BATTERY CHARGER
Model 1210 and 1210E
PowerLuber Battery Charger
INSTRUCTIONS FOR CHARGER AND BATTERIES
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instruction for Lincoln Model 1210 or 1210E Battery Charger.
1. Before using this battery charger, read all instructions and cautionary
markings on Battery Charger, Battery Pack, and product using battery.
2. CAUTION: To reduce the risk of injury, Lincoln Model 1210 or 1210E
Chargers should only be used to charge Lincoln battery pack Model
1201. Other types of batteries may burst causing personal injury and
damage. Do not charge Lincoln Model 1201 Battery Packs with any
other charger.
3. Do not expose charger to moisture (rain, snow or frost).
4. Do not abuse cord. Never carry charger by cord or yank it to disconnect from receptacle. Pull by plug rather than cord when disconnecting charger. Replace damaged or worn power cord and strain reliever immediately. DO NOT ATTEMPT TO REPAIR POWER CORD.
5. Make sure cord is located so that it will not be stepped on, tripped
over, or otherwise subjected to damage or stress.
6. Do not use an extension cord unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock.
If an extension cord must be used, make sure:
A That the extension cord is properly wired and in good electrical condition.
B Wire Size of cord is at least as specified in following chart:
LENGTH OF CORD IN FEET (M) 25 (7.5) 50 (15) 100 (30) 150 (45)
AWG SIZE OF CORD (mm²)
18 (1)
18 (1)
18 (1)
16 (1.5)
16. Dispose of expended batteries properly. The Lincoln Model 1201
Battery Pack contains rechargeable, nickel-cadmium batteries. These
batteries must be recycled or disposed of properly. Drop off expended battery packs at your local replacement battery retailer, or your
recycling center.
Users in the United States NOTE:
Applicable fees for the collection and recycling of these batteries have
been paid to the RBRCTM. For further information, call 1-800-8BATTERY.
Product Specifications
Input Voltage
Output
Time to Charge
1201 Battery:
Cord Length
Indicator Lights©
Model 1210
120 VAC/60 Hz
@ 350MA ©
14.5 Volts
@ 1.5 Amps©
Model 1210E
230 VAC/50 HZ©
@ 200MA©
14.5 Volts
@ 1.5 Amps©
1 Hour Approx.
6 ft (2 m)
1 Hour Approx.
6 ft (2 m)
Red and Green Light On
When plugging in charger both the red & green light will come on for 2 seconds.
Green Light Flashes
1. Ready to charge but no battery in charger
2. Charger does not recognize the battery because it is to hot to charge.
Once battery cools to an acceptable level charge will begin
C If an extension cord is to be used outdoors it must be marked with the
Red Light On
suffix W-A following the cord type
Battery is being charged
designations. For example -SJTW-A to indicate it is acceptable for
Green Light On
outdoor use.
Battery is fully charged
7. Do not operate charger if it has received a sharp blow, been dropped,
or otherwise damaged in any way, take it to a qualified serviceman.
Red and Green Lights Alternate Flashing
8. Do not disassemble charger or battery pack. Take it to a qualified
When battery voltage is below 9 VDC the battery will be evaluated. This can
serviceman when service or repair is required. Incorrect reassembly
last up to 5 minutes.
may result in risk of electrical shock or fire.
9. Unplug charger from outlet before attempting any maintenance or
Red Light Flashes
cleaning to reduce risk of electric shock.
Replace Battery pack
10. Charge the battery pack in a well ventilated place, do not cover the
charger and battery with a cloth, etc., while charging.
Weight
2.2 lb. (1.01 Kg)
2.2 lb. (1.01 Kg)
11. Do not store the charger or battery packs in locations
(such as a metal tool shed, or a car in the summer) where the temperature may reach or exceed 122° F
(50° C) , which can lead to deterioration of the storage battery.
12. Do not charge battery pack when the temperature is BELOW 32°
F (0° C)or ABOVE 104° F (40° C). This is very important for proper
operation.
13. Do not incinerate battery pack It can explode in a fire.
14. Do not short across the terminals of the battery pack. EXTREMELY
HIGH TEMPERATURES COULD CAUSE PERSONAL INJURY OR
FIRE.
© 15. Charging time will be approximate 1 hour after the initial charge.
Do not leave battery plugged into charger for extended period of
1201
time after charged.
* New batteries are shipped in an uncharged state and the initial charge
will require 12 hours before use.
Americas:
One Lincoln Way
St. Louis, MO 63120-1578
USA
Phone +1.314.679.4200
Fax +1.800.424.5359
Form 402027
Europe/Africa:
Heinrich-Hertz-Str 2-8
D-69183 Walldorf
Germany
Phone +49.6227.33.0
Fax +49.6227.33.259
1210 or 1210E
Battery Charger
© Indicates change
Asia/Pacific:
51 Changi Business Park
Central 2
#09-06 The Signature
Singapore 486066
Phone +65.6588.0188
Fax +65.6588.3438
© Copyright 2005
Printed in USA
Web site:
www.lincolnindustrial.com
Battery
Model 1210 and 1210E
PowerLuber Battery Charger
Declaration of conformity according to EMV directive 89/336/EEG as last amended by EC Directive 93/68/EEC Electromagnetic Compatibility.©
We declare that the model of the
Battery Charger
in the version supplied by us, complies with the provisions of the above mentioned directive.
Applied harmonized standards in particular:
EN61000-3-3
Electromagnetic Compatibility (EMC) - Part 3: Limits - Section 3: Limitations of Voltage Fluctuations and Flicker in Low
Voltage Supply Systems for Equipment with Rated Current = 16A - SAME AS IEC 61000-3-3
EN 55014-2
Electromagnetic Compatibility - Requirements for Household Appliances, Electric Tools, & Similar Apparatus Part 2: Immunity - Product Family Standard
EN55014-1
Electromagnetic Compatibility - Requirements for Household Appliances, Electric Tools and Similar Apparatus Part 1: Emission - Product Family Standard
EN 61000-3-2 + Amendment 1, + Amendment 2, + Amendment 14
Electromagnetic Compatibility (EMC) Part 3:
Input
Limits - Section 2: Limits for Harmonic Current Emissions (Equipment
St. Louis, MO 01/07/04, Paul Conley, Chief Engineer
Lincoln Industrial Standard Warranty
LIMITED WARRANTY
Lincoln warrants the equipment manufactured and supplied by Lincoln to be free from defects in material and workmanship for a
period of one (1) year following the date of purchase, excluding there from any special, extended, or limited warranty published
by Lincoln. If equipment is determined to be defective during this warranty period, it will be repaired or replaced, within Lincoln’s
sole discretion, without charge.
This warranty is conditioned upon the determination of a Lincoln authorized representative that the equipment is defective. To
obtain repair or replacement, you must ship the equipment, transportation charges prepaid, with proof of purchase to a Lincoln
Authorized Warranty and Service Center within the warranty period.
This warranty is extended to the original retail purchaser only. This warranty does not apply to equipment damaged from accident, overload, abuse, misuse, negligence, faulty installation or abrasive or corrosive material, equipment that has been altered,
or equipment repaired by anyone not authorized by Lincoln. This warranty applies only to equipment installed, operated and
maintained in strict accordance with the written specifications and recommendations provided by Lincoln or its authorized field
personnel.
THIS WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING,
BUT NOT LIMITED TO, THE WARRANTY OF MERCHANTIBILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.
In no event shall Lincoln be liable for incidental or consequential damages. Lincoln’s liability for any claim for loss or damages
arising out of the sale, resale or use of any Lincoln equipment shall in no event exceed the purchase price. Some jurisdictions
do not allow the exclusion or limitation of incidental or consequential damages, therefore the above limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights. You may also have other rights that vary by jurisdiction.
Customers not located in the Western Hemisphere or East Asia: Please contact Lincoln GmbH & Co. KG, Walldorf, Germany,
for your warranty rights.
Lincoln Industrial Contact Information
To find Lincoln Industrial’s Nearest Service Center call the following numbers, or you may also use our website
Customer Service 314-679-4200
Form 402027
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising