24 hour programmable timer - cts 24
INSTALLATION / OPERATION INSTRUCTIONS
24 HOUR PROGRAMMABLE TIMER - CTS 24
SAFETY
The equipment must be installed, and maintained by competent personnel in accordance with the appropriate statutory
regulations and codes of practice e.g. the current ELECTRICITY AT WORK REGULATIONS, BRITISH STANDARD
REQUIREMENTS FOR ELECTRICAL INSTALLATIONS, etc.
Power sources must be electrically isolated, locked off and labelled during installation and maintenance.
t is the responsibility of the installer to ensure that all electrical connections are tight and that satisfactory earthing has
been achieved.
These installation instructions must be handed io the end user.
GENERAL
Function
Permits the opening and closing of the relay/timer contacts throughout a realen range 15 minutes to 24 hours.
Identification
Legend:
Installation procedure
1 - Selection (O Auto I ON
2 - Programme increments in minimum |
steps of 15 minutes. pr 4 |
3 - Index. |
L 1
о ©
NO | OTE
| С
NL
CONTROL
To set the time: = [71
1 - Turn the scale in the direction of the O 20h30 I >.
arrow to the time required on the dial. 20
Commutation position: (2) AUTO
2 - Mauto
m ON. | on
| Programme setting: :
3 - "ON" range contacts closed - slide © ON y OFF
segment to left as required. 0
"OFF" range contacts open - slide 19100 - 20h00 “, + «= ON
segment to right as required. 196 ——
у y OFF
15mn J ||
(c) 1994 SQUARE D - UNITED KINGDOM
| SQUARE D
A016.40.47420 Ed | Di
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising