AT-PSP-001 PoE Surge Protector Quick Installation Guide

AT-PSP-001 PoE Surge Protector Quick Installation Guide
AT-PSP-001 PoE Surge Protector
Quick Installation Guide
INTRODUCTION
Model
AT-PSP-001
Description
10/100/1000BaseT surge protector agasint lightning or transcient voltage
PACKAGE CONTENTS
* 1x surge protector
* 1x Quick Installation Guide
IMPORTANT:
1. Use CAT5e or CAT6 UTP/STP cables.
2. The cabling distance between the surge protector and the protected device should be less than 1 meter.
CONNECTION
PoE Switch
< 1 meter
PoE Out
#2
PoE In
Ground screw
PoE In
#1
* Make sure the grouning
resistance is lower than
0.5Ω.
LED
PoE Out
< 1 meter
LEDs
LED definitions:
OFF when operating normally, ON when out of service life.
All specifications are subject to change without noice.
Copyright © 2016 VIVOTEK INC. All rights reserved.
VIVOTEK INC.
6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.
|T: +886-2-82455282| F: +886-2-82455532| E: sales@vivotek.com
VIVOTEK USA, INC.
VIVOTEK Europe
2050 Ringwood Avenue, San Jose, CA 95131
Randstad 22-133, 1316BW Almere, The Netherlands
|T: 408-773-8686| F: 408-773-8298| E: salesusa@vivotek.com
T: +31(0)36-5298-434 E: saleseurope@vivotek.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising