user manual

user manual
MOBOT® Slim 1 & 2, Sport
Electric Scooter
USER MANUAL
PLEASE CAREFULLY READ THE USER MANUAL AND
WARRANTY BOOK BEFORE USING
MOBOT® Slim
WARNING
Whenever you ride the MOBOT® Slim electric scooter you might
risk having serious injury from collisions, falls or loss of control.
To ride safely, YOU MUST READ AND FOLLOW ALL
INSTRUCTIONS AND WARNINGS STATED IN THIS MANUAL.
This manual includes basic operational instructions for the
MOBOT® Slim electric scooter. It does not cover any situations
where injury or death may occur.
OPERATORS MUST USE GOOD JUDGMENT AND COMMON
SENSE TO DETECT AND AVOID HAZARDS AND DANGERS that
they may encounter when riding the MOBOT® Slim electric
scooter. By using the MOBOT® Slim electric scooter, it deems
that you accept the inherent risks of operating this product.
2
CONTENTS
MAIN PARTS
4
SAFETY
5
PRODUCTS / FOLDING STAGE
6
Folding stages
6
Folding steps
7
Unfolding steps
8
OPERATION
9
Introduction of Handlebar parts
9
Operation Instruction
9
Display Factory settings
11
RIDING OPERATION
12
Ready
12
Start
12
Brake
12
BATTERY AND CHARGER
13
Battery
13
Charger
13
Change Description
13
MAINTENANCE
14
Lubricating
14
Battery
14
Placement and daily care
14
GENERAL TROUBLESHOOTING
14
PRODUCT SPECIFICATION SHEET
15
QUALITY ASSURANCE
16
3
4
SAFETY
1.
The product is recommended for adults (18 years old and above) and is not
suitable for minors age (below 12 years old). Please do not load two
passengers at the same time.
2.
Please wear your safety helmet and other protective equipment when
riding.
3.
Do not ride in traffic lane or unsafe roads that is breaking the local traffic
rules and regulations.
4.
Please exercise in wide areas, and ride after skilled manipulation.
5.
Do not attempt any dangerous actions like riding single-handedly.
6.
Always keep your feet on the scooter platform.
7.
Do not attempt to ride the scooter on stairs that are above 3 cm. It may
result in vehicle overturn, causing injuries and/or damages to the rider
and/or scooter.
8.
The maximum speed limit for MOBOT ® Slim 1 is 27 Km/h. For your safety,
please maintain the riding speed at 20 Km/h.
9.
When travelling at night, please limit the speed within 15 Km/h or less and
turn on the headlights.
10. For safety reasons, do not ride the scooter in bad weather conditions such
as heavy downpours and high winds.
11. Do not use the scooter when outdoor temperature is lower than 0ºC.
12. Please slow down or avoid using the scooter when riding in poor road
conditions such as oily or slippery road surfaces.
13. Please adjust the handlebar according to your height to ensure a safe and
comfortable riding.
14. To avoid damages to the electrical parts of the vehicle, do not immerse the
scooter in water with depth of more than 4 cm. Do not wash it with
pressurized water.
5
6
7
8
OPERATION
1. Introduction of Handlebar parts
9
7
4
3
2
1
8
8
6
5
1. Thumb Accelerator
2. Thumb Electronic Magnetic Brake
3. Switch Button
4. Setting Button
5. On/Off Light Button
6. Horn Button
7. LED Headlight
8. Handlebar Fold Button
9. Display Panel
2. Operating Instructions
a. ON/OFF
Press the switch for 1 sec until the display is shown in the panel indicating that
the power is on. Alternatively, press and hold for 3 seconds to turn off the
engine. Upon idle, it will be turned off after 3 minutes.
b. Speed control
Press the right thumb accelerator to control the speed (1-30km/h).
9
c. Braking Control
Press the left thumb to operate the electronic magnetic brake. The greater
amount of pressure is input, the greater braking force it will be.
d. Horn
Press the horn button to produce a hoot sound.
e. LED Headlight
In manual mode: Press the On/Off Light button when needed and there will be a
sign-in-display indicating that the light is turned on. Press the button again to
turn off the light.
The scooter is equiped with a sensor light that detects the need for lighting. The
headlight will turn on automatically (auto light mode) if the sensor detects poor
ambiental environment.
For example: If it is a cloudy weather and the auto light mode is on, the
headlight would turn on. If the daylight is proper, the auto light mode will detects
the surrounding light and the headlights will go off after 5 seconds.
The mode can be switch in between auto and manual by pushing on the On/Off
Light button.
f. Mileage Show
When the display is powered on, It displays two modes: speed and distance
travelled. You can change the settings button. In 'trip' mode, press the setting
button (S) for 3 seconds and it will clear the trip records.
g. Emergency
In emergency, it’s recommended to use the foot brake, but please do not use
the emergency brake at high speed to avoid wheel damage. In this case, the
company will not be responsible for this damage.
10
3. Display Factory Setting
To access the menu P0 and P1 please press the switch and setting buttons at
the same time. Pressing the setting button helps you switch between P0 and P1.
Both menus have other two submenus : 0 and 1, as follows:
P00 (a) – displays the speed in km/h and temperature in Celsius degrees
P01 (b) – displays the speed in mile/h and the temperature in Farenheit degrees
P10 (c) – lights are set on manual mode
P11 (d) – lights are set on auto mode
You can switch between menus 0 and 1 in P0 or P1 by pressing the on/off
button.
Press the setting button (S) at last to finalise the settings.
a)
b)
c)
d)
11
10
11
10 – Light sensor
11 – Speed
12 – Battery
13
12
13 – Temperature
14 – Displays the total and trip distance
14
15 - From left to right: total, trip
15
RIDING OPERATION
Ready
1. Choose a suitable venue for riding.
2. Expand the scooter in accordance with the description.
3. Adjust the T-pipe to the suitable length according to your height.
Start
1. Press the power button to turn on the power.
2. Stand one foot on the scooter and leave another foot on the ground.
3. Gently press down on the right thumb accelerator, the scooter will
immediately move forward. Place the foot which is on the ground on the
scooter. Control the speed of the scooter with the amount of pressure you
input with the right thumb accelerator.
Brake
1. Under normal circumstances, pressing the left thumb electronic magnetic
brake, the scooter will be immediately de-energized and come to a brake
stop. T––he greater pressure you input, the greater braking force it will be.
2. In emergency, it’s recommended to use the foot brake, but please do not use
the emergency brake at high speed to avoid wheel damage.
12
BATTERY AND CHARGER
Each MOBOT® Slim electric scooter is equipped with a special lithium polymer
battery and special smart charger. These accessories that come with each
scooter have a dedicated number, do not use the chargers from other brands.
Damages caused by using inappropriate battery chargers is not under usual
product warranty.
Battery
When you get the MOBOT® Slim electric scooter for the first time, please
charge the battery fully before using.
Please charge the battery once every three months if not using the scooter for
long.
Please charge the scooter for at least 6 hours when newly purchased.
Water immersion, collisions, and other abnormal factors will lead to battery
damage, which is not covered under warranty.
Charger
The company provides dedicated charger which has a charging protection
function, when the battery is 100% charged, the charger will automatically stop
charging. Charging time is no more than 3 hours.
Water immersion, collisions, and other abnormal factors will lead to charger
damage, which is not covered under warranty.
Charge Description
Open the charging hole under the rubber protective cover and plug in the
charger connector.
Connect the charger plug into the power socket.
The charger light turns red when charging is in progress. Charger light turns
green when battery is fully charged.
13
MAINTENANCE
Lubricating
Please add small amount of grease or lubricant to scooter parts, ecspecially the
handle area every six months.
Please check scooter every three months for loosen screws.
Battery
The lithium polymer batteries provided can be recharged at least 500 times.
Under proper usage, it can reach more than 1,000 times.
Placement and daily care
Do not expose the scooter under the sun or wet places for too long time. Please
keep the scooter clean and dry.
GENERAL TROUBLESHOOTING
Checklist
When the products have any problems, please refer to the following solutions.
1. LED display black screen
Reason: Exposure under the sun for too long.
Solution: Place it in shadow and it will return to normal function after a
period.
2. Values from the display do not fit the actual values.
Reason: Parameters are set incorrectly or missing.
Solution: Please reset the display to the factory settings.
3. No information on digital display
Reason: Bad battery contacts or the battery is dead.
Solution: Turn off the power then restart again. If the problem still occurs,
please contact your local reseller.In case that the product still does not
operate normally, please contact your local vendor.
14
PRODUCT SPECIFICATION SHEET
Item
MOBOT Slim 1 & 2
Overall Expand Size
940*1160*135mm
Overall Fold Size
940*330*150mm
Scooter Weight
10.5KG/10.7KG
Maximum load
110KG
Top Speed
27km/h/30km/h
Grade Ability
15/20 degree slope
Specifications
Capability
25km/30km(varied from weight, wind
speed, road conditions, temperature
Single Life
and other factors)
Battery
parameters
Standard Voltage
24V
Battery Type
Li-po Lithium Battery
Battery Capacity
6.5AH / 8.5AH
Motor type
Brushless DC Motor
Rated Output Power
250W
Maximum Rotational
Motor parameters
Speed
Rated voltage
800r/min
24V
Maximum output
torque
13.3Nm
Charger
Output Voltage
110V/220V
parameters
Charging time
2-3h
15
PRODUCT WARRANTY
In normal use, if a part or parts of the electric scooters have any problems listed
in the following form during the warranty period, please contact your local
vendor or reseller, we will provide a complete service as specified in the
warranty book.
Item
Motor
Quality problems
Under normal circumstances the motor
can not be used
Warranty
period
One year
Controller
Failures under normal use
One year
Charger
Failures under normal use
One year
Lithium Battery
UBHI
(uniblock human
interface-display)
Body structure
Under normal circumstances can not
be charged and discharged
One year
Can not be used under natural
conditions (Excluding the impact
Six month
forces and external damages)
Failures under normal use, such as
deformations and fractures
One year
Service item
Free
maintenance
Free
maintenance
Free
maintenance
Free
maintenance
Free
maintenance
Free
maintenance
Note: Please follow the correct way to use this product, the company will not be responsible
for parts damaged and other damages caused by misusing.
16
MOBOT Slim set-up instructions
(1) How to set Auto-Pilot function (Cruise Control)
FULLY Press the brake button and hold, power on, and then press the Accelerator button for 2 times.
(2) How to set Kick Start function
FULLY Press the brake button and hold, power on, and then press the Accelerator button for 3 times.
(3) How to set Speed Limit
FULLY Press the brake button and hold, power on, and then press the Accelerator button for xx times.
Cancel speed-limit 4times
Set speed 12km/h 8times
Set speed 20km/h 6times
Set speed 25km/h 5times.
17
MOBOT Slim
如何调整自动巡航模式:
在电源关闭的情况下,按住刹车键,开机,然后快速按动加速键2次。
零启动模式:一按加速按钮,车轮就开始转动
非零零启动模式:按加速按钮时,车轮不会转动;必须要滑行起来,然后再按加速钮才可驱动
如何取消零启动模式:
在电源关闭的情况下,按住刹车键,开机,然后快速按动加速键3次。
如何取消限速:
在电源关闭的情况下,按住刹车键,开机,然后快速按动加速键4次。
如何设置限速:
限速12公里/小时,按8次;限速20公里/小时,按6次;限速25公里/小时,按5次。
18
PRODUCT WARRANTY
In warranty period, if the malfunction and damage caused by the following
reasons, it will not be within the scope of product warranty:
1. Inappropriate maintenance and repair that are not in accordance with the
instruction manual.
2. Use of the electric scooter for other purposes such as performing
dangerous acts which result in damages or functional failures.
3. Using any of the external factory components.
4. Disassembling the scooter without contacting the local reseller.
5. Wrongly usage causing traffic accidents or accidental collision damage to
the product body and the parts.
6. Product wear and tear.
IZEST PTE LTD
62 UBI ROAD 1, #03-19 OXLEY BIZHUB 2, Singapore 408734
Tel: (+65) 65382816
www.MOBOT.sg
19
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising