Door Prep Template (No Holes)

Door Prep Template (No Holes)
FE575/FE595 Door Preparation Instructions
For Door With No Holes
Tools Needed
2¹⁄₈” Hole Saw
Drill Bits Needed:
¹⁄₈”, ⁷⁄₈”, 1”
Ta
Me pe
as
u
Pencil
Chisel
re
1
4
Measure Door Width
Mark and Drill Hole in Door Edge
If the door is thinner than 1³⁄₈” or thicker than 1³⁄₄”, then the lock will not
fit properly on the door.
FOR
OR
1³⁄₄” - 1³⁄₈”
a
b
c
d
¹⁄₂” Door
Width
Ta
Me pe
as
ure
Ta
Me pe
as
ure
2
Mark Lock Centerline on Door Face and Door Edge
Door Face
Door Edge
Ta
Me pe
as
u
re
⁷⁄₈” Drill Bit
OR
38” from finished floor
3
FOR
Mark and Drill Hole in Door Face with 2¹⁄₈” Hole Saw
a
b
a
b
c
d
¹⁄₂” Door
Width
2³⁄₈” or 2³⁄₄”
Ta
Me pe
as
ure
Ta
Me p e
as
ure
c
d
2¹⁄₈” Hole Saw
1” Drill Bit
5
If Necessary, Mortise for Latch
a.
b.
c.
d.
Insert latch into door edge hole.
Use pencil to trace latch and mark holes.
Remove latch and drill two ¹⁄₈” pilot holes.
Use chisel to create latch mortise.
7
Mark and Drills Holes for Strike
a.
b.
c.
d.
e.
f.
Measure 38” from finished floor and mark on door jamb.
Mark center for strike hole exactly opposite latch hole.
Drill 1” hole, ¹⁄₂” deep.
Line up strike with hole in door jamb.
Use pencil to trace strike and mark holes.
Drill two ¹⁄₈” pilot holes and use chisel to create strike mortise.
FOR
OR
Door Jamb
Latch Hole
b
a
38” From
Floor
¹⁄₈” Drill Bit
Ta
Me pe
as
ure
c
6
d
1” Drill Bit
Measure Door Jamb for Strike
Ta
Me pe
as
ure
Door Jamb
e
f
¹⁄₈” Drill Bit
38” from Floor
© Allegion 2014
Printed in U.S.A.
FE575/595 DP no holes
Rev. 11/14-online
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising