Spraymec 9150 WPC
Normet Oy
Ahmolantie 6
FI-74510 IISALMI, FINLAND
Tel +358 (0) 17 83 241
Fax +358 (0) 17 823 606
info@normet.fi www.normet.fi
Spraymec 9150 WPC
Concrete sprayer with workstand
TI100020296
DATE03.07.2012
PAGE 1 / 6
Spraymec 9150 WPC
Normet Oy
Ahmolantie 6
FI-74510 IISALMI, FINLAND
Tel +358 (0) 17Normet
83 241 Corporation
Ahmolantie
6
Fax +358 (0) 17
823 606
info@normet.fiFI-74510
www.normet.fi
IISALMI, FINLAND
Tel +358 (0) 17 83 241
Fax +358 (0) 17 823 606
TI100020296
DATE03.07.2012
Spraymec 9150 WP PAGE TI2 / 6 1700111
DRW
Concrete sprayer with workstand
DATE
09.12.2002
PAGE 2 / 4
Concrete sprayer with workstand
APPR. 07.06.2007
4m
5,5 m
4m
A=60 m2
60o
15 m
16 m
A=270 m2
7m
30o
12 m
14 m
A=348 m2
12 m
Normet Oy
Ahmolantie 6
FI-74510 IISALMI, FINLAND
Tel +358 (0) 17 83 241
Fax +358 (0) 17 823 606
info@normet.fi www.normet.fi
Spraymec 9150 WPC
TI100020296
DATE03.07.2012
PAGE 3 / 6
Concrete sprayer with workstand
SPRAYMEC 9150 WPC
is a self propelled centre articulated unit for power spraying of concrete in
large profile caverns and tunnels.
1. SPRAYPUMP
is a low-wear and low-maintenance double piston pump with the output
of 4-30 m3/hour. Pumping cylinders with a diameter of 180 and the large
suction openings ensure good suctioning, high pumping pressure enable
the conveying of stiff concrete consistencies, with a low water/cement
ratio max. aggregate size of 16 mm (also crushed) and all types of fibres
in the mix.
DIMENSIONS
Length
Width
Height
Wheel base
Ground clearance
Outer turning radius
Inner turning radius
oper.
Weight, max. total
12600 mm
2350 mm
2900 mm
3350 mm
320 mm
7850 mm
3450 mm
3050 mm
22200 kg
SPRAYPUMP
Cylinder diameter
Cylinder stroke
Pumping pressure
Pumping capacity
180 mm
630 mm
56 bar
4 - 30 m3/h
2. ACCELERATOR DOZING SYSTEM NORDOZER 900 H
is designed using wear and corrosion resistant components compatible
with all types of liquid accelerators. The accelerator flow is adjustable by
manual control, using digital flow meter, from 60 to 900 litres/h
.
3. ELECTRO-HYDRAULIC POWER PACK PPE 550
consist of pumps, oil receiver and filters operates the concrete pump and
booms. Boom hydraulics can also be operated diesel-hydraulically.
1000 l space for container
Dosing rate
60 - 900 l/h
4. NORMET SUPERBOOM NSB 900
is the heavy duty multipurpose boom for spraying of concrete, charging,
scaling and lifting. With the Sprayboom the maximum width of 16 m and roof
heights of up to 15 m can be covered. The boom controls are located on the
Spraystand and at the driver`s seat. All boom operations are proportionally
controlled in order to ensure smooth and precise movements.
Baskets can be equipped with FOPS tested safety canopy
(EN ISO 3449).
Boom lift
Boom slew
Boom extension
5. SPRAYSTAND
enables the operator to work near the nozzle and observe consistently the
working area. It can slew 340 degrees and it is equipped with an automatic
horizontal levelling system. The platform has load capacity of 500 kg. It
can be also used to control the quality and properties (eg. thickness) of
the sprayed layer.
Slew angle
340o
Lifting height
8,90 m
Lifting capacity
500 kg
Automatic horizontal levelling
6. SPRAYBOOM SB 320
is fitted on the Spraystand. It has the following automatic movements:
nozzle rotation and telescopic stroke. These automatic functions help
the operator to concentrate on the quality of the spraying process and on
minimizing the rebound.
Boom lift
- 30o ... + 60o
Telescopic stroke
2200 mm
Lateral coverage
16 m
Vertical reach
15 m
Nozzle rotation
450o
Nozzle tilting
105o
Automatic functions:
nozzle rotation, telescopic stroke
7. SCREW COMPRESSOR
FAD Electric motor
8. CABLE REEL KKH70
for power supply of the electrically operated functions, including
100 m of cable (400V, 50 HZ system).
9. SUPPORT LEGS
1 pair in front and 1 pair at rear are hydraulically operated, front pair with
lateral extensions.
PPE550
55 kW/400 V
53o
+/- 20o
2400 mm
10 m3 min at 7,0 bar
55 kW/400 V
Power cable
diam. 3 x 70 mm2 + ground, L = 100 m
Normet Oy
Ahmolantie 6
FI-74510 IISALMI, FINLAND
Tel +358 (0) 17 83 241
Fax +358 (0) 17 823 606
info@normet.fi www.normet.fi
Spraymec 9150 WPC
TI100020296
DATE03.07.2012
PAGE 4 / 6
Concrete sprayer with workstand
10. WORKING LIGHTS
On Spraystand
On carrier
2 x 70 W
2 x 500 W
2 x 70 W
2 x 500 W
11. SAFETY CANOPY
over the drivers seat fulfills the European safety regulations. Driver´s cabin
is FOPS/ROPS tested.
12. REAR BUMPER
is designed to eliminate risk of damaging the pump by the concrete supply
vehicle.
13. CARRIER NC 98
is specially designed for underground use. Diesel engine with hydro-dynamic
transmission and 4-wheel drive gives max. speed of 25 km/h. Fully enclosed
multidisc 2-circuit brakes and parking and emergency brake make operating
reliable and safe in the harsh underground conditions.
Diesel engine Driving speed
96 kW
max. 25 km/h
Normet Oy
Ahmolantie 6
FI-74510 IISALMI, FINLAND
Tel +358 (0) 17 83 241
Fax +358 (0) 17 823 606
info@normet.fi www.normet.fi
Spraymec 9150 WPC
TI100020296
DATE03.07.2012
PAGE 5 / 6
Concrete sprayer with workstand
OPTIONAL EQUIPMENT:
LTC services:
690V/50 Hz electrics
1000V/50 Hz electrics
Enclosed cabin for NC98 (ROPS/FOPS)
Particle filter for Deutz TCD 2012 L04 96 kW
LED driving lights (4 + 2 pcs)
LED working lights on cabin (2 + 2 pcs)
Upgrade Nordozer 900 EH with extra display in
operators spraying platform
Upgrade 12 cum compressor
Hydraulic driven water hose reel
SPARE PARTS
Spare parts package A: Available for 1000 h of use*.
Include periodical service, most common wearing parts
and most critical safety parts.
Spare parts package B: Available for 3000 h of use*.
Include periodical service, most common wearing parts
and most critical safety parts.
* Recommendations are based on average
hours - can vary a lot depending on work site
conditions.
TRAINING SERVICES
Available before delivery, at start up and after
delivery
Product training:
Operation and Maintenance
NorSmart
Foundation of electrics, hydraulics
and mechanics
Audit
Process training:
Concrete spraying
Charging
Process audit
AUDIT SERVICES
To improve performance of the machines
To improve the performance of your processes
To help improve the quality of maintenance operations
SERVICE CONTRACTS
Spare parts supply programmes
Scheduled inspection programmes
Supervision programmes
Periodic maintenance programmes
Machine usage programmes
LINK ONE
Link One electronic spare part manuals
WARRANTY SERVICES
Extended warranty
ADDITIONAL EQUIPMENT:
Hydraulic driven high pressure washer 180 bar / 30 L
Electric driven (400V) high pressure washer
CD/Radio system
Cabin heating
Air conditioning
Fogmaker extinguishing system (manual)
Fogmaker extinguishing system (automatic)
Ansul extinguishing system (manual)
Ansul extinguishing system (automatic)
Tempus manually actuated (Non CE)
Lubrication system for carrier, boom and pump
(Lincoln)
1 extra hand held fire extinguisher (12 kg)
1 extra rotating beacon amber
1 extra rotating beacon red
1 extra rotating beacon blue
1 extra strobe light white
Toolbox and maintenance tools
2 pcs wheel chocks with brackets
Spare wheel
Admixture container (plastic) 1000 L
Form oil system
Text labels in: Fin / Por / GB / Swe / Rus / Nor / Ger / Fra /Spa / Ita
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising