of the Side
Panels as shown (6a). Check to
ensure that the retaining lip on this
Shelf is on the same side of the
cart as the lip on the other two
Shelves. Making sure that each
socket on the underside of the
Shelf remains lined-up with the
corresponding post, hammer the
Bottom Shelf in place as shown
(6b) until Shelf is fully seated on
the Side Panels.
6a
7.) Insert White Caster Sleeves
into the sockets (7) on each of the
four corners of the Bottom Shelf.
Gently tap each Sleeve into the
Shelf until the rim on the Sleeve is
flush with the top of the Socket.
7
6b
8.) Insert a Caster into each Sleeve. Carefully hammer each Caster until the Plate on the Caster sits flush with
the Rim on the Sleeve.
9.) Turn cart upright and hammer four exposed Locking Tabs on the inside of each Side Panel into Bottom Shelf.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising