4 Hour Charger – Model No. C003
4 Hour Charger – Model No. C003
Owner’s Manual
Thank you for purchasing the Slim Travel plug-in Charger. Please read
this manual carefully. It contains important operating instructions. This
Slim Travel plug-in Charger will quickly and efficiently charge all AA or
AAA Nickel Metal-Hydride (Ni-MH) batteries. The built-in high efficiency
“switching” type power supply will adjust automatically to any voltage from
100-240VAC, for international use.
Warning:
Batteries are not pre-charged. You need to charge them before use.
Charge only Ni-MH type batteries on this charger.
Batteries may leak or explode causing personal injury if inserted
improperly, disposed of in fire, mixed with other battery types, or made
to short circuit.
Features :
Recharge 2 or 4 pieces of AA or AAA Ni-MH batteries at a time.
Built-in switching power technology for worldwide (100-240V AC)
use
Microprocessor Controlled – Battery life is protected by a negative
delta V cut-off function plus timer protection.
Automatic charging current selection for AA & AAA batteries.
Equipped with 2 LED lamps to indicate charging mode:
Flashing Red LED – Quick charge ;
Red LED light on – Trickle charge (after full charge) ;
LED goes Off – Cells are not suitable for charging (Bad cell
detection).
Smart channels protect against wrong polarity
Charging Instructions
1.
Insert 2 or 4 pieces of AA/AAA rechargeable Ni-MH batteries into
the battery compartment. Charging must be in pairs. For charging
only 2 cells, insert the batteries to the left or right side of the
charging terminal (Fig. 1) & (Fig.2)
i.
2.
Make correct contact for polarity ( + and - ) ; according to the sign in
the battery compartment.
3.
Charge either AA or AAA size at a time. Do not charge AA and AAA
at the same time.
4.
Plug the charger into any available 100-240VAC socket. The
built-in switching power supply will adjust automatically. When
using overseas, a proper plug adaptor may be required (not
supplied). The Red LED will glow and flash when the batteries are
receiving charge.
5.
After charging is completed, the Red LED will stop flashing and
stay on to indicate that the charge is completed and batteries are
ready for use. Once the Red LED light stays on, the charger
switches to “trickle” mode to keep the batteries at full.
6.
Once charging is completed, remove batteries and unplug charger
as soon as it is practical. Do not leave batteries in the charger for
extended periods of time (more than 2 days) OR when the charger
is not plugged in. Unplug the charger when not in use.
7.
Begin again at Step-1 to charge the next set of batteries.
Safety Features :
Negative delta V cut -off function
Safety timer to prevent over-charge
Short circuit protection
Reverse-polarity protection
Bad cell Detection
Bad Cell Detection :
When charge process is started, the charger detects the health status of
each of the cells in the battery compartment. If any batteries are
unsuitable for charging. i.e. short circuit or reversed polarity, the status
LED will NOT light on and off. The damage cell(s) should be properly
disposed of.
Specifications :
Power supply :
100-240VAC, 50/60Hz
International Compatible
AA 600mA
AAA 350mA
Charge rate :
Charging Time :
SIZE
mAh
CHARGE TIME
AA
AA
AAA
AAA
1300
2700
700
1000
2 hrs
4 hrs
2 hrs
3 hrs
**Charge time will vary depending upon the brand, capacity and condition of
batteries being charged.
Important Safety Instructions
1.
Before charging, read instructions.
2.
This charger is intended for use with Nickel-metal-hydride
rechargeable batteries only. Attempting to charge other types of
batteries may cause personal injury and damage to the charger.
3.
Do not expose charger to rain or moisture. For indoor use only.
4.
Remove from mains when not in use.
5.
Never use an extension cord or any attachment not recommended
by the manufacturer, otherwise this may result in a risk of fire,
electric shock or personal injury.
6.
Do not operate the charger if it has been subjected to shock or
damage. Take it to a qualified serviceman for repair.
7.
Do not disassemble the charger. Incorrect reassembly may result
in a risk of electric shock or fire.
8.
Unplug the charger before attempting any cleaning. Use a damp
cloth to clean the surface, do not immerse into water.
9.
Before scrapping your charger, remove the batteries from the unit
and ensure they are disposed of safely.
10.
The appliance is not intended for use by young children or infirm
persons without supervision.
Young children should be
supervised to ensure that they do not play with the appliance.
11.
This power unit is intended to be used in a vertical or floor mount
position.
12.
(For charger with US direct plug only) For connection to a supply
not in the U.S.A., use an attachment plug adapter of the proper
configuration for the power outlet.
Correct Disposal of this product
This marking indicates that this product
should not be disposed of with other
household wastes throughout the EU. To
prevent possible harm to the environment
or human health from uncontrolled waste
disposal, recycle it responsibly to promote
the sustainable reuse of material
resources. To return your used device,
please use the return and collection
systems or contact the retailer where the
product was purchased. They can take this
product for environmental safe recycling.
Directive 2002/96/EC
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising