Duty cycle Performance Resolution Speed Paper handling

Duty cycle Performance Resolution Speed Paper handling
Duty cycle
Speed
Controller components
Interface requirements
Targeted impressions per month on the Xerox
DocuPrint 100/115/135/155/180 EPS:
The speed at which data can be printed on the Xerox
DocuPrint 100/115/135/155/180 EPS:
• Processor (system unit):
One or more of the following network communications
systems may be used to transport documents from a
client or host to the printing system.
Printing system
Minimum
Maximum
DP100
800 thousand
3 million
DP115
1 million
DP135
1.2 million
–
One or two UltraSPARC central processing unit
(CPU) modules
Printing system
Pages per minute
(standard)
Pages per minute
(using 7 x 10 in. /
178 x 254 mm
paper) *
–
1 or 2 GB of memory (one or two 1-GB Dual In-line
Memory Modules, or DIMMs)
DP100
100
100
–
36 or 73 GB hard disk drive
–
High-density, read-only DVD-ROM drive
• Token ring LAN running TCP/IP, Novell 3.x, or
–
Diskette drive: uses 3.5 inch, 1.44 MB, double-sided,
high-density diskettes
* Requires additional equipment.
3.5 million
4 million
DP115
115
115
DP155
1.4 million
4.5 million
DP135
135
154
DP180
1.8 million
6 million
DP155
155
155
DP180
Note: Usage outside these ranges may vary the
service frequency.
Reliability performance of the Xerox DocuPrint 100/
115/135/155/180 EPS for the targeted impressions per
month:
Average
service
calls per
month
DP100
1
million
2.7
2
million
5.4
3
million
8.1
4
million
--
206
Note: Throughput rates can vary depending upon job
complexity and system configuration.
Performance
Average
monthly
print
volume
180
Average
service
calls per
month
DP115
2.6
5.2
7.8
--
Average
service
calls per
month
DP135
2.5
5.0
7.5
10.0
Average
service
calls per
month
DP155
2.6
5.2
7.8
10.4
Average
service
calls per
month
DP180
* Requires optional 7 by 10 inch enablement kit.
Paper handling
• Paper weights: 16 lbs. / 65 gsm bond to 110 lbs. /
200 gsm index cut-sheet weights
• Paper sizes:
–
8 x 10 in. / 203 x 254 mm to
14.33 x 17 in. / 364 by 432 mm, including A4 and A3
–
7 x 10 in. / 178 x 254 mm with optional 7 x 10 in.
enablement kit
2.4
4.8
7.2
9.6
5
million
--
--
--
--
12
6
million
--
--
--
--
14.4
Note: Variables other than monthly print volume affect
the average number of service calls. Please contact
your local Xerox representative for more information.
Input
–
Ethernet
–
1 or 2 Printer Controller Interface (PCI) boards
–
PGx64 or XVR-100 video graphics board
Note: This configuration may change due to the Xerox
policy of staying up to date with current technology.
Supported client workstations
Xerox DP 100/115/135/155/180 EPS supports the
following types of networked client workstations and
operating systems:
• Sun Workstation running Solaris 2.3 or higher
• PC running MS-DOS 5.0 or higher, using Ethernet
with TCP/IP or Novell NetWare, and Windows 95/
98, NT, Millennium, 2000, or XP
• PC running MS-DOS 5.0 or higher, with one or more
of the following TCP/IP packages:
80 gsm bond paper
• Auxiliary tray (Tray 2): 600 sheet capacity of 20
lbs. / 80 gsm bond paper
the length of the data interface cables that connects
them.
20 foot / 6.1 meters, or
–
Optional 50 foot / 15.2 meters
Power cable lengths are as follows:
Controller:
Printer:
8 feet / 2.4 m
15 feet / 4.6 m
• Cable length loss must be factored in if equipment is
installed in a raised-floor environment. Part of the
cable length is routed inside the equipment to
connect with interior power receptacles.
• All power cords attach to the back of the printer.
Listed below are the distances of the printer power
cord attachments from the left end of the printer as
you face it:
Pathway Access by Wollongong Group, Inc.
–
Cord #2: 23 inches / 584 mm (DP 155 & 180)
–
PC-NFS by Sun Select
PDL compatibility
AppleTalk through EtherTalk
The system interprets the following data formats:
•
•
•
•
•
•
•
•
•
–
–
• Output bin: Each output bin has a capacity of 2500
Refer to Helpful Facts About Paper to help in selection
of preprinted forms, perforated stock and labels.
• Data cable: The controller can be separated up to
Cord #1: 36 inches / 914 mm
• Any system that supports RFC-1179 lpr/lpd
DP 155 and 180: 600 by 2400 dots per inch (dpi)
DP 100, 115, and 135: 600 by 600 dots per inch (dpi)
Installation considerations
–
Output
• Sample tray: 100 sheets of 20 lbs. / 80 gsm bond
AppleTalk network protocol software*
PC/TCP Network Software by FTP Software, Inc.
• Apple Macintosh, System 7 or higher, using
Resolution
interface*
–
The Xerox DocuPrint 100/115/135/155/180 EPS may
have up to six input trays: two processor trays and two,
three, or four high-capacity feeder trays.
Two output bins are standard, with up to two
additional bins available as options.
NetWare network protocol software
• Online – Bus and tag supporting IBM 3211/4245
• Universal Serial Bus (USB) keyboard and mouse
• 17-inch flat panel monitor
• Main tray (Tray 1): 1100 sheet capacity of 20 lbs. /
sheets of 20 lbs. / 80 gsm bond with offset
capability.
• Ethernet LAN running TCP/IP, AppleTalk, or Novell
PostScript levels 2 and 3
PCL5e and PCL6
LCDS
ASCII
PDF
TIFF
VIPP
IPDS (currently not available)
Special considerations
• Transference of the black toner to poly-vinyl
surfaces is a common occurrence.
• When printing edge to edge, there is a 3 to 4.8 mm
border around the sheet where degraded image
quality may occur.
• Edge marking should be no closer than 4.8 mm from
the edge of the sheet.
• Xerox carbonless paper is approved for Xerox
DocuPrint 100/115/135/155/180 EPS. Refer to the
Xerox Supplies Catalog for the reorder numbers.
• Appearance of very small spots is a common
occurrence on all xerographic printers. Consult your
Xerox service representative for details on
acceptable spot occurrence specifications.
• In the U.S., call 1.800.822.2200 to order Xerox
Environmental requirements
Recommended
o
o
Operating
72 +/- 4 F
temperature 22o +/- 2o C
Humidity
Altitude
Minimum
o
50 F
10o C
45% +/- 10% RH 30% RH
supplies, including paper and other stocks.
Maximum
o
85 F
29o C
65% RH
Normal
Maximum
Up to 6,000 feet /
1,830 m above
sea level
9,000 feet /
2,743 m above
sea level
Heat dissipation
Standby
Running
Printer
4,454 BTU/hr.
(Fuser on)
2,700 BTU/hr.
(Energy saver)
155/180: 32,770
BTU/hr
100/115/135:
28,140 BTU/hr.
Processor and
monitor (Sun
BladeTM)
SB 1000/2000: 1,100 BTU/hr.
SB 2500: 1,570 BTU/hr.
Supplies
Reorder number
Space requirements
Expected yield
(Prints/carton)
Dry ink
US: 6R206
Europe: 6R90100
180,000
Dry ink waste
bottle
US: 93K460
Europe: 93K450
N/A
Developer
US: 5R161
Europe: 5R90095
1,000,000
Fuser agent
US: 8R2955
Europe: 8R90163
250,000
(1 bottle)
MICR dry ink
US: 6R819
180,000
MICR
developer
US: 5R573
600,000
Notes:
• Expected dry ink yield is based on a 7 percent area
Depth
Width
Height
Controller
The following data is accurate for the Sun BladeTM
1000/2000 and 2500 workstations, and is presented
as an example of typical space requirements for
workstations.
location with minimum clearance space of 36 inches
/ 91.4 cm around all sides of each piece of
equipment for access by service personnel.
• 50 inches / 127 cm clearance space is required in
front of the printer.
sight of the printer for safety purposes while the
equipment is being serviced.
• Customer must use the Xerox-supplied stand for all
controller components. Space requirements for the
controller stand are 36 by 36 inches / 91 by 91 cm.
30 in.
76.2 cm
38.25 in.
97.2 cm
Processor: Sun
BladeTM 1000/2000
19.3 in.
49 cm
8.2 in.
21 cm
17.75 in.
45.1 cm
level. On floors less than two degrees out of level, a
leveling kit must be used to level the equipment.
The printer will not function properly on floors more
than two degrees out of level.
Processor: Sun
BladeTM 2500
25 in.
63.5 cm
10 in.
25.4 cm
19 in.
46.3 cm
For additional space/configuration options, refer to the
Xerox DocuPrint 100/115/135/155/180 EPS
Installation Planning Guide.
Monitor
10 in.
25.4 cm
17 in.
43.2 cm
18.5 in.
47 cm
Printer
Space requirements (physical hardware and required
service area) for each of the printer configurations:
With inverter feeder/ 114 in.
stacker and 1 feeder/ 290 cm
stacker
223 in.
567 cm
With inverter feeder/ 114 in.
stacker and 2 feeder/ 290 cm
stackers
257 in.
652.8 cm
With inverter feeder/ 114 in.
stacker and 3 feeder/ 290 cm
stackers
288 in.
731 cm
With inverter feeder/ 114 in.
stacker, feeder/
290 cm
stacker, and bypass
transport module
242 in.
615 cm
With inverter feeder/ 114 in.
stacker and 2 feeder/ 290 cm
stackers, and bypass
transport
276 in.
701 cm
Xerox DocuPrint
100/115/135/155/180 EPS
• The controller must be positioned within the line of
35.5 in.
90.2 cm
Stand
• For proper operation, the printer must be perfectly
Customer Information
Quick Reference Card
Electrical requirements
Controller
(47-63 Hz)
Voltage
Printer
(60 Hz)
Cord #1
100-240 120/208
VAC
VAC; or
(1 phase) 120/240
VAC
(2 phase)
155/180
printer
(60 Hz)
Cord #2
Printer
(50 Hz)
120/208 380, 400,
VAC; or 415 VAC
120/240 (3 phase)
VAC
(2 phase)
Recep5-15R
tacle
NEMA part
number
14-50R
14-30R
--
Power
0.4
consumption (KVA)
Operating
mode
7.3 +
.75 per
middle
module
stacker
7.3+
.75 per
middle
module
stacker
Consult
your local
service
represent
ative
Notes:
• Dedicated service is required for each component.
Each power cord must have a separate circuit.
• Power requirements of the bypass transport are
Notes:
coverage, 8.5 by 11 inch or A4 paper, and varies
depending on area coverage of the application, as
well as the darkness settings of the printer.
• All the dimensions are taken from the system frame
• Contact your local Xerox representative for supplies
• There should be a minimum of 78 inches / 198 cm
ordering information.
• The printing system must be installed in a fixed
satisfied by the printer module.
to the nearest wall or obstruction, shown in inches
and centimeters, and are absolute minimums.
clearance from the floor to the nearest overhead
obstruction, throughout the entire area.
2004 by Xerox Corporation. All rights reserved.
Version 4.1
September 2004
701P42238
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising