Sanitizing Spray Bottle User`s Guide (SB100)

Sanitizing Spray Bottle User`s Guide (SB100)
S2454-05 SB100 – Industrial Sanitizing Spray Bottle User's Guide
Sanitizing Spray Bottle User’s Guide (SB100)
INTRODUCTION
The Sanitizing Spray Bottle (SB100) turns common drinking water into
dissolved ozone, a water-based, chemical-free, ‘green’ alternative to harsh
chemical sanitizers and deodorizers. The tiny electrolytic cell, based on the
proprietary Active Diamond Electrolytic Process Technology (ADEPT™),
runs on batteries and creates dissolved ozone on demand from the water
itself. Use this product to sanitize hard, non-porous surfaces throughout a
facility.
Water-Based, Cost-Effective Sanitizer
v Proven sanitizer generated from water
v Kills common bacteria and viruses
v Destroys odor-causing bacteria
Chemical Free & Heat Free
v Dissolved ozone is produced when the
water passes the electrolytic cell
v Leaves no residue
v Reverts to oxygen and water
v Ozone is a proven sanitizer and is ‘generally
recognized as safe’ (GRAS) by the FDA and
approved for use on organic foods
Easy to Use
v Spray, wait and wipe (or just air dry)
v No need to check the concentration or
temperature every few hours
v User-friendly indicator lights indicate the sanitizer is active
v Runs on long-lasting rechargeable batteries
Active Ingredient is Ready On Demand
v No waiting or wondering about sanitizer strength
v No capital equipment, no complicated accessories
v No chemicals to inventory
Product may vary from illustration. EOI and ADEPT are trademarks of Electrolytic Ozone, Inc. All Rights Reserved © 2012
Electrolytic Ozone, Inc. | eoi-oxygen.com | 978.203.0217
CARE AND CAUTION
The SB100-Industrial is intended for commercial and industrial use. It is
designed for safe operation when used as directed. The following general
safety precautions provide guidance for safe use. Failure to comply with the
safety precautions or warnings indicated in this manual violates the safety
standards of this equipment. The manufacturer assumes no liability for the
user’s failure to comply with these requirements.
Read manual before use.
Fill with clean, potable water only. Do not overfill.
Clean exterior of unit with soft cloth. Do not use harsh or abrasive
cleaners.
Product is intended for industrial use. It is a violation of federal law
to use this product in a manner inconsistent with its labeling.
Do not remove warning labels from unit. Do not open sealed
components.
To protect from electric shock, do not immerse unit, cord or plug in
water. To avoid shock, do not use if cord or unit is damaged.
Charge unit only with supplied power cord or other authorized
accessories or parts.
Use only in properly ventilated area in conformance to all local and
national regulations. If overly strong odor of ozone is detected,
discontinue use. If respiratory irritation is experienced, discontinue
use immediately. Sensitive individuals with respiratory conditions
such as asthma or emphysema may experience a reaction to ozone
and should use this product with caution.
Keep out of reach of children.
Do not spray toward eyes or face. In case of eye exposure: rinse
affected eye(s) thoroughly with clean water for 5 to 10 minutes. If
irritation persists, seek medical attention.
Electrolytic Ozone, Inc. | eoi-oxygen.com | 978.203.0217
OPERATING INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE USE.
Charge the Unit.
Before using the sprayer for the first time, charge the batteries. The first charge
may take up to 8 hours. Connect the battery charger to a 100 to 240 V AC 50/60
Hz power source. Remove the cover on power port. Connect the battery
charger power cord to the spray bottle power port. The system is powered by a
7.2 V NiMH rechargeable battery pack. A 100 to 240 V AC 50/60 Hz charger is
included. Use only the charger provided.
The red light on the charger indicates that the device is being charged. The charge
is complete when the light is green. The device will not operate while connected
to the charger.
Replace the Cover on the Power Port.
When charging is complete, replace cover on spray bottle power port.
Fill the Reservoir with Potable Water Only, Do Not Overfill.
Open the fill cap on the reservoir and fill with clean, potable water to the fill line.
The fill line indicates the maximum level when in the upright position. Do not
over fill. Replace the fill cap.
Replace the Fill Cap to Protect Power Port from Moisture.
Ensure that water does not reach the battery power port. Always replace the
cover.
Spray, Wait and Wipe (or Air Dry) to Sanitize.
Hold the spray nozzle 6 to 8 inches from the surface and depress trigger. Spray
evenly until wet. (Pre-clean surface if necessary.) For 99.9% effectiveness, wait 30
seconds. For 99.999% effectiveness, wait 3 to 5 minutes. Wipe with a clean
microfiber or cotton cloth or allow to air dry.
Dissolved Ozone is Generated on Demand.
Unlike chemicals that lose their efficacy with time even before use, dissolved
ozone is generated on demand. The blue indicator will light when the unit is
operating properly.
Electrolytic Ozone, Inc. | eoi-oxygen.com | 978.203.0217
INDICATORS
SYSTEM MESSAGE
SOLID BLUE
System is operating properly.
ONE RED FLASH
Battery is low.
TWO RED FLASHES
Reservoir is empty.
THREE RED FLASHES
Battery needs recharging.
TWO RED AND BLUE
FLASHES
System fault; recharge and try again. If error persists,
contact the manufacturer.
SPECIFICATIONS SB100-INDUSTRIAL
Weight (empty)
~ 2lb (0.9 kg)
Dimensions
4 in x 4 in x 10 in (10 cm x 10 cm x 25 cm)
Reservoir Capacity
~14 oz (~400 ml)
Water Temperature
40 °F to 86 °F (4 °C to 30 °C)
Water Quality
Clean, Potable Water Only
(Hardness ≤ 250 ppm CaCO3)
Rechargeable Battery
7.2 V NiMH (100 V AC to 240 V AC, 50/60 Hz)
Useful Battery Life
(typical)
5000 Reservoir Fills or 500 Charges
Regulatory Compliance
and Certifications
CE, TUV, RoHS, WEEE, USEPA Est. No. 089373-MA001, 2009 USFDA Food Code for Food Contact
Surfaces
SERVICE AND WARRANTY
This product includes a Limited Warranty. Pursuant to the language of the
Limited Warranty, the manufacturer warrants that this product is free of
defects in material and workmanship under normal use and subject to the
exclusions and limitations contained in the Limited Warranty, as well as the
terms and conditions. For service, contact the manufacturer (66K Concord
Street, Wilmington, MA 01887 or call 978-203-0217). When the unit no
longer functions, return it to the manufacturer for proper disposal.
Electrolytic Ozone, Inc. | eoi-oxygen.com | 978.203.0217
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising