Set up and configuration for TS (Remote desktop) from IPhone and IPAD Prerequisite: Server internal IP address e.g. 192.168.1.200 (if plan to connect within LAN). External IP address or name of DDNS (if plan to connect outside). Port number, default is 3389. Username and password. Live Connection to the Internet (Wi-Fi or 3G). Set up and configuration: For IOS 4.3.3 or above (IPAD, IPAD2, IPHONE 3, 4/S) Go to App store At the search box, type “rdp”. “Wyse PocketCloud” and “2X client” are recommended free apps. Tap “INSTALL” to install either one or both. Icons will be on home screen after the installation. 2X Client RDP Tap on 2X Client RDP icon to start. To add a new connection, tap Tap on RDP Connection At Alias type server name At Address type External IP address or DDNS (if plan to connect from outside), type Internal IP, (if plan to connect within office) Leave the port number as default At Username and Password type in your username and password Other settings leave as default Then tap Save To change connection setting, such as name, IP address, username or password, tap on the save any changes. To add a new connection tap To delete this connection, tap on “Edit” arrow, then Then tap -> To connect to server, Tap on “server” After log on to the sever, a tool bar will be located at the bottom. Tap on to bring out the mouse mode This mouse can simulate left and right mouse button and as well as an on-screen keyboard Tap on to bring out the on-screen keyboard A. Tap on the screen or use multi-touch gesture to zoom or move the screen B. To drag the mouse C. Simulate right mouse click D. Activates the keyboard E. To show/hide mouse and keyboard icon Wyse PocketCloud: On the home screen, tap on PocketCloud icon to start. Tap on “Advanced users” Tap to add a new connection type, and then tap on “Manual Connection” Choose RDP, Tap “Nickname” and type server name, and then tap save Tap “Host” and type External IP address or DDNS (if plan to connect from outside), type Internal IP, (if plan to connect within office), then tap save Tap “Username” and “password”, type in your username and password Then leave other settings as default, then tap “Save” to go back to the connection page Tap “Connection Settings” if any changes to need to be made for the “server” connection Tap “Connect” to connect to the server After connection has been made, a tool bar will be shown at the bottom. These icons which circled by red circle are most commonly used. This show each icon represent specific function. Tap the same time. to call out the Touch Pointer activation or tap once on the screen with 2 fingers at the To activate keyboard, Tap on Keyboard icon. Tab on to show combo keyboard Tap on to show direction key Tap on to show function key Limitation on Free App Only one connection can be added. PocketCloud Companion can not be installed on IOS.