Smart Standard Reader Installation Guide

Smart Standard Reader Installation Guide
smart_stndard_v1.2 Oct05
www.pac.co.uk
customer_services@pac.co.uk
T: +852 2638 1688, F: +852 2851 1688
Unit 310, Technology Park, 18 On Lai Street, Sha Tin, Hong Kong
T: +852 2638 1688, F: +852 2851 1688
Smart Standard Reader
Installation Guide
Reader Specifications
Smart Standard Reader Drilling Template
Blick House, Cambridge Commercial Park, 6 Trinity Close,
Paulshof, Sandton, South Africa
T: +27 11 8443200, F +27 11 8033117
1 Park Gate Close, Bredbury, Stockport, SK6 2SZ, England
T: +44 161 406 3400. F: +44 161 430 8658
PAC INTERNATIONAL LTD
A Stanley Security Solutions Business
20mm (0.79”) hole for wire entry
2 x 4 mm (0.08” x 0.16”) holes for mounting screws
Minimum outer dimension is 90 mm x 90 mm (3.54” x 3.54”)
so as not to interfere with any other components
120mA
Current Consumption (+/- 5%)
Normal
12Vdc
Power requirements
PAC proximity format
Reader Output
Activated
140mA
250m max
0.33mm cable
100m max
Cable distances
0.22mm cable
20 - 60mm (0.8” – 2.4”)(typically)
Read range
2
2
IP 67
IP rating
Charcoal
Colour
Controlled by access controller
Audible tone
Green/Red controlled by access controller
Status LED’s
90mm x 90mm x 20mm (3.54" x 3.54" 0.79")
Reader dimensions
90% max, operating non-condensing
Relative humidity
-10ºC to +55ºC (14ºF to 131ºF)
Operating temperature
Regulatory Information
CE Mark
The reader has passed all relevant tests and obtained CE approval.
C Tick
The reader has passed all relevant requirements for application of C Tick.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications to this product not expressly approved in this document could void the user's authority to operate this equipment.
Designed & Manufactured in Australia. Mifare is a registered trademark of Philips Electronics.
®
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising