Travel Charger manual

Travel Charger manual
owner’s manual
Mesa Travel Charger
The Mesa Travel Charger is an optional
accessory that allows you to charge Mesa battery
packs on the go. One or two battery packs can be
charged at once.
How to Use the Travel Charger
1. Battery pack(s) should be charged at room
temperature (68° F or 20° C) 2. Place the travel charger on a flat surface
where it will be undisturbed.
3. The following accessories can be used to
provide power to the travel charger:
Mesa Travel Charger User’s Manual
a. AC wall power charger provided with the Mesa
b. Vehicle charger cable provided with the travel charger
Plug a power adapter into the power input
jack on the back of the travel charger. Plug
the other end into a wall outlet or a vehicle
outlet.
4. Insert one or two battery packs into the
charging slots. Make sure you insert them
fully. You will feel a slight catch.
Charge Time
Two depleted batteries (in the charger at same
time): approximately 3.5 hours to fully charge.
One depleted battery: approximately 2.6 hours to
fully charge.
Mesa Travel Charger User’s Manual LED Indicators
Each battery compartment has a green and red
LED. The LED states indicate the following:
LED State
Indicates
Red LED On
Battery pack charging
Green LED
On
Battery pack fully charged
Red Flashing
LED
Battery pack or charging fault
Battery Pack or Charging Faults and Remedies
Possible causes for a flashing red LED:


Over-discharged battery: The battery pack
is severely depleted. The red LED flashes a
few seconds after the battery is inserted. If
the red LED continues to flash for a couple of
minutes, remove the battery pack. It might be
faulty, requiring replacement.
Pre-charge time out: A low battery pack is
inserted and the voltage does not reach an
Mesa Travel Charger User’s Manual
acceptable charge level. The red LED flashes
30 minutes into the charge. The battery
pack might be at the end of its life or faulty,
requiring replacement. Note: Do not confuse
this with the out-of-temperature fault (below).


Out-of-temperature range for safe charging:
The charger senses the battery pack is too
cold (< 0˚ C, 32˚ F) or too hot (> 40˚ C, 104˚ F)
for safe charging. This can occur at any time
in the charge cycle. The red LED continues to
flash, even after the battery pack is removed.
Reset the charger by inserting a battery pack
with an acceptable temperature or remove
and reapply the external power to the charger.
Bring the temperature of the battery pack
into the safe charging range. If the problem
persists, the battery pack might be faulty,
requiring replacement.
Charge cycle time out: The battery pack does
not reach full charge within eight hours. The
battery pack might be at the end of its life or
faulty, requiring replacement.
Mesa Travel Charger User’s Manual !
Battery Warnings
WARNING! These warnings are for lithium ion
rechargeable batteries.
To reduce the risk of fire or burns, do not
disassemble, crush, puncture, short external
contacts, or expose to fire.
Do not disassemble or open, crush, bend or
deform, puncture or shred.
Do not modify or remanufacture, attempt to
insert foreign objects into the battery, immerse or
expose to water or other liquids, expose to fire,
explosion or other hazard.
Only use the battery for the system for which it
is specified
Only use the battery with a charging system
that has been qualified with the system per
this standard. Use of an unqualified battery or
charger may present a risk of fire, explosion,
leakage, or other hazard.
Do not short circuit a battery or allow metallic
conductive objects to contact battery terminals.
Mesa Travel Charger User’s Manual
Replace the battery only with another battery
that has been qualified with the system.
Use of an unqualified battery may present a risk
of fire, explosion, leakage or other hazard.
Promptly dispose of used batteries in accordance
with local regulations
Battery usage by children should be supervised.
Avoid dropping the battery. If the battery is
dropped, especially on a hard surface, and the
user suspects damage, take it to a service center
for inspection.
Improper battery use may result in a fire,
explosion or other hazard.
!
Wall Charger Warnings
WARNING! To reduce the risk of personal injury,
electrical shock, fire or damage to the equipment:
Plug the wall charger into an electrical outlet
that is easily accessible at all times.
Disconnect power from the equipment by
unplugging the wall charger from the electrical
Mesa Travel Charger User’s Manual outlet or unplugging the synchronization cable
from the host computer.
Do not place anything on the wall charger cord
or any of the other cables. Arrange them so that
no one may accidentally step on or trip over
them.
Do not pull on a cord or cable. When unplugging
the wall charger from the electrical outlet, pull
on the plug, not the cord.
Use only wall chargers intended for the Mesa.
Using any other external power source can
damage your product and void your warranty.
Regulatory Information
United States (FCC)
This device complies with Part 15 of the FCC
Rules. Operation of this equipment is subject to
the following two conditions:
1. The device may not cause harmful
interference.
Mesa Travel Charger User’s Manual
2. This device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is used in a commercial or residential
environment. This equipment generates, uses,
and can radiate radio frequency energy and,
if not used in accordance with the Owner’s
Manual, may cause harmful interference to
radio communication. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Mesa Travel Charger User’s Manual Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
!
CAUTION: Only approved accessories may
be used with this equipment. In general, all
cables must be high quality, shielded, correctly
terminated, and normally restricted to two
meters in length. Wall chargers approved for
this product employ special provisions to avoid
radio interference and should not be altered or
substituted.
!
CAUTION: Changes or modifications to the
Mesa that are not expressly approved by the
manufacturer could void the user’s authority to
operate the equipment.
Industry Canada
This Class B digital apparatus complies with
Canadian ICES-003. Cet appareil numérique de
la classe B est conforme à la norme NMB-003 du
Canada.
10 Mesa Travel Charger User’s Manual
This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
CE Marking
Products bearing the CE marking
comply with the 2004/108/EC (EMC
Directive) issued by the Commission of
the European Community.
CE compliance of this device is valid only if
powered with/by a CE-marked wall charger
provided by the manufacturer. Compliance
with these directives implies conformity to the
following standards:
EN 61000-6-3:2007 Generic standards —
Emission standard for residential, commercial
and light-industrial environments.
Mesa Travel Charger User’s Manual 11
P/N 22514-01
Copyright 12-2010 Juniper Systems, Inc.
12 Mesa Travel Charger User’s Manual
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising