H20 Heavy Duty Laminator Dual Hot Roll

H20 Heavy Duty Laminator Dual Hot Roll
H20 Heavy Duty Laminator
Dual Hot Roll
Features and Benefits
Variable speed. The laminator operates at any speed up to
10 feet / 3 meters per minute. Thicker hot films are
generally applied better at mid-range to lower speeds, while
1.5 mil hot films should be applied at mid-range to higher
speeds.
Attached safety shield. The polycarbonate shield is clear
so operators can see their work. It does not conduct heat
so they’ll be protected from hot areas. It is fixed to the
laminator and the machine will not run if the feed tray and
safety shield are not in place.
Lamination pressure. The rubber rollers are spring-loaded
and preset to ensure correct and even lamination pressure.
The pressure is easy to adjust if required when performing
routine maintenance.
Ease of cleaning. The heated silicone rubber laminating
rollers, and the silicone rubber pull rollers of the laminator
should be cleaned regularly. The safety shield (see below)
on the laminator swings away in seconds, making it easy to
clean the laminating rollers.
Precision Heat Controls. Individual top and bottom heat
controls, as used on our other Digital Laminators, allow for
even, consistent heating of the laminating rollers
throughout the entire temperature range.
Supply roll tension controls. Supply roll tension is easy
to adjust by simply tightening or loosening the tension
control knobs on the supply roll mandrels.
Feed tray pressure strip. This strip on the front of the
feed tray holds images flat as they go into the laminator,
making it easier to handle the lightweight papers
sometimes used in digital imaging.
Ease of maintenance. The H20 laminator is made to last.
However, some items on a laminator do wear out. Even the
high-quality silicone rubber used in the rollers will lose
flexibility over time. Extensive use may wear out the
rollers, or an operator may cut a roller by accident. Rollers
and other key parts can be changed quickly without
disassembling the frame.
Standard Features
Slitter Assembly
Stand
Precision Feed Table
Casters
Options
1" supply roll mandrels
Additional slitter heads
H20 Heavy Duty Laminator
Dual Hot Roll
Specifications
Type of heating
Hot roll
Max lamination width
20"
Speed
0-10 FPM
Standard laminating roller diameter
2.75"
Supply roll core diameter
3"
Recommended film thickness
up to 10 mil
Max laminating thickness
1/2"
Max supply roll outside diameter
14"
Dimensions (including stand)
52"Lx39"Hx32.5"D
Shipping dimensions
56"Lx49"Hx43"D
Weight
250 lbs
Shipping weight
450 lbs
Voltage
208-240V
Amps
10 amps
Cycles
50/60 Hz
# of phases
Single
Motor
1/4 HP DC - variable speed
Electric Supply Plug
NEMA L6-20P
Heater
1500 watts
LEDCO, Inc.
4265 North Main Street
Hemlock, NY 14466
Phone: 800.345.5300
Email: info@ledcoinc.com
www.ledcoinc.com
Graphic Laminating, LLC.
6185 Cochran Road
Solon, OH 44139
Phone: 800.345.5300
Email: info@graphiclaminating.com
www.graphiclaminating.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising