BLINK S2_0420_final

BLINK S2_0420_final
ACTON
BLINK® S2
(In Wheel Motor)
OWNER’S MANUAL
WARNING!
Use of ACTON BLINK® S2 can lead to serious injury or even death due to loss of control,
falls or collisions. Please read and follow all instructions in this Owner’s Manual prior to
using BLINK® S2. Skating and the use of personal transportation devices is dangerous, due
to many unpredictable circumstances that may arise while riding. You can reduce the risk
of serious injury by wearing full protective gear (helmet, wrist guards, elbow pads and
knee pads), keeping your equipment in good condition and utilizing the ACTON BLINK®
S2 on flat surfaces away from obstacles, people and vehicles. Do not use the ACTON
BLINK® S2 in any location prohibited by law, including but not limited to, roadways,
parking lots, stores or malls.
DO NOT RETURN TO STORE! PLEASE CONTACT US DIRECTLY FOR
TECHNICAL SUPPORT BY SENDING AN EMAIL TO:
SUPPORT@ACTONGLOBAL.COM
NOTE: Manual illustrations are for demonstration purposes only. Illustrations may
not reflect exact appearance of actual product. Specifications are subject to
change without notice.
CONTENTS
I. SAFETY WARNINGS
A. General Disclaimer
B. Age, Weight & Health
C. Conditions for safe riding
D. Battery Handling & Disposal
E. Radio Interference precautions
II. PRODUCT INFORMATION
A. Technical Specifications
B. Parts List
III. USING Blink
A. Riding & Beginner Tips
B. Low Battery Charging
IV. CARE & MAINTENANCE
Other maintenance
V. TROUBLESHOOTING
VI. WARRANTY & DISCLAIMER
VII. COPYRIGHT
1
IMPORTANT
Do not use ACTON BLINK® S2 until you read and thoroughly
understand the Owner’s Manual. It contains information that
is critical to your safety.
ACTON is not liable for any damage or injury caused by unsafe usage or faulty repairs. Any repairs made to this product
by unauthorized service technicians are the sole responsibility of the owner.
BLINK® S2 is only for people 16 years of age and older.
Always wear protective gear including knee, elbow, and wrist
guards and an approved safety helmet when riding BLINK® S2.
Only use BLINK® S2 on paved surfaces or on gentle slopes.
Do not use on dirt, sand, steep slopes, or slippery surfaces.
Use caution when going down hill.
2
I. SAFETY WARNINGS AND CAUTIONS
A. General Disclaimer
Riding ACTON BLINK® S2 can be a dangerous activity. Certain conditions may cause the
equipment to fail without fault of the manufacturer. Like other electric transportation
products, ACTON BLINK® S2 is intended to move and accordingly it is possible for the rider
to lose control, fall, collide with other objects, and/or get into dangerous situations that no
amount of care, instruction or expertise can completely eliminate. If such things occur you
can be seriously injured or die, even when using safety equipment and using other
precautions.
RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
This manual contains many warnings and caution concerning the consequences of failing to
maintain, inspect or properly use your ACTON BLINK® S2. Because any incident can result
in serious injury or even death, we repeat the warning of possible serious injury or death.
WEAR HELMET AND PROTECTIVE GEAR AT ALL TIMES.
B. Age, Weight & Health
ACTON BLINK® S2 is designed for adults and for older teens. Riders must be 16 years of age
or older. Keep ACTON BLINK S2 away from small children and young teens.
DO NOT EXCEED THE WEIGHT LIMIT OF 250 LBS.
C. Conditions for safe riding
Always check and obey all local law sand regulations which may affect the locations where
ACTON BLINK® S2 may be used. Ride defensively. Watch out for potential obstacles that
could catch your wheels, force you to swerve suddenly, or lose control. Be careful to avoid
pedestrians, inline skaters, motor vehicles, other skateboarders, scooters, bikes, children or
animals that may enter your path.
Always wear proper protective equipment such as an approved safety helmet (with chin
strap securely buckled), wrist guards, elbow pads, and kneepads. A helmet may be legally
required by local laws or regulations in your area. A long-sleeved shirt and long pants are
recommended. Before riding, be sure to check that all wheels, trucks and the battery case
are secured properly.
It is highly recommended that you not ride in the rain. Riding in the rain may shorten the life
span of the bearings and motor significantly. If rain cannot be avoided, it is advised to keep
riding the board under dry conditions to avoid moisture build up in the motor.Water
damage is not covered in warranty.
The LED lights may not be bright enough to act as an illuminating light. Riding during the
night or in dark areas are not advised.
D. Battery Handling & Disposal
Your ACTON BLINK® S2 may not have a fully charged battery when first received.
Accordingly, you should charge the battery prior to your first use. Battery is best used under
optimal conditions: temperature 50-75F (10-24C), absolute humidity 45-85%.
NO RIDING AT/BELOW FREEZING TEMPERATURE
Never store or use the battery in freezing or below freezing temperatures.
3
Run time up to 90 min;
Recharge time 2-2.5 hour for regular charger
Make sure the power switch is turned off whenever the ACTON BLINK® S2 is not in use or
it will drain the battery. When the battery is drained, it is very susceptible to damage.
When the ACTON BLINK® S2 is not in regular use, recharge the battery at least once a
month until normal use is resumed.
Use only the recommended charger and use caution when charging. The charger should
be regularly examined for possible damage to the cord, plug, enclosure or other parts. The
charger should be operated only by an adult. Do not operate the charger near flammable
materials. Unplug the charger and disconnect from ACTON BLINK® S2 when not in use and
charging is complete.
E. Radio Interference Precautions
ACTON BLINK® S2 incorporates a sophisticated communication system to ensure
connection between the remote controller and the skateboard. The connection could be
unstable or lost when the remote controller’s battery is low. Stop riding when the remote’s
low battery warning appears.(quick flashing lights). Human body could interfere with
remote signal as well. Don't put remote in the pocket while riding.
Try to avoid areas with high-power electromagnetic radiating equipment, such as radio
towers, powerlines or radar. In some rare cases, connection may also be lost due to
unpredictable causes. As a safety precaution, ACTON BLINK® S2 will shut off immediately
when the connection is lost. If a loss of connection happens more than once, stop use
immediately and avoid using ACTON BLINK® S2 again in such areas.
Please contact ACTON for further assistance.
II. PRODUCT INFORMATION
A. Technical Specification
Deck
32.2 inches long, Canadian Maple Wood,Aircraft Grade
Wheels
83mm, 78A hardness
Weight
15 lbs / 6.8kg
Max Speed
18 mph/ 29 kmph
Range
14 miles
Max Incline Rate
20%
Max Rider Weight
250 lbs / 113 kg
Power
Total 1000W
Battery Capacity
36V / 4.4AH
Charging Time
2-2.5 hour
Remote Controller
2.4 Ghz Bluetooth
B. Part List
ACTON BLINK® S2 electrical skateboard
Remote controller
Skateboard Charger
4
III. USING ACTON BLINK® S2
A. Riding & Beginner Tips
The following advice is a quick start quide. The remote is provided to control the
acceleration of the board for for all levels of rider .
There are three modes for ACTON BLINK® S2: BEGINNER, NORMAL and PRO. You may
change the modes from the App. Please download the app “ACTON” to your phone.
Currently we only offer the app for Android 4.3+ and iOS iPhone 5+. For your safety,
please set to BEGINNER or NORMAL mode on the app home page to start with. Only set
to NORMAL mode when you are a comfortable rider. Only set to PRO mode when you are
very familiar with the ACTON BLINK® S2 and have mastered both beginner and normal
modes.
You may also be able to use the App to control the front LED and rear LED, but the side
LED is for safety and cannot be switched off. The energy LED consumption is very minimal
and will not affect the riding range.
F - Forward
GO
R - Backward
STOP
Also, follow these tips:
B. Low Battery Charging
ALWAYS CHARGE THE BATTERY AFTER IT DRAINS.
The battery must get charged immediately after it drains for long term battery
longevity. If the state of charge is allowed to remain below minimum for too long, it
may not be able to be recharged.
5
Red = Charging
Charging the skateboard is indicated by the LED indicator on the charger. The LED
being
will turn from red to green as it finishes char
A fast blinking light on the remote is an indication if the remote is in low battery.
IV. CARE &MAINTENANCE
Other maintenance
Clean the surface of ACTON BLINK® S2 with a damp, but not overly wet, soft cloth
only. Store ACTON BLINK® S2 in an indoor and cool environment. Recharge the
battery at least once per month and avoid contacting with volatile liquids including
Alcohol or strong cleaning agents.
V. TROUBLESHOOTING
If your ACTON BLINK® S2 is not running properly, stop using it immediately. In most
cases, turning the skateboard off for 10 seconds and restarting it will solve the issue. If
you find other problems or restarting the ACTON BLINK® S2 doesn’t resolve the issue,
refer to the following chart for common troubleshooting methods. If the problem still
exists, please stop using the ACTON BLINK® S2 and contact ACTON.
Symptom
Probable Cause
Solution
Won’t turn on
Low Battery
Charge battery for at least 1 hour
Won’t go
Bluetooth not connected
Restart the remote and BLINK S2
Remote lose re-sync
Please refer to resync manual to
resync the remote
Charger not connected
Make sure you are using the correct
charger and it is properly connected
Battery depleted
If battery has not been charged for
MORE than one month, it may REQUIRE
an extra hour before it will recharge
Exceed the weight limit
ACTON BLINK S2 is designed for a
person who weighs up to 250lbs
Battery health dropped
May need to replace the battery pack
Won’t charge
Range too low
6
VI. WARRANTY, DISCLAIMER
Return Policy
14-Day Satisfaction Guaranteed
We want you to be completely satisfied with your purchases. Orders are fully refundable
at any time prior to shipping. If you’re not happy with the product within 14 days, simply
return it back to us for a full refund. *
Items returned for refund must be returned within 14 days from delivery. Under no
circumstances will we issue refunds after 14 days of delivery.
*Customers are responsible for shipping costs for all return claims and are subject to
restocking fee of 15% if the board has been ridden or are not in store bought condition
with packaging in new, sellable form.
Warranty
This warranty is non-transferrable, and applies only to the original purchaser of ACTON
products. Your ACTON product has limited coverage for 6 months from the date of
purchase by the original purchaser from the ACTON online store or authorized resellers
ONLY. A copy of the receipt from the ACTON online store or ACTON authorized reseller
must be provided.
Please submit a ticket through website with a copy of the receipt.
ACTON products that have suffered damage stemming from an accident or impact,
have been exposed to abuse, and that have visible evidence of damage as a direct result
of impact with other objects, or have been exposed to water, negligence (such as, but
not limited to leaving batteries discharged for extended periods of time) will NOT be
covered.
Parts such as bearings, belts, wheels, tires, grip tape, and bushings are considered
consumables and wear under normal conditions. They are not covered by warranty. The
use of any alternate charger will void this warranty. Any unauthorized alterations,
tampering or repairs are not covered by this warranty.
VII. COPYRIGHT
Please visit www.ACTONglobal.com for the most up-to-date copyright information.
ACTON
info@ACTONglobal.com
7
The remote is synced with your BLINK S!
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising