MEdia firEplacE

MEdia firEplacE
MEdia fireplace
Model No. EF-642-KIT
with EF-123-11
assembly instructions
READ & SAVE THESE INSTRUCTIONS
Carefully read and review before assembling, installing,
operating or maintaining this product. Observe all safety
instructions and information.
FAILURE TO FOLLOW WARNINGS & OPERATIONAL
INSTRUCTIONS CONTAINED IN THIS MANUAL CAN RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY.
For customer service, parts
or warranty issues:
Call 1-800-561-5550
or e-mail parts@jrhome.com
Always plug heaters directly into a wall outlet/receptacle.
Never use with an extension cord or relocatable power tap
(outlet/power strip)
Fireplace Insert Specifications
Dimensions W x D x H : Net Weight Gross Weight Voltage 27”x9”x24”
37.4 lbs / 17 kg
40.7 lbs / 18.5 kg
110 – 120 V
Frequency Watts Heater Rating 60 Hz
1500 W
5118 BTUs
Grounding Instructions
the cord has a plug as shown in (a) of Figure 1 given below.
Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip)
t
Figure 1
Mantel assembly
MODEL
EF-642-KIT
PART #
PART NAME
A
B
C
D
E
F
G
H
I
J
K
L
M
BASE
LEFT SIDE PANEL
RIGHT SIDE PANEL
LEFT SIDE FRONT PANEL
RIGHT SIDE FRONT PANEL
FRONT BASE SUPPORT
UPPPER FACING
CENTRAL SHELF
CENTRAL DIVIDER
TOP BACK PANEL
TOP
BASE SHELF
BACK BASE SUPPORT
QTY
1
1
1
1
1
1
1
1
1
1
1
1
1
x 27
ASSEMBLY
Tools Required for Assembly (not included): Phillips screwdriver
STEP 1
STEP 2
STEP 3
Back View
STEP 4
Back View
STEP 5
STEP 6
STEP 7
STEP 8
Back View
STEP 9
Push the insert from the front
STEP 10
Positioning the unit against the wall
Wall
Outlet
Ground
Fully Assembled
STEP 11
Anti tipping device
Locating fireplace
rePlacinG tHe liGHt bulbs
replace insert uses 2 clear 120 Volt, 40 Watt, e-12 socket base light bulbs (small base, chandelier candle type
bulbs). the lights are located at the bottom of the unit. For convenience, if one of the light bulbs burns out, it may be
easier to replace all 2 of the light bulbs at the same time.
WarninG: Do not exceed 40 Watts per bulb. use of higher rated bulbs may r
damage, personal injury or loss of life.
re, causing property
1. turn o the power to the unit.
2.
replace insert cool if it has been operating.
3. Gently pull the mantel away fr
r
rebox to the
mantel. you do not need to remove the trims fr
rebox. t
rebox by the side handles and slide it out
of the mantel. be careful not to scratch the mantel base.
4.
replace insert free of the mantel, lie the unit on its back with the bottom facing you. you will
see 3 small plates with gold printing indicating the bulbs are behind these plates.
5. remove the 2 screws in each plate with an appropriate screwdriver. once you have removed the 2 screws in each
plate, slightly lift each plate until you can pull back and release the tabs on each plate. once you have removed
the plates you can see and access the 3 - 40 Watt bulbs.
6. remove each light bulb by unscrewing them out of the bases, turning them counterclockwise. you can use one
hand to hold the light socket in place, if required.
7. install the new light bulbs by turning each light bulb into the base clockwise. you can use one hand to hold the light
socket in place, if required.
8. replace each cover plate by inserting the tabs and lowering the plate.
9. replace the 2 screws in each plate that were removed in step 5, by using an appropriate screwdriver.
10.
replace insert up on its bottom.
11.
replace insert back on to the mantel hearth.
12.
replace insert back into position against the fr
replace insert
replace insert has rubber feet on the bottom to protect against
damage as long as it is level.
13.
rebox back in. Gently slide the mantel back up
against the wall. tur
replace and enjoy.
oPeratin G i nstructions
replace insert control functions can be accessed in 2 ways:
1. using a remote control
2. using the manual contr
replace insert.
replace insert features conveniently separate contr
this feature allows you to operate the unit in 2 di erent ways:
as a full featured
insert with both the
as a visual e ect with the
e ect only.
ect and for heat control.
e ect and heater on.
refer to the pictures for location of the buttons on both the remote contr
replace insert itself.
Operating Instructions
Low heat: 800 watts
High heat:1500 watts
REMOTE CONTROLS
1 . Heater Timer: Allows you to leave your heater
on with an automatic timer for shut
off. You can set your heater to be on for 1/2 hour
increments starting at a 1/2 hour up to a maximum
of 7-1/2 hours – press once for each 1/2 hour
increment. After you reach 7-1/2 hours the next
press will shut off the feature.
2 . Flame brightness controls: Allows you to
3. Power ON/OFF: Power to the unit
4. Heater Control: Press once for low heat, and
twice for high heat.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
1. No power, no indicator lights
Insert was not plugged in
Make sure that power cord is
plugged into 120 V outlet
2. No power, no indicator lights
No power at outlet
Check circuit breaker or fuse
3. Power indicator lights come on,
logs will not glow and no flame Broken or burned out light bulbs
effect
4. Logs glow, but no flame
5. Flame and logs glow, but no
heat
6. Heater and/or flame turn off
while operating
Flame spinner disconnected
Heater switch is off
Follow instructions for replacing
light bulbs
Call customer service for
instructions
Push heater button. Indicator light
will come on
Timer function may have been on Push On/Off button to reset
iMpOrTaNT
For questions, concerns or problems with our product please
email our customer service department:
parts@jrhome.com or call 1-800-561-5550.
DateD ProoF oF PurcHase reQuireD For Warranty serVice.
Warranty
this product is inspected, tested and carefully packaged to minimize the chance of
damage during shipment. if a part (excluding light bulbs and fuses*) within one year from
the date of purchase proves to be defective in material or fabrication under normal
use, the part will be repaired or replaced. the company’s obligation under the warranty
is to replace or repair defective parts at our discretion. any expenses or damage resulting
from the installation, removal or transportation of the product will be the responsibility
of the owner and are not covered by this warranty. the owner assumes all other risks
arising from the use or misuse of the product. the warranty will be void if the product
damage or failure is deemed by the company to be caused by accident,
alteration, misuse, abuse, incorrect installation or removal, or connection to an incorrect
power source by the owner. the company neither assumes, nor authorizes any person or
entity to assume for it any obligation or liability associated with its products.
light bulbs and fuses are not covered under this warranty. if you have any questions
regarding the warranty or service, please call our toll free number: 1-800-561-5550.
customer service
Jr Home Products
unit 1 - 5628 riverbend Drive, burnaby bc, V3n 0c1
toll Free: 1-800-561-5550
e-mail: parts@jrhome.com
you must register your p roduct to receive warranty se rvice.
registration can be completed online at www.jrhome.com or by mailing this form .
Warranty Registration Information Form / Formulaire d’enregistrement de la garantie
Name / Nom:
Street / Adress:
City / Ville:
Province / Province:
Postal Code / Code postal:
Daytime Phone # / No téléphone jour:
Evening Phone # / No téléphone soir:
E-Mail Address / Courriel:
Product/Produit:
Place of Purchase / Lieu de l’achat:
Date of Purchase / Date de l’achat:
Model # / No de modèle:
Serial # / Numéro de série:
You MUST r egister y our p roduct to r eceive
warranty service.
For w arranty service, contact J &R H ome
Products at the address, phone numbers listed
below within 30 days of purchase. Be sure t o
have your s ales r eceipt and o riginal date of
purchase. A ll w arranty service will be
coordinated by
J&R Home Products service center.
Vous DEVEZ enregistrer votre produit pour vous
prévaloir de la garantie.
Afin d e faire v aloir la g arantie, communiquez
avec J &R H ome Products à l’adresse e t aux
numéros indiqués ci-dessous dans les 30 jours
suivant la date d’achat. Ayez en main votre reçu
et la date d’achat. Toutes les demandes liées
aux g aranties seront t raitées p ar l e centre de
service de J&R Home Products.
Please mail to / Veuillez poster le tout à : Parts & Service Department, J&R Home Products Ltd. Unit 1 - 5628 Riverbend Drive, Burnaby BC, V3N 0C1 1.800.561.5550
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising