USING THE MULTI-BATTERY CHARGER Charge Function LYNX MULTI-BATTERY CHARGER Correctly insert the battery pack into the slot: simply press it into the slot until the battery latch is automatically closed; charging starts automatically. The Multi-Battery Charger, with its 4 slots, allows you to charge simultaneously 4 Lynx battery packs. Both standard capacity battery (94ACC0064) and high capacity battery (94ACC0065) can be recharged with this accessory. Figure 3 Power on LED Battery Charging State LEDs To remove the battery, release the latch on the battery pack as showed in figure 4: Figure 4 TECHNICAL FEATURES Figure 1 ELECTRICAL Power supply* Max consumption CHARGING TIME Std Battery High Cap Battery PHYSICAL Dimensions (LxWxH) POWER SUPPLY Plug the power supply, already in the box, into the connector, then plug the power supply into a socket. Use a country specific power cord. Weight (without batteries) LEDs ENVIRONMENTAL Working temperature** Storage temperature Humidity Electrostatic discharge EN 61000-4-2 Figure 2 LED INDICATORS Battery Charging Status LED Description LED Power Status Green Charger off Red Green Red blinking It is constant when the battery charger is powered Empty slot Charging Charge completed Error 822001300 12V DC 5A 2h 30 4h 210 x 149 x 48 mm (8.3 x 5.9 x 1.9 in) 418 g (14.7 oz) 4 Charger Status LEDs 1 Power on LED 0° to +50 °C (+32° to +122 °F) -20° to +70 °C (-4° to +158 °F) 95% without condensation 4 KV contact / 8 KV air * Use only DL approved power adapters ** When inserted in the spare slot, batteries must be charged at a temperature ranging from 0° to 44 °C. At higher values the charging may slow down. Never charge the main device or spare batteries in a closed space where excessive heat can build up. FCC COMPLIANCE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Modifications or changes to this equipment without the expressed written approval of Datalogic could void the authority to use the equipment. This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference which may cause undesired operation.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project